LAISHA
Open Laisha

Is every plant getting its share? The 1-minute drip cup test

Short · · 44 s

Hold a cup under an emitter for 1 minute at normal pressure: mL × 60 = mL per hour. Check the start, middle and end of several lines; within about 10% of each other is good. The full video covers drip design, run time and maintenance.

Irrigation efficiencies: conveyance, application, storage →

Subscribe on YouTube

Why uniformity matters

A drip system is designed so that every emitter delivers nearly the same flow. If emitters at the far end of a lateral give much less water than those at the start, the farmer faces a choice: run the system long enough for the driest plants, and overwater the rest, wasting water and fertiliser and leaching nutrients, or run it for the average and leave part of the field short of water. Either way, yield and water productivity fall. Uniformity is the first thing to check when a drip-irrigated crop looks uneven.

The catch test in detail

Run the system at its normal operating pressure until it is fully pressurised. Choose at least three laterals (near the inlet, the middle and the far end of the block) and, on each, an emitter near the start, the middle and the end of the line. Hold a cup or container under each emitter for exactly one minute (or longer, for low-flow emitters), and measure the volume with a measuring cylinder or syringe.

Flow per hour = millilitres collected in one minute × 60 ÷ 1,000, in litres per hour. A 2 L/h emitter should give about 33 mL in one minute.

Reading the result

Compare the lowest readings with the average. A simple field version of distribution uniformity is: average of the lowest quarter of readings ÷ average of all readings × 100. Above about 90 per cent is excellent, 80 to 90 per cent is acceptable, and below about 80 per cent needs attention. Another rule of thumb is that emitter flows should be within about 10 per cent of each other. With pressure-compensating emitters, a large spread usually means clogging or damage rather than pressure differences.

Common causes and fixes

Low flow at the far ends: pressure too low at the inlet, laterals longer than the design allows, or leaks along the line. Check the pressure gauge at the head and at the end of a lateral, repair leaks and kinks, and confirm the lateral length suits the pipe diameter and emitter flow.

Random low emitters: clogging by sediment, algae, bacterial slime or chemical precipitates such as calcium carbonate and iron. Clean the filter regularly, flush the laterals by opening the end caps until clear water runs, and, where water quality is poor, use acid or chlorine treatments as recommended for the system.

High flow from a few emitters: cracked or damaged drippers or punched holes from tools, rodents or insects. Replace them.

Once the system is uniform, calculate the run time from crop water need, emitter flow and spacing, and repeat the cup test at the start of each season.

Sources: FAO Irrigation and Drainage Paper 36, Localized Irrigation (Vermeiren L, Jobling GA, 1980) · Merriam JL, Keller J, Farm Irrigation System Evaluation: A Guide for Management (1978) · ASABE EP458, Field evaluation of microirrigation water application uniformity

Transcript

Is every plant on your drip line getting the same water?

Here is a one-minute test.

With the system running at normal pressure, hold a cup under an emitter for exactly one minute. Measure the water in millilitres, and multiply by sixty. That is the flow per hour.

Do it at the start, middle and end of a few lines.

If the numbers are within about ten percent of each other, your system is fine.

If the far ends are low, check the pressure, look for leaks and kinks, and clean the filter and flush the lines.

The full drip guide, with the run-time formula, is in our long video, and at laisha.ai.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Go further with Laisha Smarter

US$10 a month · one price worldwide · cancel any time

  • Ask Laisha about what you watched — up to 1,000 questions a month
  • Your own crop calendar and pest alerts
  • Every calculator and tool
10 days free for every new account, no card.