Saline soil (too much soluble salt): drain first, then leach. Sodic soil (too much sodium on the clay, ESP above 15): the clay disperses and flooding does nothing; apply calcium first, usually gypsum, then leach. Test before you treat.
Saline, sodic and saline-sodic soils, and their reclamation →
Salt harms land in two distinct ways. In a saline soil, dissolved salts make the soil water hard for roots to draw on, so plants wilt and scorch even when the ground is moist, yet the soil usually stays crumbly and lets water through. In a sodic soil the trouble is sodium sitting on the exchange sites of the clay. Sodium ions are large and weakly held, so when fresh water arrives the clay swells and its particles drift apart. Pores choke, the surface dries into a hard pavement, and roots meet a dense, airless layer.
Because the failures differ, a remedy for one can damage the other. Washing salts out cures salinity, but on a sodic or saline-sodic field fresh water removes the very salts that were keeping the clay flocculated.
A white, powdery crust that dissolves in water points to soluble salts. A dark, greasy-looking surface, puddles that stay murky brown for days and a hard, column-shaped subsoil suggest sodium.
Advisers in Australia, where sodic subsoils are widespread, use a simple dispersion test. Drop a few dry, pea-sized crumbs into a glass of rainwater or distilled water and leave it undisturbed. A milky halo that spreads from the crumbs and keeps the water cloudy overnight means the clay is dispersing, a strong warning of sodicity. Crumbs that merely fall into smaller pieces while the water stays clear are slaking, which shows weak structure but not excess sodium. Treat the jar as a screen, never as the diagnosis.
Sample good and poor patches separately, and take subsoil as well as topsoil, since sodium often concentrates between about 20 and 60 centimetres. Ask for electrical conductivity, ideally of the saturated paste extract (ECe), pH, exchangeable cations with cation exchange capacity so that the exchangeable sodium percentage (ESP) can be calculated, and the sodium adsorption ratio. Ask too whether the soil contains free lime, because that decides which amendment will work. If you irrigate, send a water sample for conductivity, sodium adsorption ratio and, where relevant, boron and residual sodium carbonate.
Under the long-standing US Salinity Laboratory scheme, ECe above 4 dS/m with ESP under 15 is saline; ESP above 15 with low ECe is sodic, usually with pH above 8.5; high values of both mean saline-sodic. Australian practice calls a soil sodic from an ESP of about 6, because many of its soils disperse at lower sodium levels, so check which convention your adviser uses.
Saline land needs working drainage first and then generous leaching with good water. Sodic and saline-sodic land needs calcium on the clay before any heavy leaching: gypsum on most soils, elemental sulphur or another acid-forming material where free lime is present. A pH reading above about 8.5 is a reason to test for sodium, not to treat the field as merely alkaline.
Typical errors are judging by the crust alone, flooding a field with no outlet so the water table rises and returns the salt, spreading gypsum on a purely saline soil where it adds little, and testing only the top few centimetres.
Bring in a soil specialist or drainage engineer when the water table sits within about two metres of the surface, when drains are needed, or when the amendment bill runs to many tonnes per hectare. Retest after each reclamation season to confirm that conductivity and ESP are actually falling.
Flooding a salty field to wash the salt out? On some soils, that makes things worse.
There are two problems.
A saline soil has too much soluble salt.
Drain it first, then leach it with good water, and the salt goes. A sodic soil has too much sodium on the clay. The clay disperses, the surface crusts, and water just stands on top.
Flooding it does nothing, because the sodium is not dissolved.
A sodic soil needs calcium first, usually gypsum, then leaching. The number to remember is an exchangeable sodium percentage of fifteen: above it, the soil is sodic.
So get a soil test before you treat a salty field.
The full guide to saline and sodic soils is in our long video and at laisha.ai.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
An AI operating system for agriculture: free guides, manuals and tools written for every country.