LAISHA
Open Laisha

NCEES FE Environmental Air & Noise Pollution: Monitoring & Control: practice questions

NCEES FE Environmental · USA · National Council of Examiners for Engineering and Surveying

Original practice questions written to the published syllabus · not past papers
10worked here, free
43written to this exam in this subject
10syllabus units

About NCEES FE Environmental

NCEES FE Environmental is a licensing and registration exam run by National Council of Examiners for Engineering and Surveying, for candidates in USA. Computer-based at Pearson VUE, 110 questions, 6-hour appointment (5 h 20 min exam time, 25-minute break). Reference handbook supplied on screen.

Source: ncees.org.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Air & Noise Pollution: Monitoring & Control in NCEES FE Environmental

Air quality engineering calculations: dispersion, control device efficiency, combustion and emission estimates, and noise.

Air pollutants, their health and crop effects, standards and indices, dispersion, and control equipment, plus noise. Agricultural sources (residue burning, ammonia, dust, odour) are covered here alongside the industrial ones GATE ES examines.

Our 43 NCEES FE Environmental questions in this subject: 6 easy, 24 medium, 13 hard, across 10 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to NCEES FE Environmental and are not shown on any other exam's page.

Question 1 · easy

A room of 200 m³ receives 1000 m³ of outdoor air per hour. How many air changes per hour (ACH) is this?

  1. 5
  2. 1200
  3. 200
  4. 0.2
Answer and working

A. 5

ACH = 1000/200 = 5. 0.2 inverts the ratio; 200 is the volume; 1200 adds.

Question 2 · medium

For a ground-level source (H = 0) with Q = 100 g/s, u = 5 m/s, σy = 100 m and σz = 50 m, what is the centreline ground-level concentration?

  1. About 4000 µg/m³
  2. About 1273 µg/m³
  3. About 637 µg/m³
  4. About 1.27 µg/m³
Answer and working

B. About 1273 µg/m³

C = Q/(π u σy σz) = 1.27 × 10⁻³ g/m³ ≈ 1273 µg/m³. 637 uses 2π; 4000 omits π; 1.27 confuses units.

Question 3 · medium

In a simple box model, C = qL/(uH), what happens to the urban concentration if the mixing height halves?

  1. It halves
  2. It doubles
  3. It is unchanged
  4. It quadruples
Answer and working

B. It doubles

C is inversely proportional to mixing height H.

Question 4 · medium

Gravity settling chambers are effective mainly for particles larger than about

  1. 0.5 µm
  2. 0.05 µm
  3. 5 µm
  4. 50 µm
Answer and working

D. 50 µm

Fine particles settle too slowly; chambers are pre-cleaners for coarse particles.

Question 5 · medium

Why does doubling a particle's diameter increase its Stokes settling velocity fourfold?

  1. Velocity scales with diameter squared
  2. Settling velocity is proportional to diameter
  3. Air viscosity doubles for larger particles
  4. Larger particles have lower density
Answer and working

A. Velocity scales with diameter squared

vt ∝ dp²; doubling dp gives 4 × vt.

Question 6 · hard

What is the 'air-to-cloth ratio' in fabric filter design?

  1. Ratio of bag length to diameter
  2. Mass of dust per bag per day
  3. Fabric weight per square metre
  4. Gas flow per unit fabric area
Answer and working

D. Gas flow per unit fabric area

Air-to-cloth ratio equals filtration velocity; lower values improve efficiency and bag life.

Question 7 · medium

Condensation is most suitable for VOC streams that are

  1. free of any organic compounds
  2. very dilute with very low boiling points
  3. composed only of nitrogen and oxygen
  4. concentrated, with high boiling points
Answer and working

D. concentrated, with high boiling points

Cooling condenses VOCs efficiently only when concentrations and boiling points are high.

Question 8 · medium

Selective catalytic reduction of NOx uses which reagent?

  1. Limestone slurry
  2. Chlorine gas
  3. Activated carbon
  4. Ammonia or urea over a catalyst
Answer and working

D. Ammonia or urea over a catalyst

SCR injects NH3 or urea upstream of a catalyst at about 300–400 °C, reducing NOx to N2.

Question 9 · medium

Thermal NOx forms mainly

  1. from air N2 and O2 in very hot flames
  2. from water vapour in the flue gas
  3. from sulphur in coal reacting with nitrogen
  4. from nitrogen in fertilisers applied to fields
Answer and working

A. from air N2 and O2 in very hot flames

Thermal NOx forms above roughly 1300 °C; fuel NOx comes from fuel-bound nitrogen.

Question 10 · medium

Increasing sound intensity tenfold raises the sound level by

  1. 3 dB
  2. 10 dB
  3. 20 dB
  4. 100 dB
Answer and working

B. 10 dB

L = 10 log(I/I0); ×10 intensity = +10 dB; doubling = +3 dB.

A study plan for Air & Noise Pollution: Monitoring & Control in NCEES FE Environmental

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (63% of the 43 questions): Particulate control: settling chambers, cyclones, wet scrubbers, fabric filters, ESP (8, 19%); Gaussian plume dispersion modelling (7, 16%); Gaseous control: absorption, adsorption, condensation, combustion (6, 14%); Noise: sources, effects, standards, measurement and control (6, 14%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Control of SOx, NOx, CO and hydrocarbons; vehicle emissions (5, 12%); Meteorology and dispersion: stability, mixing height, wind rose (4, 9%); Emission inventories for point, line and area sources (3, 7%); Indoor air pollution (2, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Air quality indices and visibility (1, 2%); Criteria pollutants, ambient and emission standards (1, 2%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Indoor air pollution (1 hard of 2), Gaussian plume dispersion modelling (3 hard of 7), Control of SOx, NOx, CO and hydrocarbons; vehicle emissions (2 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Indoor air pollution (1 easy of 2); Emission inventories for point, line and area sources (1 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — NCEES FE Environmental Air & Noise Pollution: Monitoring & Control

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.