ICAR AIEEA-PG Concentrated & Dried Dairy Products: practice questions
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
48written to this exam in this subject
12syllabus units
About ICAR AIEEA-PG
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Concentrated & Dried Dairy Products in ICAR AIEEA-PG
Physico-chemical changes in manufacture and storage of milk powder, lactose crystallisation and its significance, chemistry of condensed and dried milks, evaporation and spray drying principles. Expect MCQs on sugar ratio, forewarming, seeding, WPNI classes, roller versus spray drying and powder defects.
Evaporated and sweetened condensed milk, milk powders and their functional properties, storage and defects.
Our 48 ICAR AIEEA-PG questions in this subject: 17 easy, 28 medium, 3 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
Question 1 · easy
1,000 kg of milk with 12.5% total solids is concentrated to evaporated milk of 25% total solids. How much water is removed?
500 kg
250 kg
750 kg
125 kg
Answer and working
A. 500 kg
Concentrate = 1000 × 12.5 ÷ 25 = 500 kg; water removed = 1000 − 500 = 500 kg. 250 kg would leave 750 kg; 125 kg is the solids; 750 kg would concentrate four-fold.
Question 2 · easy
A milk powder has a bulk density of 0.60 g/mL. What volume does a 25 kg bag occupy?
25.0 L
150.0 L
15.0 L
41.7 L
Answer and working
D. 41.7 L
Volume = 25,000 g ÷ 0.60 g/mL = 41,667 mL = 41.7 L. 15.0 L multiplies by density; 25.0 L treats density as 1; 150.0 L slips a factor of ten.
Question 3 · medium
Why is evaporated milk homogenised?
To crystallise the lactose into fine crystals
To remove dissolved air before canning
To increase its heat stability by breaking casein
To prevent fat separation
Answer and working
D. To prevent fat separation
Fine globules do not cream in the can over months. The separation it prevents would otherwise build up during long storage.
Question 4 · medium
Lactose crystals in SCM begin to feel gritty roughly above what size?
About 10 µm
About 0.1 µm
About 1 mm
About 0.5 µm
Answer and working
A. About 10 µm
Crystals smaller than about 10 µm are not perceived; larger ones increasingly give sandiness.
Question 5 · easy
Why is milk concentrated in an evaporator before spray drying?
The dryer cannot remove any water from liquid milk at all
Concentration removes the fat before drying
Evaporation removes water far more cheaply than the dryer
Concentration sterilises the milk before drying
Answer and working
C. Evaporation removes water far more cheaply than the dryer
Multiple-effect evaporators use much less energy per kg of water.
Question 6 · hard
During spray drying, milk droplet temperature stays well below the inlet air temperature mainly because:
The droplets are frozen before they enter the chamber
The air is cooled by water sprays before it meets the droplets
Milk has a very high thermal conductivity that dissipates heat
Evaporative cooling holds droplets near wet-bulb temperature
Answer and working
D. Evaporative cooling holds droplets near wet-bulb temperature
While water evaporates, the droplet surface stays near wet-bulb temperature.
Question 7 · medium
Compared with spray-dried powder, roller-dried milk powder has:
Better instant properties in cold water
No free fat at all and a lower bulk density
Lower insolubility and less heat damage
More insolubility and heat damage
Answer and working
D. More insolubility and heat damage
Contact with hot drums causes denaturation and browning.
Question 8 · easy
Under Codex, skimmed milk powder contains at most:
26% fat
1.5% fat
0.1% fat
5% fat
Answer and working
B. 1.5% fat
SMP ≤1.5% fat; WMP ≥26% and <42%.
Question 9 · medium
Under Codex, whole milk powder contains:
At most 1.5% fat
At least 42% fat
At least 26% and less than 42% fat
Between 1.5% and 10% fat, as partly skimmed
Answer and working
C. At least 26% and less than 42% fat
Higher-fat powders form a separate class.
Question 10 · easy
Dairy whitener, common in South Asia, is:
Vegetable fat with sodium caseinate and glucose syrup solids
Milk powder with added sugar for whitening tea and coffee
Pure skim milk powder with no additives
Condensed milk dried on rollers
Answer and working
B. Milk powder with added sugar for whitening tea and coffee
Non-dairy creamers use vegetable fat and caseinate; whitener is milk-based with sugar.
A study plan for Concentrated & Dried Dairy Products in ICAR AIEEA-PG
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (50% of the 48 questions): Defects of condensed milks (6, 13%); Evaporated milk: process and heat stability (6, 13%); Spray drying of milk: process and powder properties (6, 13%); Sweetened condensed milk: sugar ratio and lactose crystallisation (6, 13%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Whole, skim and instant milk powders (6, 13%); Heat classification of milk powders: WPNI (5, 10%); Powder storage, caking and Maillard browning (3, 6%); Water activity, sorption and glass transition in powders (3, 6%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Dairy whiteners and filled milk powders (2, 4%); Powder fires and explosions: safety (2, 4%); Roller drying (2, 4%); Agglomeration and instantising (1, 2%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Dairy whiteners and filled milk powders (1 hard of 2), Spray drying of milk: process and powder properties (1 hard of 6), Sweetened condensed milk: sugar ratio and lactose crystallisation (1 hard of 6).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Agglomeration and instantising (1 easy of 1); Water activity, sorption and glass transition in powders (2 easy of 3).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.