ICAR AIEEA-PG Dairy Colloids: Emulsions, Foams & Gels: practice questions
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
80written to this exam in this subject
11syllabus units
About ICAR AIEEA-PG
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Dairy Colloids: Emulsions, Foams & Gels in ICAR AIEEA-PG
Milk as a colloidal system and the physical chemistry of the emulsions, foams and gels that make cream, ice cream, yoghurt and cheese.
Our 80 ICAR AIEEA-PG questions in this subject: 30 easy, 48 medium, 2 hard, across 11 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
Question 1 · easy
What is the approximate HLB of distilled monoglycerides?
About 3–4
About 10–12
About 15
About 18–20
Answer and working
A. About 3–4
Monoglycerides are lipophilic with HLB around 3–4; polysorbate 80 is about 15.
Question 2 · medium
What is the purpose of the second stage of a two-stage homogeniser?
To separate the cream from the skim milk after the first stage
To raise the fat globule size back to about 4 µm for flavour
To pasteurise the milk by the heat generated in the valve
To break up clusters of newly formed globules sharing casein
Answer and working
D. To break up clusters of newly formed globules sharing casein
New globules can be linked by shared casein micelles; the low-pressure second stage disperses these clusters, lowering viscosity and creaming.
Question 3 · medium
What mainly covers the new fat surface created by homogenising milk?
Fresh milk fat globule membrane synthesised by enzymes during homogenisation
Adsorbed casein micelles and fragments, plus whey protein
Lactose crystals that deposit from the serum onto every globule surface
Nothing; the new surface stays bare until the milk is pasteurised
Answer and working
B. Adsorbed casein micelles and fragments, plus whey protein
The native membrane is far too little for the enlarged area; caseins dominate the new surface, so homogenised globules behave partly like casein particles.
Question 4 · medium
Why must raw milk not be homogenised and then held before heat treatment?
Homogenised raw milk coagulates within minutes because of the pressure
The new globules rise faster and form a solid cream plug
Homogenisation raises the bacterial count tenfold in raw milk
Disrupted membranes let milk lipase act quickly, causing rancidity
Answer and working
D. Disrupted membranes let milk lipase act quickly, causing rancidity
Lipoprotein lipase reaches the newly exposed fat, releasing free fatty acids; pasteurisation immediately after homogenisation inactivates it.
Question 5 · easy
Why is cream whipped cold, at about 5 °C?
So the fat is partly crystalline and partially coalesces
So that all the fat is fully liquid and spreads over the bubbles
So that bacteria cannot grow during the minute of whipping
So that the cream freezes and holds its shape immediately
Answer and working
A. So the fat is partly crystalline and partially coalesces
Partial coalescence needs a mix of solid and liquid fat; warm cream with liquid fat gives weak, unstable foam.
Question 6 · easy
With which cation does κ-carrageenan form firm, brittle gels?
Magnesium only
Potassium
Sodium only
Calcium only, in the form of the egg-box
Answer and working
B. Potassium
κ-Carrageenan gels with K⁺ and shows syneresis; ι-carrageenan forms elastic gels with Ca²⁺; λ does not gel.
Question 7 · medium
Fat globules bound to a protein gel network, increasing its firmness, are called:
Inactive fillers
Active fillers
Depletants
Antifoams
Answer and working
B. Active fillers
Globules covered with casein or whey protein interact with the gel matrix and reinforce it, as in yoghurt made from homogenised milk.
Question 8 · medium
How does high-methoxyl pectin stabilise acidified milk drinks at pH about 4?
It hydrolyses casein into soluble peptides
It raises the pH back to 6.7 so that casein is negatively charged again
It adsorbs on positive casein and repels by steric and charge effects
It forms a calcium egg-box gel that traps every particle
Answer and working
C. It adsorbs on positive casein and repels by steric and charge effects
Below about pH 4.6 casein is positively charged; pectin's negative blocks adsorb while loops and tails stabilise.
Question 9 · easy
Nanoemulsions are commonly defined as emulsions with mean droplet radius below about:
10 µm
1 nm
1 mm
100 nm
Answer and working
D. 100 nm
Definitions vary, but below about 100 nm radius is common; such droplets hardly scatter visible light and barely cream.
Question 10 · easy
Which device makes nanoemulsions by colliding two high-velocity jets in an interaction chamber?
Colloid mill
Microfluidiser
Paddle mixer
Cream separator
Answer and working
B. Microfluidiser
Microfluidisers give intense shear and impact; colloid mills and mixers give much coarser emulsions.
A study plan for Dairy Colloids: Emulsions, Foams & Gels in ICAR AIEEA-PG
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (46% of the 80 questions): Acid and rennet milk gels (10, 13%); Foams: formation, structure and stability; whipped cream and overrun (10, 13%); Creaming, flocculation, coalescence and partial coalescence (9, 11%); Protein and polysaccharide gels (8, 10%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Hydrocolloid stabilisers and protein-polysaccharide interactions (7, 9%); Organogels, hydrogels and nanoemulsions (7, 9%); Techniques to study structure: microscopy and particle sizing (7, 9%); Colloidal state of milk and colloid stability (6, 8%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Emulsifiers and the HLB concept (6, 8%); Emulsion formation, homogenisation and stability (6, 8%); Interfacial science and surfactants (4, 5%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Creaming, flocculation, coalescence and partial coalescence (1 hard of 9), Acid and rennet milk gels (1 hard of 10).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Colloidal state of milk and colloid stability (4 easy of 6); Emulsifiers and the HLB concept (4 easy of 6).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.