ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
59written to this exam in this subject
11syllabus units
About ICAR AIEEA-PG
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Cream, Butter, Ghee & Milk Fat Products in ICAR AIEEA-PG
Manufacture of butter and ghee and changes during manufacture and storage, defects, and chemistry of cream, butter and ghee including spoilage of ghee and antioxidants. Expect MCQs on churning theory, overrun, ghee methods, pre-stratification, granulation, analytical constants and defects such as fishy, rancid, leaky and mottled butter.
Cream products, butter, anhydrous milk fat, butter oil and ghee: processes, yields, defects and quality.
Our 59 ICAR AIEEA-PG questions in this subject: 13 easy, 41 medium, 5 hard, across 11 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
Question 1 · easy
1.0 L of cream whips to 2.1 L of whipped cream. What is the overrun?
52%
110%
210%
11%
Answer and working
B. 110%
Overrun = (2.1 − 1.0) ÷ 1.0 × 100 = 110%. 210% uses the whipped volume as the numerator; 52% divides the gain by the whipped volume; 11% slips the decimal.
Question 2 · medium
500 kg of 38% cream gives 230 kg of butter of 81.5% fat. What is the churning efficiency?
46.0%
98.7%
1.3%
121.1%
Answer and working
B. 98.7%
Fat in butter = 187.45 kg; fat in cream = 190 kg; efficiency = 98.7%. 46.0% is butter per cream mass; 1.3% is the loss; 121.1% compares butter mass with fat and is really overrun plus 100.
Question 3 · medium
Under the PMO, products with 10% or more fat are pasteurised:
Only by UHT, never by HTST
5 °C lower than milk (fat is said to transfer heat better)
3 °C higher than milk, i.e. 74.4 °C for 15 s in HTST
At exactly the same temperature as milk
Answer and working
C. 3 °C higher than milk, i.e. 74.4 °C for 15 s in HTST
Fat protects micro-organisms, so the PMO adds 3 °C: 68.3 °C/30 min or 74.4 °C/15 s.
Question 4 · hard
In the accepted foam theory of churning, air bubbles:
Carry away the lactose so that the fat becomes insoluble and separates
Dissolve the globule membrane completely so the fat melts
Cool the cream until all the fat solidifies into one block
Collect globules whose damaged membranes let liquid fat glue them together
Answer and working
D. Collect globules whose damaged membranes let liquid fat glue them together
Globules adsorb at bubbles, membranes are damaged, liquid fat spreads and acts as glue; clusters grow into grains as the foam collapses.
Question 5 · medium
Butter churned at too high a temperature tends to give:
Higher overrun with no change in quality
Very long churning times and very hard, brittle grains
Soft grains and high fat loss in buttermilk
No buttermilk at all
Answer and working
C. Soft grains and high fat loss in buttermilk
Too much liquid fat gives greasy grains and more fat in buttermilk; too cold gives long churning.
Question 6 · medium
Why is washing of butter grains often omitted in modern practice?
Washing is banned in all countries
It removes flavour and needs potable water, with little benefit
Washing raises the fat content above 90%
Washing destroys the water-in-oil emulsion of the butter grains
Answer and working
B. It removes flavour and needs potable water, with little benefit
Washing removes buttermilk but also flavour; modern hygiene makes it largely unnecessary.
Question 7 · easy
Cultured butter differs from sweet-cream butter in that it:
Is made from cream fermented with an aroma culture
Contains at least 3% salt
Is made from cream heated to UHT temperatures before churning
Contains vegetable oil
Answer and working
A. Is made from cream fermented with an aroma culture
Lactic butter has diacetyl aroma and lower serum pH from fermentation.
Question 8 · medium
Desi butter (makkhan) in South Asia is churned from:
Dahi
Ghee residue
Skim milk
Sweet cream
Answer and working
A. Dahi
Makkhan is churned from dahi and used mainly for ghee.
Question 9 · hard
Fishy flavour in butter is associated with:
Unsalted sweet-cream butter stored frozen for a short time
Butter coloured with too much annatto or carotene
Butter made from cream pasteurised at too low a temperature
Salted butter from acid cream, with trimethylamine from lecithin
Answer and working
D. Salted butter from acid cream, with trimethylamine from lecithin
Acid, salt and metal ions favour lecithin breakdown and oxidation giving fishy flavour.
Question 10 · medium
Why is high-fat cream (about 70–80%) preferred in the direct-cream method?
It needs no heating
It gives a whiter ghee
It increases ghee residue, which is the main product sold
Less water to evaporate, saving fuel and time
Answer and working
D. Less water to evaporate, saving fuel and time
Low-fat cream carries much serum, raising fuel use and residue.
A study plan for Cream, Butter, Ghee & Milk Fat Products in ICAR AIEEA-PG
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (54% of the 59 questions): Overrun and yield calculations in butter (10, 17%); Butter defects and grading (8, 14%); Ghee flavour, granulation and keeping quality (7, 12%); Types of cream and their standards (7, 12%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Ghee making: creamery-butter, direct-cream, pre-stratification and desi methods (6, 10%); Batch and continuous butter making (5, 8%); Cream processing: pasteurisation, neutralisation and ripening (5, 8%); Cultured and salted butter; dairy spreads (4, 7%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Ghee residue and buttermilk utilisation (4, 7%); Anhydrous milk fat and butter oil (2, 3%); Fractionation and modification of milk fat (1, 2%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Butter defects and grading (2 hard of 8), Batch and continuous butter making (1 hard of 5), Cream processing: pasteurisation, neutralisation and ripening (1 hard of 5).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Fractionation and modification of milk fat (1 easy of 1); Anhydrous milk fat and butter oil (1 easy of 2).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.