ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
53written to this exam in this subject
11syllabus units
About ICAR AICE-JRF/SRF
ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Cream, Butter, Ghee & Milk Fat Products in ICAR AICE-JRF/SRF
Subject 34 Unit 5: fat globule size and creaming, cream composition, chemistry of neutralisation and ripening, mechanism of churning, desi and creamery butter, ghee composition by method, analytical constants, cow versus buffalo ghee, hydrolytic and oxidative deterioration, adulteration, grading, antioxidants, buttermilk and ghee residue. Subject 37 Unit 1: fat-rich dairy products technology.
Cream products, butter, anhydrous milk fat, butter oil and ghee: processes, yields, defects and quality.
Our 53 ICAR AICE-JRF/SRF questions in this subject: 5 easy, 25 medium, 23 hard, across 11 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.
Question 1 · hard
To remove 3.5 kg of lactic acid from cream with calcium hydroxide (74 g Ca(OH)2 neutralises 180 g lactic acid), how much lime is needed?
2.88 kg
0.72 kg
1.44 kg
3.27 kg
Answer and working
C. 1.44 kg
Ca(OH)2 = 3.5 × 74 ÷ 180 = 1.44 kg (one mole of hydroxide neutralises two moles of acid). 2.88 kg assumes one mole of acid per mole of lime; 3.27 kg is the sodium bicarbonate figure; 0.72 kg halves the correct value.
Question 2 · hard
Butter (1,000 kg, 16% water) is made into ghee. Pre-stratification removes 80% of the water as liquid serum before heating. Taking 2,257 kJ per kg of water evaporated and ignoring sensible heat, how much evaporation energy is saved?
53.6 MJ
361.1 MJ
288.9 MJ
72.2 MJ
Answer and working
C. 288.9 MJ
Water = 160 kg; evaporation without stratification = 160 × 2257 = 361.1 MJ; 80% removed as liquid saves 288.9 MJ. 361.1 MJ is the total load; 72.2 MJ is what remains; 53.6 MJ uses sensible heat to 100 °C in place of latent heat.
Question 3 · medium
Why is sour cream neutralised before pasteurisation for butter or ghee?
Neutralisation is needed to activate the starter in cultured butter
Neutralisation removes feed taints by binding them to the alkali
Acid cream curdles on heating, and salted butter from it turns fishy
Neutralisation increases the fat content of the cream for churning
Answer and working
C. Acid cream curdles on heating, and salted butter from it turns fishy
Heating acid cream coagulates protein, causing losses and burnt particles; high acidity in salted butter promotes fishy and oxidised flavours.
Question 4 · hard
Soft summer milk fat is usually given which ageing treatment to firm the butter?
Rapid deep cooling, giving many small crystals
Adding vegetable oil to raise the solid fat content
Holding at 40 °C so that no fat crystallises before churning
Slow cooling at a warm temperature, forming few large crystals
Answer and working
A. Rapid deep cooling, giving many small crystals
Fast deep cooling gives many small crystals that bind more liquid fat, firming soft fat.
Question 5 · medium
In continuous (Fritz-type) butter machines, butter grains form:
Within seconds in a fast-beater churning cylinder
After several hours in a slowly rotating drum
By evaporation of water under vacuum
Only after the cream has been fermented overnight with culture
Answer and working
A. Within seconds in a fast-beater churning cylinder
High-speed beaters produce grains almost instantly; working follows in screw sections with a vacuum stage.
Question 6 · medium
Why is salted butter usually made from sweet rather than cultured cream?
Salt cannot dissolve in acid serum
Salt combined with acidity promotes oxidative defects in storage
Cultured cream will not churn if salt is added
Salt kills the aroma culture, so that no diacetyl can ever form in it
Answer and working
B. Salt combined with acidity promotes oxidative defects in storage
Acid plus salt and trace metals favours fishy and oxidised flavours.
Question 7 · hard
Which approach makes butter spreadable from the refrigerator while keeping it pure milk fat?
Raising the water content above 25% with stabilisers
Adding sugar to lower the melting point of the fat
Adding hydrogenated vegetable fat to raise its softness at 5 °C
Using olein fractions or cream ageing that leaves more liquid fat
Answer and working
D. Using olein fractions or cream ageing that leaves more liquid fat
Fractions and crystallisation control stay within milk fat; vegetable fat would make it a blend.
Question 8 · easy
Dry fractionation of milk fat separates:
Water from fat
Fat from protein
Cholesterol from phospholipids
A high-melting stearin from a low-melting olein
Answer and working
D. A high-melting stearin from a low-melting olein
Controlled crystallisation and filtration split milk fat by melting range.
Adding hydrogen to the unsaturated fatty acids, raising their melting point
Rearranging fatty acids on the glycerol without changing their composition
Answer and working
D. Rearranging fatty acids on the glycerol without changing their composition
Positional rearrangement alters crystallisation; hydrogenation would change composition.
Question 10 · hard
Why is solvent fractionation rarely used for food milk fat?
It cannot separate any fractions from milk fat
Solvent cost and acceptance outweigh its sharper separation
It is required only for vegetable oils by law
It destroys all the triglycerides in milk fat
Answer and working
B. Solvent cost and acceptance outweigh its sharper separation
Acetone or hexane crystallisation separates well but is costly and unpopular for dairy.
A study plan for Cream, Butter, Ghee & Milk Fat Products in ICAR AICE-JRF/SRF
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (57% of the 53 questions): Cream processing: pasteurisation, neutralisation and ripening (9, 17%); Fractionation and modification of milk fat (8, 15%); Anhydrous milk fat and butter oil (7, 13%); Ghee making: creamery-butter, direct-cream, pre-stratification and desi methods (6, 11%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Batch and continuous butter making (4, 8%); Cultured and salted butter; dairy spreads (4, 8%); Types of cream and their standards (4, 8%); Ghee flavour, granulation and keeping quality (3, 6%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Ghee residue and buttermilk utilisation (3, 6%); Overrun and yield calculations in butter (3, 6%); Butter defects and grading (2, 4%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Batch and continuous butter making (3 hard of 4), Ghee flavour, granulation and keeping quality (2 hard of 3), Ghee residue and buttermilk utilisation (2 hard of 3).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Ghee residue and buttermilk utilisation (1 easy of 3); Cultured and salted butter; dairy spreads (1 easy of 4).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.