LAISHA
Open Laisha

ICAR AICE-JRF/SRF Membrane Processing & Dairy Ingredients: practice questions

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
82written to this exam in this subject
12syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Membrane Processing & Dairy Ingredients in ICAR AICE-JRF/SRF

Subject 37 Unit 4: classification, hardware and design of membrane plants, UF modelling (mass transfer and resistance models), fouling and cleaning, factors affecting flux in UF and RO, energy use, preparation of WPC, casein, co-precipitates, lactose and low-lactose products, demineralisation, and functional properties of whey proteins, casein and UF retentate. Subject 38 Unit 3: membrane types, properties and selection. Expect model equations, flux and VCF calculations and mechanism questions.

MF, UF, NF and RO in milk and whey processing, the protein and lactose ingredients they make, and how their function is measured.

Our 82 ICAR AICE-JRF/SRF questions in this subject: 9 easy, 50 medium, 23 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · easy

10,000 L of skim milk gives 7,500 L of UF permeate. What is the volume concentration factor?

  1. 0.75
  2. 1.33
  3. 4
  4. 3
Answer and working

C. 4

Retentate = 2,500 L; VCF = 10,000 ÷ 2,500 = 4. 1.33 divides feed by permeate; 0.75 is the permeate fraction; 3 is permeate ÷ retentate.

Question 2 · hard

A solute with rejection 0.3 undergoes 3 diavolumes of constant-volume diafiltration. Using C/C0 = e^(−N(1 − R)), what fraction remains?

  1. 12.2%
  2. 40.7%
  3. 30.0%
  4. 5.0%
Answer and working

A. 12.2%

e^(−3 × 0.7) = e^−2.1 = 12.2%. 5.0% ignores rejection; 40.7% uses N × R instead of N(1 − R); 30.0% is the rejection.

Question 3 · hard

Skim milk with 3.4% protein and 5.6% other solids is ultrafiltered to VCF 3.5 without diafiltration. Assuming full protein retention and free passage of other solids, what is the protein in dry matter of the retentate?

  1. 12%
  2. 68%
  3. 88%
  4. 38%
Answer and working

B. 68%

Protein = 11.9%; other solids stay 5.6%; DM protein = 11.9 ÷ 17.5 = 68%. 38% is skim milk itself; 12% is wet protein; 88% wrongly divides the other solids by the VCF.

Question 4 · medium

Why is centrifugal fat removal used before whey UF?

  1. Fat speeds UF flux and must be added back later
  2. Fat prevents microbial growth on the membranes
  3. Fat is needed to crystallise lactose in the permeate
  4. Fat fouls membranes and lowers protein purity
Answer and working

D. Fat fouls membranes and lowers protein purity

Residual fat concentrates with protein and fouls.

Question 5 · medium

Why does UF flux generally rise with temperature?

  1. Osmotic pressure doubles
  2. Viscosity falls
  3. Proteins denature and pass through
  4. The membrane pores shrink
Answer and working

B. Viscosity falls

Lower viscosity eases flow; high temperatures bring other risks.

Question 6 · medium

Cleaning effectiveness is usually verified by:

  1. The weight of the membrane module
  2. The temperature of the final rinse
  3. Clean water flux recovery
  4. The colour of the cleaning solution
Answer and working

C. Clean water flux recovery

Normalised water permeability is compared with a reference.

Question 7 · easy

Ceramic MF of about 1.4 µm removes bacteria from skim milk because bacteria are:

  1. Denser than fat globules
  2. Larger than casein micelles
  3. Charged opposite to the membrane
  4. Smaller than casein micelles
Answer and working

B. Larger than casein micelles

Bacteria are retained by size; micelles pass.

Question 8 · medium

Permeate from MPC production is mainly:

  1. A fat-rich stream for butter
  2. A protein-rich stream sold as WPC
  3. A lactose-rich stream that must be used
  4. Pure water for boiler feed
Answer and working

C. A lactose-rich stream that must be used

Small solutes pass into permeate.

Question 9 · medium

In electrodialysis, ions move through:

  1. Alternating cation- and anion-exchange membranes under an electric field
  2. Ceramic pores that retain only proteins
  3. A single neutral membrane under high hydraulic pressure
  4. Resin columns that are regenerated with acid and alkali between production runs
Answer and working

A. Alternating cation- and anion-exchange membranes under an electric field

Ion-exchange membranes and DC current separate salts into a brine stream.

Question 10 · hard

Why might cheese standards in some countries restrict milk protein concentrate in cheese milk?

  1. Standards of identity define permitted milk ingredients
  2. MPC cannot coagulate with rennet
  3. MPC always contains vegetable fat
  4. MPC contains no casein
Answer and working

A. Standards of identity define permitted milk ingredients

Names and permitted ingredients are set by regulation.

A study plan for Membrane Processing & Dairy Ingredients in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (43% of the 82 questions): Flux, transmembrane pressure and concentration factor (11, 13%); Concentration polarisation and fouling models (9, 11%); Functional properties of dairy proteins: solubility, emulsifying, foaming, gelation (8, 10%); Diafiltration (7, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Ultrafiltration: milk protein concentrates and cheese milk (7, 9%); Membrane classification and membrane materials (6, 7%); Membrane cleaning and sanitation (6, 7%); Microfiltration: bacteria removal and micellar casein (6, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Nanofiltration and electrodialysis for demineralisation (6, 7%); Reverse osmosis for concentration and water recovery (6, 7%); Ingredient specifications and applications (5, 6%); Membrane modules and plant configurations (5, 6%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Concentration polarisation and fouling models (5 hard of 9), Diafiltration (3 hard of 7), Membrane classification and membrane materials (2 hard of 6).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Flux, transmembrane pressure and concentration factor (2 easy of 11); Membrane classification and membrane materials (1 easy of 6).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Membrane Processing & Dairy Ingredients

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.