ICAR AICE-JRF/SRF Emerging & Non-thermal Dairy Processing: practice questions
ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
74written to this exam in this subject
12syllabus units
About ICAR AICE-JRF/SRF
ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Emerging & Non-thermal Dairy Processing in ICAR AICE-JRF/SRF
Alternatives and additions to heat: high pressure, pulsed electric fields, ultrasound, ohmic and microwave heating, irradiation, carbonation and hurdle technology.
Our 74 ICAR AICE-JRF/SRF questions in this subject: 19 easy, 46 medium, 9 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.
Question 1 · easy
What pressure range is most used commercially in high pressure processing?
4–6 MPa
400–600 MPa
40–60 kPa
4,000–6,000 MPa
Answer and working
B. 400–600 MPa
Commercial HPP mostly runs at 400–600 MPa for a few minutes.
Question 2 · easy
Which microorganisms are most resistant to high pressure alone at ambient temperature?
Bacterial spores
Moulds
Yeasts
Gram-negative rods
Answer and working
A. Bacterial spores
Spores need pressure combined with heat; Gram-negatives are generally more pressure sensitive than Gram-positives.
Question 3 · medium
What is the mechanism of microbial inactivation by pulsed electric fields?
Dissolving cell walls with ozone
Heating the cell interior to over 100 °C
Electroporation of the cell membrane
Breaking covalent bonds in DNA directly
Answer and working
C. Electroporation of the cell membrane
An induced transmembrane potential above about 1 V creates pores, irreversible at high intensity.
Question 4 · easy
What frequency range is typical of power ultrasound for processing?
About 2–10 GHz
About 2–10 MHz
About 20–100 kHz
About 20–100 Hz
Answer and working
C. About 20–100 kHz
High-frequency, low-intensity ultrasound (MHz) is used for measurement.
Question 5 · easy
What is the main mechanism by which power ultrasound acts in liquids?
Joule heating
Acoustic cavitation
Electroporation
Ionising radiation
Answer and working
B. Acoustic cavitation
Bubble collapse produces hot spots, shock waves, shear, microjets and radicals.
Question 6 · medium
Why is ethanol added as a co-solvent when extracting phospholipids?
Ethanol sterilises the extraction vessel
Supercritical CO2 is non-polar and dissolves them poorly
Phospholipids react with CO2 to form gas
Ethanol lowers the critical pressure of CO2 to zero
Answer and working
B. Supercritical CO2 is non-polar and dissolves them poorly
A polar modifier extends CO2's range to polar lipids.
Question 7 · hard
How do regulators usually treat deliberately engineered nanomaterials in food?
They treat them exactly as bulk materials
They ban all nanostructures, including casein micelles
They exempt them from any assessment
They require specific safety assessment
Answer and working
D. They require specific safety assessment
Particle-specific behaviour requires characterisation and toxicology; natural dairy nanostructures are not treated as engineered.
Question 8 · medium
Under a pressure treatment, the target organism's D value is 0.8 min. What minimum holding time gives a 6-log reduction?
7.5 min
4.8 min
0.13 min
6.8 min
Answer and working
B. 4.8 min
6 × 0.8 = 4.8 min. 0.13 divides 0.8 by 6.
Question 9 · medium
In EU novel food law, when is a food from a new process 'novel'?
Only when the food is imported
When the process significantly changes composition
Whenever the factory or production line is newly built
Whenever the process uses electricity at any stage
Answer and working
B. When the process significantly changes composition
Significant changes affecting nutrition, metabolism or undesirable substances trigger authorisation.
Question 10 · medium
Why can't pressure-treated milk simply be called 'pasteurised milk' in many jurisdictions?
Pressure treatment is banned for all foods everywhere
Pasteurisation is defined by thermal processes
Pasteurised milk must be sold frozen
Pressure-treated milk contains no protein
Answer and working
B. Pasteurisation is defined by thermal processes
Dairy standards list time–temperature combinations; other processes need specific recognition or a different name.
A study plan for Emerging & Non-thermal Dairy Processing in ICAR AICE-JRF/SRF
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (47% of the 74 questions): High pressure processing (10, 14%); Ohmic, microwave, radio-frequency and infrared heating (9, 12%); Pulsed electric fields (8, 11%); Regulatory approval of novel processes (8, 11%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Cold plasma (7, 9%); Irradiation and UV-C treatment of milk (7, 9%); Supercritical fluid extraction (7, 9%); Ultrasound in processing and cleaning (6, 8%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Hurdle technology (5, 7%); Microencapsulation and nanotechnology (3, 4%); 3D printing and other new formats (2, 3%); Carbonation and carbon dioxide to extend shelf life (2, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Microencapsulation and nanotechnology (1 hard of 3), Ohmic, microwave, radio-frequency and infrared heating (2 hard of 9), High pressure processing (2 hard of 10).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Cold plasma (3 easy of 7); Irradiation and UV-C treatment of milk (3 easy of 7).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.