LAISHA
Open Laisha

ICAR AICE-JRF/SRF Dairy Colloids: Emulsions, Foams & Gels: practice questions

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
43written to this exam in this subject
11syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Dairy Colloids: Emulsions, Foams & Gels in ICAR AICE-JRF/SRF

Milk as a colloidal system and the physical chemistry of the emulsions, foams and gels that make cream, ice cream, yoghurt and cheese.

Our 43 ICAR AICE-JRF/SRF questions in this subject: 5 easy, 21 medium, 17 hard, across 11 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

Why does skim milk look slightly bluish?

  1. Skim milk contains copper ions from the separator that tint it blue
  2. Riboflavin in skim milk absorbs yellow light and so leaves the milk looking blue
  3. Whey proteins in solution form a blue pigment complex with calcium phosphate
  4. Casein micelles are small and scatter short blue wavelengths more strongly
Answer and working

D. Casein micelles are small and scatter short blue wavelengths more strongly

Without fat globules, scattering is dominated by sub-micrometre micelles, which scatter shorter wavelengths more. Riboflavin gives whey a greenish-yellow colour, not blue.

Question 2 · hard

Using κ⁻¹ ≈ 0.304/√I nm for a 1:1 electrolyte at 25 °C, what is the Debye length at an ionic strength of 0.08 mol/L, similar to milk?

  1. About 11 nm
  2. About 1.1 nm
  3. About 3.8 nm
  4. About 0.024 nm
Answer and working

B. About 1.1 nm

0.304/√0.08 = 0.304/0.283 ≈ 1.07 nm. 3.8 nm divides by I instead of √I; 11 nm is a tenfold slip. The short Debye length means electrostatic repulsion in milk acts only over very short distances.

Question 3 · medium

What mainly gives casein micelles their stability in fresh milk?

  1. Covalent disulphide bonds linking every micelle to the fat globules
  2. Strong van der Waals attraction between micelles and the serum
  3. Steric and electrostatic repulsion from the κ-casein hairy layer
  4. A coat of phospholipid membrane taken from the secretory cell
Answer and working

C. Steric and electrostatic repulsion from the κ-casein hairy layer

The flexible, negatively charged C-terminal part of κ-casein protrudes as a hairy layer. Remove it (chymosin) or collapse it (acid, ethanol) and micelles aggregate.

Question 4 · medium

What is the Gibbs-Marangoni effect?

  1. Proteins unfolding and forming disulphide bonds once they reach an air-water interface
  2. Droplets rising under gravity at a rate set by their size and density
  3. Gas diffusing from small bubbles into large bubbles because of a pressure difference
  4. Surfactant flow towards stretched spots that drags liquid in and heals thin films
Answer and working

D. Surfactant flow towards stretched spots that drags liquid in and heals thin films

Interfacial tension gradients drive flow along the interface, which carries liquid into thinning films. Gas diffusion between bubbles is disproportionation; rising droplets is creaming.

Question 5 · medium

What is partial coalescence?

  1. Reversible clustering of droplets by a non-adsorbing polysaccharide
  2. Growth of large droplets at the expense of small ones by diffusion
  3. Clumping of partly crystalline globules that keep their shapes
  4. Merging of fully liquid droplets into one larger spherical droplet
Answer and working

C. Clumping of partly crystalline globules that keep their shapes

Fat crystals pierce films and liquid oil joins globules, but the crystal network stops them rounding up. Full coalescence gives spheres; diffusion-driven growth is Ostwald ripening.

Question 6 · hard

Why does milk heated well above minimum pasteurisation cream less than raw milk?

  1. Heat inactivates the cold agglutinins that cluster the globules
  2. Heat converts the globules into casein micelles
  3. Heat strips all the fat globule membranes off the globules entirely
  4. Heat melts the fat so it becomes denser than the serum
Answer and working

A. Heat inactivates the cold agglutinins that cluster the globules

The IgM cryoglobulins are heat sensitive; once inactivated, globules rise singly and slowly.

Question 7 · hard

Agar gels set at about 35–40 °C but melt only near 85 °C. What is this behaviour called?

  1. Ostwald ripening
  2. Thermal hysteresis
  3. Thixotropy
  4. Syneresis
Answer and working

B. Thermal hysteresis

The setting and melting temperatures differ widely because helix aggregates dissociate only at high temperature.

Question 8 · hard

An emulsion has 4% dispersed phase by volume and a Sauter mean diameter d32 of 0.5 µm. What is its interfacial area per mL of emulsion?

  1. 0.12 m²
  2. 0.048 m²
  3. 0.48 m²
  4. 4.8 m²
Answer and working

C. 0.48 m²

Area = 6φ/d32 = 6 × 0.04/(0.5 × 10⁻⁶) = 4.8 × 10⁵ m²/m³ = 0.48 m²/mL. 0.12 m² uses 3φ/d (radius form with diameter).

Question 9 · medium

Zeta potential is usually derived from which measurement?

  1. Conductivity of the dispersion measured with no field applied
  2. Electrophoretic mobility in an applied electric field
  3. pH change on adding acid
  4. Angle of light scattering at rest
Answer and working

B. Electrophoretic mobility in an applied electric field

Electrophoretic light scattering measures particle velocity in a field; Henry or Smoluchowski equations convert mobility to zeta potential.

Question 10 · easy

What is an oleogel?

  1. A fat crystallised fully into the beta polymorph
  2. Liquid oil given solid-like structure by a gelator network
  3. A water-swollen network of hydrophilic polysaccharide chains
  4. An oil-in-water emulsion stabilised only by casein
Answer and working

B. Liquid oil given solid-like structure by a gelator network

Oleogels use ethylcellulose, waxes, monoglycerides or phytosterol mixtures to structure oil without saturated fat crystals.

A study plan for Dairy Colloids: Emulsions, Foams & Gels in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (42% of the 43 questions): Colloidal state of milk and colloid stability (5, 12%); Interfacial science and surfactants (5, 12%); Acid and rennet milk gels (4, 9%); Creaming, flocculation, coalescence and partial coalescence (4, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Emulsifiers and the HLB concept (4, 9%); Emulsion formation, homogenisation and stability (4, 9%); Organogels, hydrogels and nanoemulsions (4, 9%); Techniques to study structure: microscopy and particle sizing (4, 9%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Foams: formation, structure and stability; whipped cream and overrun (3, 7%); Hydrocolloid stabilisers and protein-polysaccharide interactions (3, 7%); Protein and polysaccharide gels (3, 7%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Creaming, flocculation, coalescence and partial coalescence (3 hard of 4), Acid and rennet milk gels (2 hard of 4), Emulsifiers and the HLB concept (2 hard of 4).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Organogels, hydrogels and nanoemulsions (2 easy of 4); Foams: formation, structure and stability; whipped cream and overrun (1 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Dairy Colloids: Emulsions, Foams & Gels

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.