ICAR AIEEA-PG Dairy Processing Equipment: practice questions
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
34written to this exam in this subject
13syllabus units
About ICAR AIEEA-PG
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Dairy Processing Equipment in ICAR AIEEA-PG
Unit II: materials and sanitary features of dairy equipment; homogeniser theory, triplex pump, lubrication, care, accessories and standards; pasteuriser construction and materials, HTST, care; sterilisers; mixing and agitation; principles of evaporation and drying equipment. Expect direct MCQs on parts, functions and care of each machine.
Construction, operation, care and sizing of the machines in a milk plant: tanks, separators, homogenisers, pasteurisers, sterilisers and fillers.
Our 34 ICAR AIEEA-PG questions in this subject: 22 easy, 12 medium, 0 hard, across 13 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
Question 1 · easy
What is the volume of a vertical cylindrical silo 4 m in diameter and 10 m high?
40.0 m³
251.3 m³
125.7 m³
502.7 m³
Answer and working
C. 125.7 m³
V = π × 4² ÷ 4 × 10 = 125.7 m³. 502.7 uses diameter as radius; 40.0 ignores π and the area; 251.3 divides D² by 2 instead of 4.
Question 2 · medium
A two-stage homogeniser is set to a total of 20 MPa with the second stage at a fifth of the total. What is the second-stage pressure?
16 MPa
4 MPa
20 MPa
5 MPa
Answer and working
B. 4 MPa
One-fifth of 20 is 4 MPa. 16 MPa is the first-stage share; 5 MPa uses a quarter; 20 MPa is the total.
Question 3 · easy
Why is milk in silos agitated gently rather than vigorously?
To heat the milk by friction
To separate cream at the top
To incorporate air for later whipping into cream
To prevent creaming without foaming or fat damage
Answer and working
D. To prevent creaming without foaming or fat damage
Vigorous agitation causes foam and lipolysis.
Question 4 · easy
Why must a homogeniser never run against a closed outlet?
Its motor is too weak to start against milk
It is a positive-displacement pump
The milk would freeze
The valve would open by itself
Answer and working
B. It is a positive-displacement pump
Pressure would build until something fails; a relief valve is fitted.
Question 5 · easy
Plate heat exchangers are best suited to:
Drying powders
Low-viscosity liquids without particles
Very viscous pastes with large particles
Gas cooling in refrigeration plants
Answer and working
B. Low-viscosity liquids without particles
Narrow channels limit PHEs.
Question 6 · easy
Why must steam retorts be vented before timing begins?
Remove air causing cold spots
To raise the pressure above 10 bar
To add oxygen for sterilisation
To cool the cans
Answer and working
A. Remove air causing cold spots
Air pockets reduce heat transfer.
Question 7 · easy
Which agitator suits viscous products in jacketed kettles?
Anchor with scrapers
High-speed propeller
Marine propeller with baffles
Static mixer
Answer and working
A. Anchor with scrapers
Anchors sweep the wall and aid heat transfer.
Question 8 · easy
Batch butter churns are filled with cream to about:
Completely full to the lid
Ninety per cent
One-tenth
Half their volume
Answer and working
D. Half their volume
Space is needed for agitation and air.
Question 9 · easy
In traditional open cheese vats, curd is cut with:
Wire harps
Homogenising valves
Paring discs
Dasher blades
Answer and working
A. Wire harps
Harps with wires cut the coagulum into cubes.
Question 10 · easy
A continuous ice cream freezer is cooled by:
Steam condensing in its jacket
Ambient air
Hot water
Evaporating refrigerant
Answer and working
D. Evaporating refrigerant
Ammonia or halocarbons evaporate at low temperature.
A study plan for Dairy Processing Equipment in ICAR AIEEA-PG
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (59% of the 34 questions): Homogenisers: triplex pump, valves, two-stage operation, care (7, 21%); Milk storage tanks and silos (4, 12%); Centrifugal separators and clarifiers (3, 9%); Filling and packaging machines (3, 9%); Ice cream freezers (3, 9%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Sanitary design features and materials of dairy equipment (3, 9%); Butter churns and continuous butter makers (2, 6%); Mixing and agitation equipment (2, 6%); Plate heat exchangers: regeneration, holding tube, flow diversion valve (2, 6%); Tubular and scraped-surface heat exchangers (2, 6%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Cheese vats, curd makers and moulding systems (1, 3%); Retorts and in-container sterilisers (1, 3%); UHT plants: direct steam injection and infusion; indirect systems (1, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Bank the easy marks: Mixing and agitation equipment (2 easy of 2); Plate heat exchangers: regeneration, holding tube, flow diversion valve (2 easy of 2).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.