ICAR AICE-JRF/SRF Wood Seasoning, Preservation & Protection: practice questions
ICAR AICE-JRF/SRF (PhD) — Subject 59 Forestry · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
37written to this exam in this subject
12syllabus units
About ICAR AICE-JRF/SRF
ICAR AICE-JRF/SRF (PhD) — Subject 59 Forestry is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 2 hours, 120 MCQs (Part A 20 general; Part B 50 core group; Part C 50 subject), +4 / −1, maximum 480.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Wood Seasoning, Preservation & Protection in ICAR AICE-JRF/SRF
MCQs on wood seasoning and preservation techniques: air and kiln seasoning, defects, preservatives and treatment processes.
Drying timber without defects and protecting it from decay, insects and fire, by chemical, biological and modified-wood methods.
Our 37 ICAR AICE-JRF/SRF questions in this subject: 2 easy, 10 medium, 25 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.
Question 1 · hard
Air seasoning is often used before kiln drying mainly because it:
Produces lower final moisture content than any kiln
Prevents all seasoning defects
Prevents all seasoning defects in every species
Removes much water cheaply, saving kiln time and energy
Answer and working
D. Removes much water cheaply, saving kiln time and energy
Pre-drying reduces the costly kiln stage.
Question 2 · hard
A drawback of long air seasoning in warm, humid climates is:
Risk of stain, decay and insects
Excessively fast drying in all seasons
Moisture contents below 5%
Collapse in every species
Answer and working
A. Risk of stain, decay and insects
Slow drying in warm humid air favours fungi and insects.
Question 3 · hard
Collapsed wood in some species can be partly recovered by:
Freezing the wood overnight
Soaking in preservative
Sanding the surface
Reconditioning with steam
Answer and working
D. Reconditioning with steam
Steaming allows flattened cells to recover partly.
Question 4 · hard
Girdling is now less common because it:
Is forbidden by every forest act in Asia
Makes logs sink
Increases seasoning time
Reduces growth and permits insect attack
Answer and working
D. Reduces growth and permits insect attack
Dying standing trees attract borers.
Question 5 · hard
Why can a marine pile attacked by shipworms look sound from outside?
Shipworms only eat the paint on piles
Larvae enter through tiny holes and tunnel internally
Shipworms attack only above water
Shipworms leave large surface grooves
Answer and working
B. Larvae enter through tiny holes and tunnel internally
Internal tunnelling destroys piles while the surface appears intact.
Question 6 · easy
Pentachlorophenol was listed for elimination under the Stockholm Convention in:
2015
1975
1995
2025
Answer and working
A. 2015
It is persistent and contaminated with dioxins.
Question 7 · hard
A main disadvantage of creosote is that it:
It leaches out of wood within a few weeks
Is ineffective against marine borers
Contains carcinogenic PAHs and cannot be painted
Makes wood swell greatly
Answer and working
C. Contains carcinogenic PAHs and cannot be painted
It is effective and leach-resistant but oily and hazardous.
Question 8 · hard
The Lowry process differs from the Rueping process in that it:
No initial pressure, so less recovery
It uses an initial vacuum, like the Bethell process
It uses no preservative at all
It applies only to green, unseasoned wood
Answer and working
A. No initial pressure, so less recovery
No initial air pressure means less expulsion of excess.
Question 9 · hard
A known side effect of some fire-retardant treatments is:
Increased hygroscopicity and fastener corrosion
Lower moisture uptake in humid rooms
Increased strength at high temperature
Elimination of all decay
Answer and working
A. Increased hygroscopicity and fastener corrosion
Salts attract moisture; some formulations also reduce strength in hot conditions.
Question 10 · medium
In India, insecticides and fungicides used as wood preservatives are registered under:
The Indian Forest Act, 1927
The Biological Diversity Act, 2002
The Forest Rights Act, 2006
The Insecticides Act, 1968
Answer and working
D. The Insecticides Act, 1968
Registration is through the Central Insecticides Board and Registration Committee.
A study plan for Wood Seasoning, Preservation & Protection in ICAR AICE-JRF/SRF
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (35% of the 37 questions): Treatment methods: non-pressure and pressure (full-cell, empty-cell) (4, 11%); Air seasoning (3, 8%); Biological and environmentally safer preservation; modified wood (3, 8%); Fire retardants (3, 8%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Kiln seasoning: kiln types and schedules (3, 8%); Preservatives: oil-type, water-borne, organic solvent (3, 8%); Retention, penetration and treatment standards (3, 8%); Safety and environmental rules on preservatives (3, 8%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Sap-displacement and diffusion methods (3, 8%); Seasoning defects and their control (3, 8%); Solar and other low-cost seasoning (3, 8%); Wood-destroying agents: fungi, insects, marine borers (3, 8%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Treatment methods: non-pressure and pressure (full-cell, empty-cell) (3 hard of 4), Air seasoning (2 hard of 3), Biological and environmentally safer preservation; modified wood (2 hard of 3).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Preservatives: oil-type, water-borne, organic solvent (1 easy of 3); Wood-destroying agents: fungi, insects, marine borers (1 easy of 3).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.