LAISHA
Open Laisha

ICAR AICE-JRF/SRF Water & Wastewater Treatment: practice questions

ICAR AICE-JRF/SRF (PhD) — Environmental Sciences (subject 71) and Agricultural Meteorology (subject 60) · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
17written to this exam in this subject
12syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD) — Environmental Sciences (subject 71) and Agricultural Meteorology (subject 60) is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. Computer-based MCQ paper for PhD admission and the JRF/SRF fellowship; one paper per subject. Timing and marking follow the yearly bulletin and were not re-read.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Water & Wastewater Treatment in ICAR AICE-JRF/SRF

Urban and industrial wastewater characteristics, treatment levels, activated sludge, anaerobic treatment and UASB, distillery, sugar and dairy effluents, CETPs and ZLD, sludge disposal.

Making water safe to drink and wastewater safe to release or reuse: unit operations, biological treatment, reactor kinetics, sludge, industrial effluents and zero liquid discharge. Farm-scale lagoons and manure systems are in the Agricultural Engineering subject waste-management-environmental-engg; this subject covers municipal and agro-industrial treatment to GATE ES depth.

Our 17 ICAR AICE-JRF/SRF questions in this subject: 0 easy, 15 medium, 2 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

Which coagulation mechanism involves particles being enmeshed in precipitating metal hydroxide?

  1. Inter-particle bridging
  2. Sweep flocculation
  3. Double-layer compression
  4. Charge neutralisation
Answer and working

B. Sweep flocculation

Bridging uses polymers; compression and neutralisation act on surface charge.

Question 2 · hard

Estimate the osmotic pressure of a 35 g/L NaCl solution at 25 degrees C using pi = i C R T (i = 2, R = 0.08314 L bar/(mol K)).

  1. 15 bar
  2. 30 bar
  3. 3.0 bar
  4. 867 bar
Answer and working

B. 30 bar

C = 35/58.44 = 0.599 mol/L; pi = 2 x 0.599 x 0.08314 x 298 = 30 bar. Omitting i halves it.

Question 3 · hard

Crown corrosion of concrete sewers is caused mainly by:

  1. Hydrogen sulphide oxidised to sulphuric acid by bacteria on the pipe crown
  2. Methane combustion inside the sewer during dry weather
  3. Chlorine residuals reacting with the cement at the invert of the pipe during wet weather
  4. Nitrate in sewage dissolving the steel reinforcement directly
Answer and working

A. Hydrogen sulphide oxidised to sulphuric acid by bacteria on the pipe crown

Anaerobic conditions produce H2S; aerobic bacteria on the crown form acid.

Question 4 · medium

Enhanced biological phosphorus removal requires:

  1. Continuous aeration throughout the tank
  2. Anaerobic then aerobic zones
  3. Addition of nitrate to the raw influent
  4. Only anoxic conditions in every zone
Answer and working

B. Anaerobic then aerobic zones

Phosphate-accumulating organisms release P anaerobically and take up excess P aerobically.

Question 5 · medium

An SVI above about 150-200 mL/g usually indicates:

  1. Anaerobic digestion
  2. Complete nitrification
  3. Sludge bulking
  4. Excellent settling
Answer and working

C. Sludge bulking

Often caused by filamentous organisms. Bulking sludge settles poorly and can wash out of clarifiers.

Question 6 · medium

Who developed the UASB reactor, and where?

  1. Karl Imhoff, Germany
  2. Edward Ardern, England
  3. Gustaf de Laval, Sweden
  4. Gatze Lettinga, Netherlands
Answer and working

D. Gatze Lettinga, Netherlands

Ardern and Lockett developed activated sludge (1914); Imhoff the Imhoff tank.

Question 7 · medium

Why is a CSTR more resistant to shock loads than a PFR?

  1. Inflow is immediately diluted in the tank
  2. It always has a shorter retention time
  3. It has no microorganisms that a shock could harm
  4. It operates at higher pressure than plug flow
Answer and working

A. Inflow is immediately diluted in the tank

Complete mixing dampens spikes in concentration or toxicity.

Question 8 · medium

Typical solids retention time for mesophilic anaerobic sludge digesters is about:

  1. 1-2 days
  2. 1-2 years
  3. 1-2 hours
  4. 15-30 days
Answer and working

D. 15-30 days

Methanogens need long SRT. Short SRTs wash out methanogens and cause failure.

Question 9 · medium

What gives distillery spentwash its dark brown colour, which is hard to remove?

  1. Melanoidins and related colourants
  2. Chlorophyll from cane leaves
  3. Methylene blue added in processing
  4. Iron oxides from soil
Answer and working

A. Melanoidins and related colourants

Maillard-reaction melanoidins resist biological degradation.

Question 10 · medium

What is the usual first treatment step for distillery spentwash before further treatment in India?

  1. Direct discharge to rivers
  2. Chlorination at high doses
  3. Primary sedimentation alone
  4. Biomethanation with energy recovery
Answer and working

D. Biomethanation with energy recovery

Biomethanation recovers energy; ZLD routes follow.

A study plan for Water & Wastewater Treatment in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (47% of the 17 questions): Agro-industrial effluents: dairy, sugar, distillery, food processing (2, 12%); Anaerobic treatment and UASB reactors (2, 12%); BOD kinetics (2, 12%); Filtration, desalination and disinfection (2, 12%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Sewers, storm sewers and appurtenances (2, 12%); Activated sludge, trickling filters and their design parameters (1, 6%); Common effluent treatment plants, recycling and zero liquid discharge (1, 6%); Primary, secondary and tertiary treatment (1, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Reactor kinetics: batch, CSTR and plug flow (1, 6%); Screening, sedimentation, coagulation and flocculation (1, 6%); Sludge treatment and disposal (1, 6%); Water and wastewater quality parameters: BOD, COD, solids, nutrients (1, 6%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Filtration, desalination and disinfection (1 hard of 2), Sewers, storm sewers and appurtenances (1 hard of 2).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Water & Wastewater Treatment

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.