LAISHA
Open Laisha

ICAR AIEEA-PG Evaporation & Drying in Dairy Plants: practice questions

ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
24written to this exam in this subject
12syllabus units

About ICAR AIEEA-PG

ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Evaporation & Drying in Dairy Plants in ICAR AIEEA-PG

Unit II: principles of evaporation and drying, vacuum pan and its care, atmospheric drum dryer, spray dryer principles, fluidisation. Expect definitions and short calculations.

Evaporators and dryers for milk and whey: design, energy economy, operation and powder engineering.

Our 24 ICAR AIEEA-PG questions in this subject: 14 easy, 9 medium, 1 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.

Question 1 · easy

10,000 kg of skim milk with 9% solids is concentrated to 45% solids. How much water is evaporated?

  1. 8,000 kg
  2. 3,600 kg
  3. 4,500 kg
  4. 2,000 kg
Answer and working

A. 8,000 kg

Concentrate = 900 ÷ 0.45 = 2,000 kg; water = 10,000 − 2,000 = 8,000 kg. 2,000 kg is the concentrate; 4,500 kg is 45% of the feed; 3,600 kg subtracts percentages (45 − 9) of the feed.

Question 2 · medium

An evaporator with a steam economy of 2.7 evaporates 8,000 kg of water. How much steam does it use?

  1. 21,600 kg
  2. 2,963 kg
  3. 2,667 kg
  4. 8,000 kg
Answer and working

B. 2,963 kg

Steam = 8,000 ÷ 2.7 = 2,963 kg. 21,600 kg multiplies by the economy; 8,000 kg assumes a single effect; 2,667 kg assumes an economy of exactly 3.

Question 3 · medium

1,000 kg/h of whey concentrate at 55% solids is spray-dried to powder of 97% solids. How much water is evaporated per hour?

  1. 567 kg
  2. 450 kg
  3. 420 kg
  4. 433 kg
Answer and working

D. 433 kg

Powder = 550 ÷ 0.97 = 567 kg; water = 1,000 − 567 = 433 kg. 450 kg is the water in the feed, ignoring moisture left in powder; 567 kg is the powder; 420 kg subtracts percentages (97 − 55) of the feed.

Question 4 · medium

Foaming in a vacuum pan is a problem mainly because:

  1. Foam raises the boiling point sharply
  2. Foam carries product into the condenser
  3. Foam sterilises the product
  4. Foam crystallises the sugar
Answer and working

B. Foam carries product into the condenser

Steady boiling and correct vacuum limit foaming.

Question 5 · easy

During the constant-rate drying period, the surface of a wet material stays near:

  1. The dry-bulb temperature of the inlet air
  2. 0 °C
  3. The wet-bulb temperature
  4. The dew point of the outlet air
Answer and working

C. The wet-bulb temperature

Evaporation cools the wet surface to near the wet-bulb temperature.

Question 6 · easy

Which atomiser type tolerates variations in feed rate and viscosity best?

  1. Drum film applicator
  2. Two-fluid nozzle
  3. Rotary wheel
  4. High-pressure nozzle
Answer and working

C. Rotary wheel

Wheels handle changes well but need wide chambers.

Question 7 · medium

In co-current spray drying, the wettest droplets meet:

  1. Air at the outlet temperature only
  2. The coldest air
  3. The hottest air
  4. No air until the fluid bed
Answer and working

C. The hottest air

Evaporative cooling protects them; dry particles meet cooler air.

Question 8 · medium

Drum dryers are energy-efficient per kg of water because:

  1. They recycle all the vapour as heating steam
  2. They use no steam or other heating medium
  3. They evaporate water at room temperature
  4. Heat passes by conduction from steam to film
Answer and working

D. Heat passes by conduction from steam to film

Conduction avoids heating large air volumes.

Question 9 · easy

Freeze drying removes water by:

  1. Boiling liquid water at atmospheric pressure
  2. Spraying it into hot air
  3. Sublimation of ice under vacuum
  4. Pressing the product between rollers
Answer and working

C. Sublimation of ice under vacuum

Ice goes directly to vapour below the triple point.

Question 10 · easy

Why should as much water as possible be removed before the spray dryer?

  1. The dryer uses far more energy per kg of water
  2. The dryer cannot remove any water at all
  3. Evaporators cannot handle concentrated milk
  4. Drying dilute milk gives higher bulk density
Answer and working

A. The dryer uses far more energy per kg of water

Evaporation and RO are much cheaper per kg of water.

A study plan for Evaporation & Drying in Dairy Plants in ICAR AIEEA-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (54% of the 24 questions): Vacuum pans (4, 17%); Drum dryers (3, 13%); Principles of evaporation and boiling-point elevation (3, 13%); Spray dryers: atomisers, chamber design, two- and three-stage drying (3, 13%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Falling-film evaporators (2, 8%); Multiple-effect evaporation and steam economy (2, 8%); Separation and recovery of powder: cyclones and bag filters (2, 8%); Drying fundamentals: drying rate and psychrometrics (1, 4%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Energy and safety in dryers (1, 4%); Fluid-bed dryers and agglomeration (1, 4%); Freeze drying and freeze concentration (1, 4%); Thermal and mechanical vapour recompression (1, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Fluid-bed dryers and agglomeration (1 hard of 1).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Separation and recovery of powder: cyclones and bag filters (2 easy of 2); Drying fundamentals: drying rate and psychrometrics (1 easy of 1).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG Evaporation & Drying in Dairy Plants

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.