LAISHA
Open Laisha

GATE ES Environmental Chemistry: practice questions

GATE — Environmental Science and Engineering (ES) · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
94written to this exam in this subject
13syllabus units

About GATE ES

GATE — Environmental Science and Engineering (ES) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 subject). MCQ, MSQ and NAT question types with negative marking on MCQ only, as in all GATE papers.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Environmental Chemistry in GATE ES

The chemistry of water, soil and air that pollution, treatment and climate subjects assume: equilibria, the carbonate system, redox, gas solubility, ozone and smog chemistry. GATE ES Section 2 in full.

Our 94 GATE ES questions in this subject: 13 easy, 59 medium, 22 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE ES and are not shown on any other exam's page.

Question 1 · medium

What is the ionic strength of a 0.01 M CaCl2 solution?

  1. 0.03 M
  2. 0.05 M
  3. 0.02 M
  4. 0.01 M
Answer and working

A. 0.03 M

I = ½(0.01 × 2² + 0.02 × 1²) = ½(0.04 + 0.02) = 0.03 M. 0.01 is the salt concentration; 0.02 ignores charge squared for Ca; 0.05 omits the ½.

Question 2 · medium

An acetate buffer contains 0.2 M acetate and 0.1 M acetic acid (pKa 4.76). What is its pH?

  1. 4.46
  2. 5.06
  3. 4.76
  4. 5.76
Answer and working

B. 5.06

pH = pKa + log([A⁻]/[HA]) = 4.76 + log 2 = 5.06. 4.76 assumes equal amounts; 4.46 inverts the ratio; 5.76 adds one full unit.

Question 3 · easy

How does the saturation concentration of dissolved oxygen in water change as temperature rises?

  1. It first rises then falls above 10 °C
  2. It increases
  3. It stays the same
  4. It decreases
Answer and working

D. It decreases

Gas solubility falls with temperature: about 14.6 mg/L at 0 °C, 9.1 at 20 °C and 7.6 at 30 °C.

Question 4 · medium

Why do amphoteric metal hydroxides such as Al(OH)3 redissolve at very high pH?

  1. They react with dissolved oxygen to form gases
  2. They lose all water and become oxides that dissolve
  3. They are reduced to the metal at high pH
  4. They form soluble hydroxo-anions such as aluminate
Answer and working

D. They form soluble hydroxo-anions such as aluminate

Amphoteric hydroxides dissolve in strong base as aluminate and similar anions, so each metal has a pH of minimum solubility.

Question 5 · medium

In what order are electron acceptors generally used as an organic-rich sediment becomes more reducing?

  1. O2, nitrate, Mn(IV), Fe(III), sulphate, CO2 (methanogenesis)
  2. CO2, sulphate, Fe(III), Mn(IV), nitrate, O2
  3. Sulphate, nitrate, O2, Fe(III), Mn(IV), CO2
  4. Fe(III), O2, sulphate, nitrate, CO2, Mn(IV)
Answer and working

A. O2, nitrate, Mn(IV), Fe(III), sulphate, CO2 (methanogenesis)

Microbes use acceptors in order of decreasing energy yield: the redox ladder from oxygen to methanogenesis.

Question 6 · medium

What is the oxidation state of sulphur in sulphate (SO4²⁻)?

  1. −2
  2. +6
  3. +2
  4. +4
Answer and working

B. +6

S + 4(−2) = −2, so S = +6. Sulphide is −2; sulphite +4.

Question 7 · easy

Which parameter measures the oxygen required to chemically oxidise organic matter using potassium dichromate?

  1. Chemical oxygen demand (COD)
  2. Total organic carbon (TOC)
  3. Dissolved oxygen (DO)
  4. Biochemical oxygen demand (BOD)
Answer and working

A. Chemical oxygen demand (COD)

COD uses dichromate in acid; BOD is microbial oxygen use over 5 days; DO is dissolved oxygen; TOC measures carbon.

Question 8 · easy

Which international agreement controls the production of ozone-depleting substances such as CFCs?

  1. The Stockholm Convention (2001)
  2. The Kyoto Protocol (1997)
  3. The Montreal Protocol (1987)
  4. The Basel Convention (1989)
Answer and working

C. The Montreal Protocol (1987)

Montreal regulates ODS; Kyoto greenhouse gases; Stockholm POPs; Basel hazardous waste trade.

Question 9 · medium

Which type of radiation is stopped by a sheet of paper but is most hazardous when inhaled or ingested?

  1. Alpha particles
  2. X-rays
  3. Beta particles
  4. Gamma rays
Answer and working

A. Alpha particles

Alpha particles have low penetration but high ionisation; inside the body they damage tissue intensely.

Question 10 · medium

Which radionuclide from nuclear accidents concentrates in the thyroid gland?

  1. Caesium-137
  2. Strontium-90
  3. Radon-222
  4. Iodine-131
Answer and working

D. Iodine-131

I-131 (t½ ≈ 8 days) accumulates in the thyroid; Cs-137 behaves like potassium and Sr-90 like calcium.

A study plan for Environmental Chemistry in GATE ES

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (45% of the 94 questions): Speciation of inorganic and organic contaminants (9, 10%); Water quality parameters and their measurement (9, 10%); Chemical equilibrium, thermodynamics and reaction kinetics (8, 9%); Complexation, precipitation and solubility product (8, 9%); Radioactivity and radionuclides in the environment (8, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Redox reactions, pe-pH diagrams and redox zonation (8, 9%); Acid-base equilibria, buffers and alkalinity (7, 7%); Chemical bonding, concentration units, activity and ionic strength (7, 7%); Solubility of gases in water: Henry's law (7, 7%); Tropospheric ozone and photochemical smog (7, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Stratospheric ozone chemistry and ozone-depleting substances (6, 6%); Composition and structure of the atmosphere (5, 5%); The carbonate system and ocean acidification (5, 5%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: The carbonate system and ocean acidification (2 hard of 5), Speciation of inorganic and organic contaminants (3 hard of 9), Chemical bonding, concentration units, activity and ionic strength (2 hard of 7).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Radioactivity and radionuclides in the environment (2 easy of 8); Composition and structure of the atmosphere (1 easy of 5).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE ES Environmental Chemistry

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.