LAISHA
Open Laisha

ICAR AIEEA-PG / PGS Sugar, Sweeteners, Chocolate & Confectionery Technology: practice questions

ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
88written to this exam in this subject
11syllabus units

About ICAR AIEEA-PG / PGS

ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Sugar, Sweeteners, Chocolate & Confectionery Technology in ICAR AIEEA-PG / PGS

Unit III names the technology of sugars and sweets. Expect MCQs on cane and beet composition, Brix, pol and purity, clarification methods (defecation, double sulphitation, carbonation), multiple-effect evaporation, massecuite and molasses, jaggery and khandsari, by-products, invert sugar, DE of glucose syrups, sweeteners, and confectionery terms such as doctor, graining, fondant and toffee.

Making sugar from cane and beet, non-centrifugal sugars such as jaggery, alternative sweeteners, and the sugar and chocolate confectionery built on them.

Our 88 ICAR AIEEA-PG / PGS questions in this subject: 23 easy, 53 medium, 12 hard, across 11 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.

Question 1 · medium

A cane juice reads 18.0 °Brix and 15.3 pol. Its purity is

  1. 117.6
  2. 2.7
  3. 85.0
  4. 82.5
Answer and working

C. 85.0

Purity = 15.3 ÷ 18.0 × 100 = 85.0. 117.6 inverts the ratio; 2.7 is Brix minus pol; 82.5 has no consistent basis.

Question 2 · hard

Vacuum pans boil syrup at reduced pressure and moderate temperature mainly to

  1. Increase the solubility of sucrose in the syrup
  2. Raise the boiling point so crystals grow faster
  3. Limit colour and inversion
  4. Remove calcium salts left from clarification
Answer and working

C. Limit colour and inversion

Lower boiling temperature reduces Maillard and caramel colour and the inversion of sucrose. Lower temperature reduces, not increases, solubility, it lowers rather than raises the boiling point, and calcium salts are not removed by boiling.

Question 3 · medium

Sugar colour in ICUMSA units is based on

  1. Polarimeter reading of a normal solution
  2. Reflectance of the dry crystals in daylight
  3. Absorbance at 420 nm
  4. Turbidity of a saturated solution at 20 °C
Answer and working

C. Absorbance at 420 nm

The ICUMSA colour method measures absorbance at 420 nm of a filtered sugar solution at specified pH and concentration; lower numbers mean whiter sugar. Polarimetry measures pol, and reflectance and turbidity are other tests.

Question 4 · medium

Distillery spent wash from molasses fermentation is difficult to dispose of mainly because it has

  1. Very low solids and neutral pH
  2. A high content of live yeast cells only
  3. A high fat content that floats
  4. A very high organic load
Answer and working

D. A very high organic load

Spent wash (vinasse) is acidic, dark and has a very high BOD and COD, so it needs anaerobic digestion, concentration and incineration, composting or controlled land application. It is not low in solids, and fat is not its problem.

Question 5 · medium

In enzymic manufacture of glucose syrup, the enzyme used for liquefaction of gelatinised starch is

  1. Glucoamylase
  2. Thermostable α-amylase
  3. Glucose isomerase
  4. Invertase
Answer and working

B. Thermostable α-amylase

A heat-stable α-amylase thins the gelatinised starch to dextrins at high temperature. Glucoamylase saccharifies the dextrins to glucose, glucose isomerase makes fructose, and invertase splits sucrose.

Question 6 · easy

Xylitol and erythritol give a cooling sensation in the mouth because they

  1. Contain menthol-like terpenes
  2. Are stored frozen before use
  3. Have a strongly negative heat of solution
  4. Release carbon dioxide when dissolved
Answer and working

C. Have a strongly negative heat of solution

Both polyols absorb heat as they dissolve, cooling the mouth, which suits mint confectionery and gum. They contain no terpenes, need no frozen storage and release no gas.

Question 7 · easy

In sugar confectionery, a 'doctor' is

  1. An ingredient controlling crystallisation
  2. A worker who checks the boiling temperature
  3. A tool used to cut toffee into pieces
  4. An enzyme that adds flavour to fondant
Answer and working

A. An ingredient controlling crystallisation

Doctors such as glucose syrup, invert sugar or cream of tartar (which inverts some sucrose) hinder or control crystallisation. The term does not refer to a person, a tool or a flavour enzyme.

Question 8 · medium

Compound coatings made with lauric fats such as palm kernel fat are used partly because they

  1. Contain more cocoa butter
  2. Melt above 40 °C
  3. Need no tempering
  4. Never develop off-flavours
Answer and working

C. Need no tempering

Lauric fats crystallise directly in a stable form, so coatings made with them do not need tempering. They contain little or no cocoa butter, melt near mouth temperature, and can develop soapy off-flavours if lipase acts on them.

Question 9 · medium

A customer returns chocolate with a white film. A drop of water placed on the film dissolves it. The defect is

  1. Fat bloom
  2. Sugar bloom
  3. Mould growth
  4. Untempered chocolate
Answer and working

B. Sugar bloom

Sugar crystals dissolve in water, so a film that disappears under a drop of water is sugar bloom. Fat bloom does not dissolve in water, mould shows growth, and untempered chocolate shows streaks and softness.

Question 10 · medium

Water activity of a confection mainly determines

  1. Its sweetness relative to sucrose
  2. Microbial growth and moisture migration
  3. Its melting point in the mouth
  4. The colour of the product
Answer and working

B. Microbial growth and moisture migration

Water activity controls which microorganisms can grow and whether the product gains or loses moisture to its surroundings and neighbouring components. Sweetness, melting and colour depend on other factors.

A study plan for Sugar, Sweeteners, Chocolate & Confectionery Technology in ICAR AIEEA-PG / PGS

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (42% of the 88 questions): Cane sugar manufacture: extraction, clarification, evaporation and crystallisation (10, 11%); Chocolate manufacture: refining, conching and tempering (10, 11%); Sugar confectionery: hard-boiled sweets, toffee, fondant and gums (9, 10%); Confectionery quality and shelf life (8, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Glucose syrups, invert sugar and high-fructose syrups (8, 9%); Sugar alcohols and high-intensity sweeteners (8, 9%); Sugar by-products: molasses, bagasse and press mud (8, 9%); Jaggery and other non-centrifugal sugars (7, 8%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Refining and specialty sugars (7, 8%); Sugarcane and sugar beet as raw materials (7, 8%); Fat bloom and sugar bloom (6, 7%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Sugar by-products: molasses, bagasse and press mud (2 hard of 8), Cane sugar manufacture: extraction, clarification, evaporation and crystallisation (2 hard of 10), Chocolate manufacture: refining, conching and tempering (2 hard of 10).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Sugarcane and sugar beet as raw materials (3 easy of 7); Cane sugar manufacture: extraction, clarification, evaporation and crystallisation (3 easy of 10).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG / PGS Sugar, Sweeteners, Chocolate & Confectionery Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.