Indian Forest Service Examination Stand Tending, Thinning & Pruning: practice questions
Indian Forest Service Examination (IFoS) — Forestry optional · India · Union Public Service Commission
Original practice questions written to the published syllabus · not past papers
10worked here, free
17written to this exam in this subject
10syllabus units
About Indian Forest Service Examination
Indian Forest Service Examination (IFoS) — Forestry optional is a government recruitment exam run by Union Public Service Commission, for candidates in India. Three stages: the Civil Services (Preliminary) Examination as a screening test; a written Main examination of six conventional papers (General English 300, General Knowledge 300, and two optional subjects of two papers each at 200 marks, 1,400 in all); and a 300-mark personality test.
We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.
Stand Tending, Thinning & Pruning in Indian Forest Service Examination
The intermediate treatments between regeneration and harvest that shape a stand's growth, quality and health.
Our 17 Indian Forest Service Examination questions in this subject: 1 easy, 11 medium, 5 hard, across 10 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Indian Forest Service Examination and are not shown on any other exam's page.
Question 1 · hard
What is the main risk of an over-heavy cleaning in a young natural regeneration?
Immediate conversion of the stand from high forest to simple coppice
A permanent increase in the stand's maximum stand density index
Exposure to sun, frost, wind and weeds
Loss of the right to carry out any later thinnings under the working plan
Answer and working
C. Exposure to sun, frost, wind and weeds
Removing too much cover leaves the young crop exposed and opens the site to weeds. It does not convert the system, change the species' maximum SDI or remove thinning rights.
Question 2 · medium
If thinning within the middle density range does not raise total volume production, why is it done?
It always doubles total volume production within one thinning cycle on every site
It lowers the cost of final felling to zero because no trees remain at rotation age in the thinned stand
It removes the need for any regeneration after final felling of the stand
It concentrates growth on fewer, larger, more valuable trees and uses trees that would otherwise die
Answer and working
D. It concentrates growth on fewer, larger, more valuable trees and uses trees that would otherwise die
Thinning redistributes growth to fewer, larger stems, which are worth more per cubic metre, and captures mortality as intermediate yield. It does not double production, remove felling costs or replace regeneration.
Question 3 · medium
An outrow in a thinning is:
A removed row that serves as an extraction rack, often combined with selective thinning between racks
A row of trees left unthinned along the compartment edge as a windbreak for the stand
A row of seedlings planted outside the plantation boundary to mark the compartment line, often with a stone pillar
A row of the tallest trees retained for seed in the final felling of the crop
Answer and working
A. A removed row that serves as an extraction rack, often combined with selective thinning between racks
Outrows open access for machines and are combined with selective thinning in the rows between. The other definitions are not outrows.
Question 4 · medium
A thinning ratio d/D clearly greater than 1 indicates:
Removal of trees smaller than average, as in low thinning from below the main canopy
Removal of trees larger than average, as in crown or selection thinning
Removal unrelated to size, as in row thinning
A thinning in which no trees were removed
Answer and working
B. Removal of trees larger than average, as in crown or selection thinning
d/D above 1 means removed trees exceed the pre-thinning mean diameter. Low thinning gives d/D below 1; row thinning gives about 1.
Question 5 · hard
A dense conifer stand was left unthinned well past its scheduled first thinning. What is generally the safer course?
Remove two-thirds of the stems at once to make up for lost time
Remove all dominants so the suppressed trees can respond quickly to the extra light and space
Fertilise heavily without thinning so that crowns expand at once
Thin lightly and often, or accept a no-thin regime, rather than make one heavy thinning
Answer and working
D. Thin lightly and often, or accept a no-thin regime, rather than make one heavy thinning
Overdue stands have small crowns and weak roots; heavy thinning invites windthrow and snow break. Removing dominants is high-grading; fertilising an overstocked stand mainly increases mortality.
Question 6 · hard
Removing bark-beetle brood trees before the new generation emerges is an example of:
Liberation cutting
Crown thinning
Precommercial thinning
Sanitation cutting
Answer and working
D. Sanitation cutting
Removing infested trees to prevent spread is sanitation. Liberation removes overtopping older trees; crown thinning and precommercial thinning are density treatments.
Question 7 · medium
Where should a pruning cut be made?
Just outside the branch collar, without leaving a stub and without cutting flush into the stem
Flush with the stem, cutting through the branch collar to leave a smooth surface of the trunk
About 15 cm from the stem, leaving a stub that will dry out and fall off later
Halfway along the branch, so that the remaining stub still carries some leaves
Answer and working
A. Just outside the branch collar, without leaving a stub and without cutting flush into the stem
Cutting at the collar lets the wound close quickly. Flush cuts enlarge the wound and slow healing; long stubs delay occlusion and admit decay.
Question 8 · medium
An advantage of girdling over felling unwanted trees is that:
The girdled tree immediately produces more seed for natural regeneration
The girdled tree's timber becomes more valuable than that of a felled tree of the same species
The tree dies standing and does not damage neighbouring crop trees as it would if felled
Girdling always kills the tree within one week, whatever the species
Answer and working
C. The tree dies standing and does not damage neighbouring crop trees as it would if felled
Girdled trees die in place and later become snags. They do not seed more, gain value, or die within a week.
Question 9 · medium
Timber stand improvement (TSI) in North American usage includes:
Only clear felling followed by planting of improved stock raised from seed orchards of the best trees
Cleaning, release, girdling and cull-tree removal without harvesting merchantable trees
Only fertiliser application from aircraft
Only the construction of forest roads and bridges
Answer and working
B. Cleaning, release, girdling and cull-tree removal without harvesting merchantable trees
TSI is the set of non-commercial operations that improve composition, quality and growth. The other options are single unrelated operations.
Question 10 · hard
Why can whole-tree harvesting for bioenergy create nutrient deficiencies that stem-only harvesting did not?
Whole-tree harvesting adds salt to the soil from the machinery used
Stem-only harvesting leaves the roots, which are the only nutrient store in a forest ecosystem at every stage of the rotation
Branches and foliage hold a large share of nutrients, so removing them exports more from the site
Whole-tree harvesting is done only on sites already rich in nutrients
Answer and working
C. Branches and foliage hold a large share of nutrients, so removing them exports more from the site
Foliage and branches are nutrient-rich; removing them increases export. Leaving them on site, returning ash or fertilising can compensate.
A study plan for Stand Tending, Thinning & Pruning in Indian Forest Service Examination
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (47% of the 17 questions): Fertilisation of established stands (2, 12%); Girdling and other stand-improvement methods (2, 12%); Improvement felling and salvage cutting (2, 12%); Thinning grades and thinning schedules (2, 12%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Thinning methods: mechanical, ordinary (low), crown, selection (2, 12%); Thinning: objectives and effects on growth (2, 12%); Weeding and cleaning (2, 12%); Climber cutting (1, 6%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Pruning: natural and artificial; timing and lift (1, 6%); Release treatments and competition control (1, 6%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Fertilisation of established stands (1 hard of 2), Improvement felling and salvage cutting (1 hard of 2), Thinning grades and thinning schedules (1 hard of 2).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Thinning methods: mechanical, ordinary (low), crown, selection (1 easy of 2).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.