ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papersICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Unit 1 (technology of milk, special milks, unit operations and their advances) and Unit 3 (advances in processing, cleaning and sanitation); deeper questions on ESL routes, UHT direct versus indirect, B* and C*, lactose hydrolysis and psychrotroph enzymes.
From reception to the consumer pack: clarification, separation, standardisation, homogenisation, pasteurisation, ESL and UHT, and special milks.
Our 60 ICAR AICE-JRF/SRF questions in this subject: 2 easy, 38 medium, 20 hard, across 13 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.
By Stokes' law, if a particle's diameter is doubled and all else is unchanged, its separation velocity becomes:
A. 4 times greater
v ∝ d², so doubling d multiplies v by 2² = 4. 2 times treats v as linear in d; 8 times uses d³ (particle volume); half confuses velocity with settling time.
Warming milk from 10 °C to 45 °C lowers its viscosity from 2.5 mPa·s to 1.0 mPa·s. Ignoring changes in density, by what factor does the rising velocity of a fat globule increase (Stokes' law)?
B. 2.5
v ∝ 1/η, so the ratio is 2.5 ÷ 1.0 = 2.5. 6.25 squares the ratio, as if viscosity entered like diameter; 0.4 inverts it; 4.5 is the temperature ratio 45 ÷ 10.
Using B* = t ÷ 10.1 × 10^((T − 135) ÷ 10.5), with t in seconds, what is B* for a UHT hold of 4 s at 140 °C?
D. 1.19
4 ÷ 10.1 = 0.396; 10^(5 ÷ 10.5) = 2.994; B* = 1.19 (≥ 1, so commercially adequate by this criterion). 0.19 is C* with the 30.5 s and z = 31.4 °C constants; 0.40 ignores the temperature term; 1.25 uses z = 10 °C.
Using F0 = t (min) × 10^((T − 121.1) ÷ 10), what is the F0 of 4 seconds at 140 °C?
C. 5.17 min
t = 4/60 = 0.0667 min; 10^(18.9 ÷ 10) = 77.6; F0 = 5.17 min. 310.5 enters seconds where minutes are required; 4.21 uses z = 10.5 °C; 0.13 drops the power of ten.
Why does a volumetric flow meter at tanker reception need an air eliminator?
D. Entrained air is counted as milk, so the meter over-reads
A volumetric meter counts the volume passing; air in the line inflates the reading and overpays the supplier. Hence plants prefer weighing or fit air eliminators.
Activation of the lactoperoxidase system to preserve raw milk involves adding:
C. Small amounts of thiocyanate and a hydrogen peroxide source such as percarbonate
Thiocyanate and peroxide let native lactoperoxidase form antibacterial hypothiocyanite (Codex CXG 13-1991). Formalin and bicarbonate are adulterants.
Why must raw milk be pasteurised immediately after homogenisation?
C. Native lipase attacks the exposed fat and turns the milk rancid fast
Breaking the globule membrane exposes fat to lipoprotein lipase; heat inactivates the enzyme. Casein is not lost.
Holding time in an HTST plant must be met by:
A. The fastest-moving particle, not the average particle
Regulations require the fastest particle to be held for the legal time, because some milk moves faster than the mean (2× in laminar flow).
Why is the cream fraction heat-treated separately rather than microfiltered in the MF route to ESL milk?
D. Fat globules are bacteria-sized and would be retained with them
Fat globules overlap bacteria in size, so they cannot be separated by a 1.4 µm membrane. Cream does carry bacteria.
Why is vitamin A commonly added to reduced-fat and skim milks?
B. Vitamin A is fat-soluble and leaves with the fat on skimming
Fat-soluble vitamins leave with the cream; fortification restores them. Vitamin A is not water-soluble.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.