ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency
Original practice questions written to the published syllabus · not past papers
10worked here, free
38written to this exam in this subject
9syllabus units
About ICAR AIEEA-PG / PGS
ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.
How the arrangement of molecules and phases decides texture, stability and digestion: emulsions, foams, gels and their stability, structure-function design, encapsulation and delivery of bioactives, digestion models, and the science and regulation of nanoscale food materials.
Our 38 ICAR AIEEA-PG / PGS questions in this subject: 19 easy, 19 medium, 0 hard, across 9 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.
Question 1 · medium
Using Stokes' law, how does the creaming velocity change when droplet radius is halved?
It falls to one quarter
It falls to one eighth
It doubles
It halves
Answer and working
A. It falls to one quarter
v ∝ r², so (1/2)² = 1/4.
Question 2 · easy
Which equipment produces submicron droplets in milk and infant formula?
High-pressure valve homogeniser
Ribbon blender
Hammer mill
Planetary dough mixer
Answer and working
A. High-pressure valve homogeniser
High-pressure homogenisers generate turbulence and cavitation in a narrow gap; mixers and mills do not.
Question 3 · medium
What is disproportionation in foams?
Drainage of liquid out of the films between bubbles
Rupture of the thin films between neighbouring bubbles
Rise of the whole foam layer under gravity
Gas diffusing from small bubbles to larger ones
Answer and working
D. Gas diffusing from small bubbles to larger ones
Higher Laplace pressure in small bubbles drives gas through the liquid to larger ones.
Question 4 · easy
Which food is a solid foam?
Honey
Milk
Bread
Mayonnaise
Answer and working
C. Bread
Bread crumb is a set gluten-starch matrix with gas cells.
Question 5 · medium
What conditions does high-methoxyl pectin need to gel?
High sugar and low pH
High pH and no sugar
Freezing to −18 °C
Calcium ions with low sugar
Answer and working
A. High sugar and low pH
HM pectin needs soluble solids above about 55% and pH about 2.8–3.5; LM pectin gels with calcium.
Question 6 · medium
How do calcium ions gel alginate?
By hydrolysing the alginate chains into short pieces
By forming triple helices together with gelatin
By bridging guluronic blocks in egg-box junctions
By reacting with lactose to form insoluble complexes
Answer and working
C. By bridging guluronic blocks in egg-box junctions
Ca²⁺ cross-links G-blocks of adjacent chains; LM pectin gels the same way.
Question 7 · medium
Why is high-methoxyl pectin added to drinking yoghurt at pH about 4?
It makes the whole drink set into a firm gel
It raises the pH of the drink above 7
It coats casein and stops aggregation
It removes the lactose from the drink
Answer and working
C. It coats casein and stops aggregation
Adsorbed pectin gives negative charge and steric repulsion to casein near its pI.
Question 8 · easy
A spray-dried fish oil powder has 30 g total oil and 1.5 g surface oil per 100 g. What is the encapsulation efficiency?
105%
95%
5%
28.5%
Answer and working
B. 95%
EE = (30 − 1.5)/30 × 100 = 95%. 5% is the surface fraction; 28.5% is the encapsulated mass in g; 105% adds the values.
Question 9 · medium
Why are volatile flavours retained during spray drying better than their volatility suggests?
The air inlet is held below 0 °C throughout drying
Flavours become non-volatile at high temperature
Water escapes faster than flavour through the dry skin
The flavours react with the wall to form stable salts
Answer and working
C. Water escapes faster than flavour through the dry skin
Once a skin forms, larger flavour molecules diffuse much more slowly than water.
Question 10 · easy
How are alginate beads for probiotics usually formed?
Spray drying the alginate in hot air at 300 °C
Mixing the alginate with oil and freezing it
Heating the alginate solution to 120 °C
Dripping alginate into calcium chloride
Answer and working
D. Dripping alginate into calcium chloride
Calcium cross-links alginate instantly, forming gel beads.
A study plan for Food Structure, Colloids, Encapsulation & Nanotechnology in ICAR AIEEA-PG / PGS
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (53% of the 38 questions): Protein and polysaccharide gels (8, 21%); Foams and aerated foods (6, 16%); Microencapsulation: spray drying, coacervation and extrusion (6, 16%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Colloidal systems in foods: dispersions, emulsions, foams and gels (4, 11%); Emulsion formation and stability mechanisms (4, 11%); Structure-function relationships and food structure design (4, 11%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Interfacial science: surfactants and proteins at interfaces (3, 8%); Protein-polysaccharide interactions (2, 5%); In-vitro digestion models and bioaccessibility (1, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Bank the easy marks: In-vitro digestion models and bioaccessibility (1 easy of 1); Interfacial science: surfactants and proteins at interfaces (2 easy of 3).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.