LAISHA
Open Laisha

ICAR AIEEA-PG / PGS Mathematics for Food Science & Engineering: practice questions

ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
18written to this exam in this subject
8syllabus units

About ICAR AIEEA-PG / PGS

ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Mathematics for Food Science & Engineering in ICAR AIEEA-PG / PGS

The calculus, linear algebra, differential equations and numerical methods behind every food engineering calculation: heat penetration curves, drying rates, reaction kinetics and process optimisation. GATE XE makes this section compulsory for every candidate who takes the Food Technology section.

Our 18 ICAR AIEEA-PG / PGS questions in this subject: 7 easy, 7 medium, 4 hard, across 8 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.

Question 1 · easy

Fourier's law of heat conduction is written q = −k∇T. What does the negative sign express?

  1. Heat flows in the direction of decreasing temperature
  2. Heat flux is measured into the surface, not out of it
  3. Thermal conductivity is a negative quantity for foods
  4. Temperature falls as conductivity rises in a solid
Answer and working

A. Heat flows in the direction of decreasing temperature

∇T points towards increasing temperature, and heat flows the opposite way, from hot to cold; the minus sign makes q point down the gradient. Conductivity is positive; the sign is not a measuring convention for surfaces; and it says nothing about how temperature depends on conductivity.

Question 2 · hard

A sauce cools from 90 °C to 50 °C in 10 min in a room at 20 °C, following Newton's law of cooling. How long from the start does it take to reach 30 °C?

  1. 30.0 min
  2. 23.0 min
  3. 20.0 min
  4. 15.0 min
Answer and working

B. 23.0 min

T − 20 = 70e^(−kt). At 10 min: 30 = 70e^(−10k), so k = ln(70/30)/10 = 0.0847 per min. For T = 30: 10 = 70e^(−kt), so t = ln 7/k = 23.0 min. 20 min assumes a linear fall; 15 min and 30 min come from using temperatures rather than temperature differences above the room.

Question 3 · medium

A slab of food takes 40 min to reach a target centre temperature. Under the same surface conditions and properties, how long will a slab of twice the thickness take?

  1. 160 min
  2. 80 min
  3. 40 min
  4. 320 min
Answer and working

A. 160 min

Time enters through the Fourier number Fo = αt/L², so equal Fo needs t ∝ L². Doubling L multiplies the time by 4: 4 × 40 = 160 min. 80 min assumes time proportional to thickness; 320 min uses L³. (With a finite Biot number the scaling is only approximate, because Bi also changes with L.)

Question 4 · easy

Thermal conductivity of a product is 0.40 W/(m·K) at 20 °C and 0.50 W/(m·K) at 40 °C. By linear interpolation, what is it at 26 °C?

  1. 0.45 W/(m·K)
  2. 0.43 W/(m·K)
  3. 0.41 W/(m·K)
  4. 0.46 W/(m·K)
Answer and working

B. 0.43 W/(m·K)

k = 0.40 + (26 − 20)(0.50 − 0.40)/(40 − 20) = 0.40 + 6 × 0.005 = 0.43. 0.45 is the midpoint value; 0.46 uses 6/10 of the difference instead of 6/20; 0.41 uses 2/20.

Question 5 · hard

A cold-point record gives 111.1 °C, 121.1 °C and 121.1 °C at 0, 1 and 2 min (z = 10 °C, reference 121.1 °C). What F₀ does the trapezoidal rule give for these 2 min?

  1. 1.55 min
  2. 1.00 min
  3. 1.10 min
  4. 2.00 min
Answer and working

A. 1.55 min

Lethal rates L = 10^((T − 121.1)/10): 0.1, 1 and 1. Trapezoid with h = 1: 0.5[0.1 + 2(1) + 1] = 1.55 min. 2.00 min treats every minute as fully lethal; 1.10 min adds the rates of only two points; 1.00 min uses only the last interval.

Question 6 · medium

A first-order inactivation has rate constant k = 0.5 per minute. What is the D value?

  1. 4.61 min
  2. 2.00 min
  3. 0.50 min
  4. 0.87 min
Answer and working

A. 4.61 min

D = 2.303/k = 2.303/0.5 = 4.61 min, because a tenfold drop means ln 10 = 2.303 units of kt. 2.00 min is 1/k, the time for an e-fold (not tenfold) drop; 0.87 min divides by 2.303k instead of multiplying; 0.50 min confuses k with D.

Question 7 · hard

A can holds 10⁴ spores of a spoilage organism with D₁₂₁ = 1.5 min. What F₀ gives a probability of one surviving spore per 10⁵ cans?

  1. 15.0 min
  2. 13.5 min
  3. 6.0 min
  4. 7.5 min
Answer and working

B. 13.5 min

From 10⁴ to 10⁻⁵ per can is 9 log reductions: F = 9 × 1.5 = 13.5 min. 6.0 min is only the 4 logs to one spore per can; 7.5 min uses 5 logs; 15.0 min uses 10 logs.

Question 8 · easy

In thermal death kinetics, what does the z value mean?

  1. The temperature change that changes D tenfold
  2. The temperature at which the D value is one minute
  3. The number of log reductions delivered by a process
  4. The time for a tenfold fall in the surviving population
Answer and working

A. The temperature change that changes D tenfold

z is the temperature interval for a one-log change in D. The time for a tenfold reduction is D; no standard parameter is defined as the temperature where D is one minute; the number of logs delivered is F/D.

Question 9 · medium

A population of 10⁶ cells per mL with D = 2 min is held for 10 min at the test temperature. How many cells per mL survive?

  1. 10⁵ cells per mL
  2. 1 cell per mL
  3. 10 cells per mL
  4. 100 cells per mL
Answer and working

C. 10 cells per mL

Log reduction = t/D = 10/2 = 5, so N = 10⁶/10⁵ = 10 per mL. 100 corresponds to 4 logs, 1 to 6 logs, and 10⁵ to a single log.

Question 10 · medium

Non-enzymatic browning in a stored powder follows zero-order kinetics: the browning index rises from 0.10 to 0.30 in 20 days. When will it reach the rejection value of 0.50?

  1. 40 days
  2. 20 days
  3. 30 days
  4. 50 days
Answer and working

A. 40 days

Zero order: the index rises by a constant amount per day, (0.30 − 0.10)/20 = 0.01 per day. From 0.10 to 0.50 needs 0.40/0.01 = 40 days. 50 days ignores the starting value of 0.10; 20 days is only the further time after day 20; 30 days has no basis in a constant rate.

A study plan for Mathematics for Food Science & Engineering in ICAR AIEEA-PG / PGS

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (72% of the 18 questions): Applications in food science: first-order kinetics, exponential decay and logarithmic survivor curves (10, 56%); First-order and second-order ordinary differential equations (2, 11%); Complex numbers, analytic functions and Cauchy-Riemann equations (1, 6%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Matrices, determinants, rank and systems of linear equations (1, 6%); Numerical integration and Euler's method for ODEs (1, 6%); Numerical methods: Gauss elimination, LU decomposition, interpolation and Newton-Raphson (1, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Partial differential equations: one-dimensional heat equation and Laplace equation by separation of variables (1, 6%); Vector calculus: gradient, divergence, curl and Green's theorem (1, 6%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: First-order and second-order ordinary differential equations (2 hard of 2), Numerical integration and Euler's method for ODEs (1 hard of 1), Applications in food science: first-order kinetics, exponential decay and logarithmic survivor curves (1 hard of 10).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Matrices, determinants, rank and systems of linear equations (1 easy of 1); Numerical methods: Gauss elimination, LU decomposition, interpolation and Newton-Raphson (1 easy of 1).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG / PGS Mathematics for Food Science & Engineering

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.