LAISHA
Open Laisha

ICAR AICE-JRF/SRF Cheese Science & Technology: practice questions

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
64written to this exam in this subject
13syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Cheese Science & Technology in ICAR AICE-JRF/SRF

Subject 34 Unit 7 (rennet action, changes during manufacture and ripening, coagulants from microbial, animal and plant sources), subject 36 Unit 5 (cheese starters, accelerated ripening, spoilage) and subject 37 Units 1 and 7 (manufacture, microbial rennet and recombinant chymosin, immobilised enzymes, enzyme-modified cheese). Questions go deeper: proteolytic agents and their substrates, Fitz equation, C/P ratio, UF cheese making.

Cheese from milk selection to ripening and processed cheese: coagulation, curd handling, salting, ripening, yield and the major variety families.

Our 64 ICAR AICE-JRF/SRF questions in this subject: 2 easy, 43 medium, 19 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

Ultrafiltration of 1,200 kg of milk (3.3% protein) gives 240 kg of retentate. Assuming complete protein retention, what is the protein content of the retentate?

  1. 13.2%
  2. 0.66%
  3. 16.5%
  4. 19.8%
Answer and working

C. 16.5%

Concentration factor = 1200 ÷ 240 = 5; protein = 3.3 × 5 = 16.5%. 13.2% uses the permeate-to-retentate ratio (4); 0.66% divides by the factor; 19.8% counts permeate and retentate together as the multiplier.

Question 2 · hard

A processed-cheese batch uses 400 kg of natural cheese (38% moisture) and 10 kg of dry emulsifying salt. How much water must be added for a final moisture of 45%, assuming no evaporation?

  1. 59.1 kg
  2. 163.3 kg
  3. 28.0 kg
  4. 69.1 kg
Answer and working

A. 59.1 kg

Solids = 400 × 0.62 + 10 = 258 kg; final mass = 258 ÷ 0.55 = 469.1 kg; water = 469.1 − 400 − 10 = 59.1 kg. 69.1 kg forgets the salt already in the batch; 163.3 kg treats 45% as the solids content; 28.0 kg just multiplies the moisture difference by the cheese mass.

Question 3 · hard

A cheesemaker switches from calf chymosin to a more proteolytic microbial coagulant at the same clotting dose for long-ripened Cheddar. What is the most likely result?

  1. No effect, since the clotting dose was matched exactly
  2. Faster lactose fermentation by the coagulant and a sharp rise in acidity in the vat
  3. A large rise in yield because more casein stays in the curd
  4. A small fall in yield and more risk of bitterness during ripening
Answer and working

D. A small fall in yield and more risk of bitterness during ripening

More non-specific proteolysis releases more casein fragments into the whey and leaves more hydrophobic peptides in the cheese. Matching the clotting dose does not match the proteolytic activity; coagulants do not ferment lactose.

Question 4 · medium

After chymosin action, which kappa-casein fragment leaves with the whey?

  1. Caseinomacropeptide (residues 106–169)
  2. Gamma-1-casein fragment (residues 29–209)
  3. Para-kappa-casein (residues 1–105)
  4. Alpha-s1-I casein (residues 24–199)
Answer and working

A. Caseinomacropeptide (residues 106–169)

The hydrophilic C-terminal caseinomacropeptide is released into the serum; para-kappa-casein stays on the micelle. Gamma-caseins come from plasmin action on beta-casein; alpha-s1-I comes from chymosin action during ripening.

Question 5 · medium

Why is part of the whey replaced by water during Gouda making?

  1. To add calcium from the water so the curd fuses more firmly in the press
  2. To lower the fat content of the curd so that it meets the fat-in-dry-matter limit set by law
  3. To dilute the coagulant so that it stays active for longer in the curd
  4. To remove lactose so that less acid forms and the cheese keeps a higher pH
Answer and working

D. To remove lactose so that less acid forms and the cheese keeps a higher pH

Washing curd removes lactose, limiting lactic acid and giving the higher pH and elastic body of Gouda, Edam and Colby. It does not lower fat or add useful calcium.

Question 6 · medium

Why will Mozzarella curd not stretch if its pH is too high?

  1. Too much colloidal calcium phosphate has dissolved, so the curd turns to liquid
  2. Too much salt has been absorbed from the cooking water, firming the curd
  3. Too little calcium phosphate has dissolved, so the curd is not plastic
  4. The coagulant has been destroyed, so the protein network cannot form fibres
Answer and working

C. Too little calcium phosphate has dissolved, so the curd is not plastic

Stretching needs partial demineralisation, reached in a pH window of about 5.2–5.4 for cow-milk Mozzarella. Too low a pH gives sticky, soupy curd with fat loss.

Question 7 · hard

A Cheddar has low salt-in-moisture. Which ripening defect is most likely?

  1. Mould growth inside the cheese, because a low salt level draws oxygen into the paste
  2. Late blowing by clostridia, because salt has no role in spore control
  3. Bitter, acid, pasty cheese from excessive starter and coagulant activity
  4. Dry, crumbly, slow-ripening cheese with a pronounced salty taste
Answer and working

C. Bitter, acid, pasty cheese from excessive starter and coagulant activity

Low S/M permits too much starter acid and coagulant proteolysis, giving bitterness and pasty body. High S/M gives slow, dry, salty cheese.

Question 8 · hard

Why are exogenous proteinases added to milk a poor way to accelerate Cheddar ripening?

  1. Most is lost in whey; what stays risks bitterness and lower yield
  2. Proteinases are not legal in any country as food processing aids
  3. Proteinases ferment lactose and make the curd far too acid to press
  4. Proteinases are destroyed by salt, so they never reach the cheese interior
Answer and working

A. Most is lost in whey; what stays risks bitterness and lower yield

Enzyme added to milk mostly leaves with the whey, early proteolysis lowers yield and raises bitterness risk, and curd addition is hard to distribute evenly; encapsulation was developed to address this. Proteinases do not ferment lactose.

Question 9 · medium

Which group lists commonly used emulsifying salts for processed cheese?

  1. Sodium citrates and sodium mono-, di- and polyphosphates
  2. Sodium benzoate, potassium sorbate and nisin only
  3. Calcium chloride, calcium lactate and calcium carbonate salts
  4. Sodium nitrate, potassium nitrate and lysozyme
Answer and working

A. Sodium citrates and sodium mono-, di- and polyphosphates

Citrates and phosphates are the main emulsifying salts. Calcium salts would do the opposite; nitrates and lysozyme are anti-clostridial; sorbate and benzoate are preservatives.

Question 10 · medium

Slits and fractures in otherwise normal Cheddar are often associated with:

  1. Excessive emulsifying salt in the blend
  2. Propionic eyes from a Swiss-type starter culture
  3. Gas from heterofermentative non-starter lactic acid bacteria
  4. Too little moisture left in the curd at the time of hooping
Answer and working

C. Gas from heterofermentative non-starter lactic acid bacteria

Heterofermentative NSLAB produce CO2 that causes slits in Cheddar. Emulsifying salts are not used in natural Cheddar.

A study plan for Cheese Science & Technology in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (61% of the 64 questions): Ripening and accelerated ripening (10, 16%); Coagulants: calf rennet, microbial, fermentation-produced chymosin, plant (9, 14%); Milk quality and pre-treatment for cheese (7, 11%); Rennet coagulation and gel formation (7, 11%); Mechanised and UF-based cheese making (6, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Cheddaring, pasta filata stretching and other curd treatments (4, 6%); Processed cheese and cheese spreads: emulsifying salts (4, 6%); Cheese defects and grading (3, 5%); Cheese yield: formulas and factors (3, 5%); Cutting, cooking and syneresis (3, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Salting: dry, brine and its effect (3, 5%); Varieties: Cheddar, Gouda, Swiss types, Mozzarella, Parmesan, blue and soft cheeses (3, 5%); Fresh cheeses: cottage, cream cheese, quark, queso fresco, paneer (2, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Cheese yield: formulas and factors (2 hard of 3), Processed cheese and cheese spreads: emulsifying salts (2 hard of 4), Cheese defects and grading (1 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Mechanised and UF-based cheese making (1 easy of 6); Ripening and accelerated ripening (1 easy of 10).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Cheese Science & Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.