LAISHA
Open Laisha

GATE XL Evaporation, Dehydration & Concentration of Foods: practice questions

GATE — Life Sciences (XL), Section U Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
82written to this exam in this subject
13syllabus units

About GATE XL

GATE — Life Sciences (XL), Section U Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. Within XL, Section P Chemistry is understood to be compulsory and the candidate chooses two further sections, of which U Food Technology is one; this structure and the mark split are from earlier brochures and were not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Evaporation, Dehydration & Concentration of Foods in GATE XL

Same Section 3–4 content as XE-G. Questions tend to link drying to water activity, browning and microbial stability, as well as the standard moisture-basis and psychrometric calculations.

Removing water from liquid and solid foods: evaporator types and energy economy, drying theory and dryer design, spray, drum and freeze drying, concentration by freezing and membranes, and the quality changes that drying causes. Agricultural Engineering's post-harvest-cereals-pulses-oilseeds covers grain drying; this subject covers processed foods and powders.

Our 82 GATE XL questions in this subject: 21 easy, 50 medium, 11 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XL and are not shown on any other exam's page.

Question 1 · medium

Boiling-point elevation reduces the capacity of an evaporator because it

  1. increases the latent heat of the heating steam, so more steam must be condensed per hour
  2. reduces the useful temperature difference between steam and boiling liquid
  3. raises the heat transfer coefficient beyond the design value
  4. lowers the solids content of the concentrate leaving the unit
Answer and working

B. reduces the useful temperature difference between steam and boiling liquid

With Q = U A ΔT, a higher boiling point at the same steam temperature means a smaller ΔT and less heat transferred.

Question 2 · hard

A single-effect evaporator receives 5,000 kg/h of feed at 20 °C (cp = 3.9 kJ/kg K) and evaporates 4,000 kg/h of water. The liquid boils at 70 °C (latent heat 2,333 kJ/kg) and steam condenses with latent heat 2,230 kJ/kg. The steam needed is closest to

  1. 4,185 kg/h
  2. 4,000 kg/h
  3. 4,797 kg/h
  4. 4,622 kg/h
Answer and working

D. 4,622 kg/h

S = [F cp (T1 − TF) + V λv]/λs = (5,000 × 3.9 × 50 + 4,000 × 2,333)/2,230 = (975,000 + 9,332,000)/2,230 = 4,622 kg/h. 4,185 ignores feed heating; 4,000 kg/h assumes an economy of exactly 1; 4,797 heats the feed from 0 °C instead of 20 °C.

Question 3 · medium

The vapour leaving the last effect of a multiple-effect evaporator goes to

  1. the steam boiler as feed water
  2. a condenser kept under vacuum
  3. the first effect as heating steam
  4. the product as stripping gas
Answer and working

B. a condenser kept under vacuum

Last-effect vapour is too low in temperature to heat another effect, so it is condensed, which also maintains the vacuum.

Question 4 · easy

Thermal vapour recompression uses

  1. an electrically driven centrifugal compressor
  2. a steam-jet ejector driven by high-pressure motive steam
  3. a liquid-ring vacuum pump fitted on the barometric condenser
  4. a heat exchanger between feed and concentrate
Answer and working

B. a steam-jet ejector driven by high-pressure motive steam

TVR thermocompressors entrain low-pressure vapour with motive steam. An electric compressor is MVR; a vacuum pump and regenerative heat exchanger are other components.

Question 5 · medium

In a concurrent (parallel-flow) tunnel dryer,

  1. the driest product meets the hottest air, so final moisture is low but scorching is likely
  2. air and product move in opposite directions, so heat recovery is greatest
  3. air flows across the belt rather than along it, so all trays dry equally
  4. the wettest product meets the hottest air, so final moisture stays relatively high
Answer and working

D. the wettest product meets the hottest air, so final moisture stays relatively high

Concurrent flow gives rapid initial drying with evaporative cooling protecting the product, but the dry end meets cool, humid air. Countercurrent flow gives low final moisture and a scorching risk.

Question 6 · hard

If the product temperature during primary freeze drying rises above its collapse temperature,

  1. sublimation stops at once and the ice melts into a liquid that drips from the trays
  2. the product dries faster and gives a more porous, better-quality structure
  3. the condenser warms up and the vacuum is automatically restored
  4. the softened matrix flows, pores close and the product shrinks
Answer and working

D. the softened matrix flows, pores close and the product shrinks

Above collapse (near Tg′ or the eutectic), the freeze-concentrated phase becomes mobile, structure is lost and quality falls. Collapse does not improve porosity.

Question 7 · medium

Non-enzymatic browning of dried vegetables is often worst towards the end of hot-air drying because

  1. the product absorbs oxygen from the air only after it is completely dry
  2. browning needs liquid water above aw 0.99, which exists only at the end
  3. enzymes become active again at the end of drying
  4. aw passes through the fast-browning range while the product is hot
Answer and working

D. aw passes through the fast-browning range while the product is hot

Maillard browning peaks around aw 0.6–0.8; late in drying the product is in this range while hot.

Question 8 · hard

The selective diffusion theory explains aroma retention in spray-dried products by stating that

  1. a dried surface passes water far more readily than aroma molecules
  2. aroma molecules evaporate faster than water from the droplet throughout drying
  3. aromas are destroyed by heat and replaced by Maillard flavours
  4. aromas bind to the chamber walls and return to the powder later
Answer and working

A. a dried surface passes water far more readily than aroma molecules

As the droplet surface concentrates, diffusivity of larger aroma molecules falls far more than that of water, trapping aroma inside.

Question 9 · easy

Ice in a freeze dryer sublimes rather than melts during primary drying because the chamber is held below the triple point of water, which is at about:

  1. 611 Pa and 0.01 °C
  2. 101.3 kPa and 100 °C
  3. 22.1 MPa and 374 °C
  4. 12.3 kPa and 50 °C
Answer and working

A. 611 Pa and 0.01 °C

Below the triple point (611.7 Pa, 0.01 °C) liquid water cannot exist at equilibrium, so ice passes directly to vapour. 101.3 kPa and 100 °C is the normal boiling point. 22.1 MPa and 374 °C is the critical point. 12.3 kPa and 50 °C is a point on the liquid-vapour line.

Question 10 · medium

In mechanical vapour recompression, a compressor raises the pressure of the vapour leaving the evaporator so that it can:

  1. Be vented to atmosphere with less noise
  2. Condense in the calandria above the liquid's boiling point
  3. Be returned to the boiler as feed water
  4. Cool the product before it leaves the evaporator
Answer and working

B. Condense in the calandria above the liquid's boiling point

Compression raises the saturation temperature of the vapour above the boiling point of the liquor, so the vapour's latent heat can be reused for heating, giving very high equivalent steam economy. Venting wastes it. It is condensate, not vapour, that may be returned to a boiler. Compression adds heat, it does not cool the product.

A study plan for Evaporation, Dehydration & Concentration of Foods in GATE XL

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (54% of the 82 questions): Drying theory: constant-rate and falling-rate periods (11, 13%); Psychrometry, humidification and dehumidification (10, 12%); Evaporation: boiling-point elevation and heat transfer (8, 10%); Single- and multiple-effect evaporators; steam economy (8, 10%); Freeze drying: principles, cycle design and collapse temperature (7, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Spray drying: atomisation, powder properties and agglomeration (7, 9%); Freeze concentration and membrane concentration (5, 6%); Hot-air dryers: cabinet, tunnel, belt and fluidised-bed (5, 6%); Osmotic dehydration and intermediate-moisture foods (5, 6%); Quality changes in dried foods and rehydration (5, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Falling-film, forced-circulation and plate evaporators (4, 5%); Vapour recompression: thermal and mechanical (4, 5%); Drum drying (3, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Spray drying: atomisation, powder properties and agglomeration (2 hard of 7), Drying theory: constant-rate and falling-rate periods (3 hard of 11), Vapour recompression: thermal and mechanical (1 hard of 4).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Psychrometry, humidification and dehumidification (4 easy of 10); Quality changes in dried foods and rehydration (2 easy of 5).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XL Evaporation, Dehydration & Concentration of Foods

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.