LAISHA
Open Laisha

GATE XL Food Packaging Science & Technology: practice questions

GATE — Life Sciences (XL), Section U Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
33written to this exam in this subject
12syllabus units

About GATE XL

GATE — Life Sciences (XL), Section U Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. Within XL, Section P Chemistry is understood to be compulsory and the candidate chooses two further sections, of which U Food Technology is one; this structure and the mark split are from earlier brochures and were not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Food Packaging Science & Technology in GATE XL

Same Section 3–4 content as XE-G, often linked to microbiology (CO2 effects, C. botulinum in reduced-oxygen packs) and chemistry (oxidation, moisture gain).

Packaging as part of the preservation system: materials and their barrier properties, package design and testing, metal cans, glass, paper and plastics, aseptic, modified-atmosphere, active and intelligent packaging, migration and food-contact law, and packaging sustainability. Agricultural Engineering's storage-engineering-packaging covers bulk storage and an introduction to packaging materials; this subject is the full packaging course.

Our 33 GATE XL questions in this subject: 14 easy, 12 medium, 7 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XL and are not shown on any other exam's page.

Question 1 · easy

Packaging in direct contact with the food is called

  1. secondary packaging such as a shipping case
  2. tertiary packaging such as a wrapped pallet
  3. quaternary packaging such as a container
  4. primary packaging
Answer and working

D. primary packaging

Primary packaging touches the food and must meet food-contact law.

Question 2 · hard

Box compression strength of corrugated cases in a humid cold store

  1. rises because humidity strengthens the fibres and the starch glue
  2. is unchanged by humidity
  3. doubles after a week
  4. falls substantially as the board absorbs moisture
Answer and working

D. falls substantially as the board absorbs moisture

Paper loses stiffness as it absorbs moisture; creep under load also reduces strength over time.

Question 3 · easy

Tinplate is

  1. low-carbon steel coated with tin
  2. aluminium coated with chromium
  3. pure tin rolled into sheets
  4. steel coated with polyethylene only
Answer and working

A. low-carbon steel coated with tin

Electrolytic tin coating protects the steel; TFS uses chromium/chromium oxide.

Question 4 · medium

Black staining inside cans of fish and sweetcorn is due to

  1. iron oxide rust from external moisture after retorting
  2. migration of lacquer pigment
  3. sulphides of tin or iron from heated proteins
  4. excess nitrate in the brine
Answer and working

C. sulphides of tin or iron from heated proteins

Sulphur compounds released during heating react with the metal; sulphur-resistant lacquers prevent it.

Question 5 · medium

Tie layers are needed in coextrusion mainly to

  1. add colour to the outer layer
  2. sterilise the inner surface
  3. bond incompatible polymers such as PE and EVOH
  4. increase the oxygen permeability of the whole film structure
Answer and working

C. bond incompatible polymers such as PE and EVOH

Adhesive polymers join layers that would not otherwise adhere.

Question 6 · easy

A 25 µm film has an OTR of 1,600 cm³/m² day. A 50 µm film of the same material has an OTR of about

  1. 3,200 cm³/m² day
  2. 800 cm³/m² day
  3. 400 cm³/m² day
  4. 1,600 cm³/m² day
Answer and working

B. 800 cm³/m² day

OTR ∝ 1/thickness: 1,600 × 25/50 = 800. 3,200 doubles instead; 400 quarters it.

Question 7 · hard

A film with OTR 1,600 cm³/m² day is laminated to a barrier film with OTR 2 cm³/m² day. The laminate OTR is about

  1. 801 cm³/m² day
  2. 1,602 cm³/m² day
  3. 2.0 cm³/m² day
  4. 0.001 cm³/m² day
Answer and working

C. 2.0 cm³/m² day

Resistances add: 1/OTR = 1/1,600 + 1/2, so OTR = 2.0; the barrier layer dominates. 801 averages; 1,602 adds the OTRs.

Question 8 · medium

Ranked from best to worst oxygen barrier, which order is correct?

  1. LDPE > HDPE > PET > EVOH
  2. EVOH, dry > PET > HDPE > LDPE
  3. PET > LDPE > EVOH > HDPE
  4. HDPE > EVOH > LDPE > PET
Answer and working

B. EVOH, dry > PET > HDPE > LDPE

EVOH and PVDC lead; PET is moderate; polyolefins are poor, LDPE the poorest.

Question 9 · easy

The most widely used sterilant for aseptic carton packaging material is

  1. chlorine gas
  2. ethylene oxide
  3. formaldehyde
  4. hydrogen peroxide
Answer and working

D. hydrogen peroxide

H2O2, followed by hot sterile air to remove residues; residues in product are regulated.

Question 10 · medium

Bio-polyethylene made from sugarcane ethanol is

  1. biodegradable in home compost within weeks
  2. bio-based but not biodegradable
  3. fossil-based and biodegradable
  4. edible
Answer and working

B. bio-based but not biodegradable

It is chemically identical to fossil PE and behaves the same at end of life.

A study plan for Food Packaging Science & Technology in GATE XL

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (55% of the 33 questions): Barrier properties: water vapour and oxygen transmission rates (6, 18%); Laminates, coextrusion and coatings (4, 12%); Metal cans: tinplate, tin-free steel and aluminium; corrosion and lacquers (4, 12%); Modified-atmosphere and vacuum packaging (4, 12%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Plastics: polymer types, properties and processing (3, 9%); Active packaging: oxygen scavengers, moisture absorbers and antimicrobials (2, 6%); Aseptic packaging systems (2, 6%); Edible and biodegradable packaging (2, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Functions and levels of food packaging (2, 6%); Paper, paperboard and corrugated packaging (2, 6%); Glass containers (1, 3%); Migration and food-contact material regulation (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Barrier properties: water vapour and oxygen transmission rates (3 hard of 6), Modified-atmosphere and vacuum packaging (2 hard of 4), Paper, paperboard and corrugated packaging (1 hard of 2).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Functions and levels of food packaging (2 easy of 2); Glass containers (1 easy of 1).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XL Food Packaging Science & Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.