LAISHA
Open Laisha

GATE XL Fats & Oils Technology: practice questions

GATE — Life Sciences (XL), Section U Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
34written to this exam in this subject
13syllabus units

About GATE XL

GATE — Life Sciences (XL), Section U Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. Within XL, Section P Chemistry is understood to be compulsory and the candidate chooses two further sections, of which U Food Technology is one; this structure and the mark split are from earlier brochures and were not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Fats & Oils Technology in GATE XL

Same Section 3 content, with chemistry of fats: iodine and saponification values, polymorphism, interesterification and oxidation.

From oilseed to finished fat: mechanical expression and solvent extraction, refining, bleaching and deodorisation, fat modification by hydrogenation, interesterification and fractionation, and the fat products — margarine, shortening, vanaspati and specialty fats — made from them.

Our 34 GATE XL questions in this subject: 17 easy, 13 medium, 4 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XL and are not shown on any other exam's page.

Question 1 · medium

1,000 kg of seed with 40% oil is pressed to a cake with 8% oil. Using a balance on oil-free solids, how much oil is recovered?

  1. 348 kg
  2. 320 kg
  3. 400 kg
  4. 52 kg
Answer and working

A. 348 kg

Cake = 1,000 × 0.60/0.92 = 652 kg holding 52 kg oil; 400 − 52 = 348 kg. 320 kg wrongly takes 8% of the seed mass.

Question 2 · hard

The pungency of kachi ghani mustard oil comes from:

  1. Free fatty acids from lipase
  2. Allyl isothiocyanate
  3. Erucic acid released on pressing
  4. Sesamol formed by roasting
Answer and working

B. Allyl isothiocyanate

Glucosinolates are hydrolysed by myrosinase.

Question 3 · medium

How much sodium hydroxide (before excess) is needed per tonne of oil containing 1% free fatty acids as oleic acid?

  1. 0.40 kg
  2. 10 kg
  3. 1.42 kg
  4. 7.05 kg
Answer and working

C. 1.42 kg

10 kg FFA × 40/282 = 1.42 kg. 7.05 kg inverts the molecular weight ratio.

Question 4 · medium

Winterisation of sunflower oil removes:

  1. Waxes
  2. Phospholipids
  3. Free fatty acids
  4. Chlorophyll
Answer and working

A. Waxes

So the oil stays clear in the cold.

Question 5 · easy

Palm olein is used mainly as:

  1. Biodiesel feedstock only
  2. Cocoa butter equivalent
  3. Cooking and frying oil
  4. Hard stock for margarine
Answer and working

C. Cooking and frying oil

Stearin is the hard fraction.

Question 6 · easy

Under the Codex fat spreads standard, margarine contains at least:

  1. 95% fat
  2. 60% fat
  3. 40% fat
  4. 80% fat
Answer and working

D. 80% fat

Reduced-fat spreads contain less.

Question 7 · easy

Coconut oil has a saponification value near 250 mg KOH/g, far above most seed oils, because:

  1. It is highly unsaturated, like sunflower oil
  2. It contains much free fatty acid after pressing
  3. It is rich in phospholipids from the copra
  4. Its fatty acids are short and medium chain
Answer and working

D. Its fatty acids are short and medium chain

Saponification value is inversely related to mean molar mass; lauric (C12) and myristic (C14) acids give more ester groups per gram, so more KOH is needed. Unsaturation is measured by iodine value, and coconut oil is in fact highly saturated. Free fatty acid raises acid value, not saponification value much. Coconut oil has few phospholipids.

Question 8 · easy

Water degumming of crude soybean oil removes:

  1. Hydratable phospholipids, as lecithin
  2. Free fatty acids, as soapstock
  3. Colour pigments, by adsorption
  4. Waxes, by crystallisation in the cold
Answer and working

A. Hydratable phospholipids, as lecithin

Hydratable phosphatides swell with water and separate as gums, which are dried to make lecithin. Free fatty acids are removed by alkali neutralisation or steam stripping. Pigments are removed by bleaching earth. Waxes are removed by winterisation or dewaxing.

Question 9 · medium

Tripalmitin has a molar mass of 807.3 g/mol. Its theoretical saponification value (KOH = 56.1 g/mol) is:

  1. 69.5 mg KOH/g
  2. 208.5 mg KOH/g
  3. 139.0 mg KOH/g
  4. 625.4 mg KOH/g
Answer and working

B. 208.5 mg KOH/g

Each triacylglycerol consumes three KOH: 3 × 56.1 × 1000 / 807.3 = 208.5 mg KOH/g. 69.5 assumes one KOH per molecule. 139.0 assumes two. 625.4 multiplies by three a second time.

Question 10 · easy

Under FSSAI rules, as in several European countries, frying oil must be discarded once its total polar compounds exceed:

  1. 5%
  2. 25%
  3. 50%
  4. 75%
Answer and working

B. 25%

FSSAI set a limit of 25% total polar compounds for reused frying oil; many European countries use limits of 24 to 27%. 5% is typical of fresh oil. 50% and 75% would be grossly abused oils.

A study plan for Fats & Oils Technology in GATE XL

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (56% of the 34 questions): Oil quality tests: acid value, peroxide value, iodine value and saponification value (6, 18%); Neutralisation, bleaching and deodorisation; physical refining (4, 12%); Hydrogenation and trans fatty acids (3, 9%); Interesterification: chemical and enzymatic (3, 9%); Margarine, shortening and vanaspati (3, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Sources and composition of edible oils and fats (3, 9%); Degumming and lecithin recovery (2, 6%); Fractionation (2, 6%); Frying oil deterioration and management (2, 6%); Mechanical expression and expellers (2, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Solvent extraction and desolventising (2, 6%); By-products of oil refining (1, 3%); Specialty fats and cocoa butter equivalents (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Mechanical expression and expellers (1 hard of 2), Oil quality tests: acid value, peroxide value, iodine value and saponification value (2 hard of 6), Neutralisation, bleaching and deodorisation; physical refining (1 hard of 4).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Degumming and lecithin recovery (2 easy of 2); Fractionation (2 easy of 2).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XL Fats & Oils Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.