ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency
Original practice questions written to the published syllabus · not past papersICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Unit II names thermobacteriology, pasteurisation and sterilisation; Unit III names canning, packaging and containers. Questions are MCQs at definition and short-calculation level: 12D and F0, commercial sterility, acid classes, types of spoilage (flat sour, TA, sulphide), double-seam parts and faults, retort types and aseptic processing.
Designing and validating heat processes that make food safe and shelf-stable: microbial death kinetics, heat penetration, process calculation by the general and formula methods, retorts and aseptic systems, and the regulatory framework for low-acid canned foods. Agricultural Engineering's food-dairy-engineering introduces D, z and F; this subject teaches the full process-establishment practice.
Our 46 ICAR AIEEA-PG / PGS questions in this subject: 22 easy, 23 medium, 1 hard, across 13 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.
Under the United States definition widely used in trade, a low-acid food is one with
C. equilibrium pH above 4.6 and water activity above 0.85
21 CFR 113 defines low-acid foods as those with finished equilibrium pH greater than 4.6 and water activity greater than 0.85 (alcoholic beverages excluded). Initial brine pH is not the criterion; 0.95 and 5.6 are not the regulatory values.
Swollen cans from one production lot yield a mixed flora of cocci, short rods and some spore-formers. The most likely cause is
A. post-process leakage through seams
Cocci and other non-spore-formers cannot survive a retort process, so their presence points to contamination after processing, usually through faulty seams. Underprocessing typically leaves a pure culture of spore-formers; thermophilic spoilage gives thermophilic spore-formers; pre-process spoilage shows growth without viable organisms. Leakage typically happens during cooling.
A can with both ends bulged that can be pushed in by thumb pressure but return when released is described as a
C. soft swell
A soft swell has both ends bulged but yielding to pressure. A flipper looks normal until struck; a springer has one end bulged that can be pushed in, making the other bulge; a hard swell cannot be pushed in at all.
During visual seam inspection an operator finds a seam where the cover hook and body hook are not interlocked at one point. This fault is called a
C. false seam
A false seam is a section where the hooks do not interlock, a serious leak risk. A cut-over is metal fractured over the chuck; a deadhead is an incompletely rolled seam where the chuck slipped; a vee is a projection of metal at the bottom of the seam, often at the side seam.
Venting a steam retort at the start of the cycle is essential because
D. air left in the retort creates cooler zones where cans are underprocessed
A steam-air mixture is cooler than pure steam at the same pressure, and air pockets insulate containers, so air must be vented. Steam is the heating medium; venting does not raise pressure; bleeders and drains handle condensate.
Glass jars and retort pouches are usually processed in water-immersion, water-spray or steam-air retorts rather than pure saturated steam because these retorts
A. allow an overriding air pressure independent of temperature to protect the package
Overpressure keeps lids and seals in place against the internal pressure of the hot contents. These retorts work at sterilising temperatures above 100 °C, still need temperature control, and heat by conventional means.
The aluminium foil layer in a retort pouch laminate mainly provides
A. a barrier to oxygen, light and moisture
Foil gives an almost complete barrier to gases, light and moisture, which gives long shelf life. Sealing is by the polypropylene inner layer; printing is usually on or under the polyester outer layer.
The cook value C is usually expressed with
D. reference 100 °C and z = 33 °C
The cook value uses a quality z (commonly 33 °C) at 100 °C. 121.1 °C with z = 10 °C defines F₀; the others are not standard cook-value conventions.
A process authority, in low-acid canning regulation, is
B. an expert person or body in thermal processing who establishes the scheduled processes
Process authorities have the expertise and facilities to design heat penetration and distribution studies and set scheduled processes. Inspectors, controllers and retailers have other roles.
The international Codex text that sets hygiene requirements for low-acid canned foods is the
D. Code of Hygienic Practice for Low-Acid and Acidified Low-Acid Canned Foods
The Code of Hygienic Practice for Low-Acid and Acidified Low-Acid Canned Foods covers scheduled processes, retort operation, containers and records. The other Codex texts cover labelling, aflatoxin and additives.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.