ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papersICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Unit VI MCQs cover processing and dairy operations at definition level: HTST and LTLT conditions, the phosphatase test, regeneration, types of heat exchangers, evaporators and driers, homogenisation purpose, membrane classes, freezing methods and CIP sequence, with short direct calculations.
Unit operations of food and milk plants: balances, fluid flow, heat exchange, thermal processing, evaporation, separation, freezing and hygienic design.
Our 43 ICAR AIEEA-PG questions in this subject: 33 easy, 10 medium, 0 hard, across 13 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
The classical minimum time–temperature combination for HTST pasteurisation of milk is
D. 72 °C for 15 s
HTST is 72 °C for 15 s and LTLT 63 °C for 30 min (Codex and most national codes; local law may add margins). 135 °C for seconds is UHT.
A negative alkaline phosphatase test on pasteurised milk indicates that
B. The milk has received at least the minimum pasteurisation treatment
Alkaline phosphatase is slightly more heat resistant than the target pathogens, so its inactivation shows adequate pasteurisation. It does not show sterility; over-heating is shown by a negative lactoperoxidase test.
In a can of a conduction-heating solid food, the slowest heating point is
B. At the geometric centre
Conduction heating is symmetrical, so the centre heats slowest. In convection-heating liquids the cold point is lower on the axis.
5000 kg/h of milk at 12 % total solids is concentrated to 45 % TS. The water evaporated is
B. 3667 kg/h
Product = 5000 × 12/45 = 1333 kg/h; water = 5000 − 1333 = 3667 kg/h. Subtracting percentages gives 1650 kg/h; 1333 kg/h is the concentrate. 4400 kg/h removes all the water in the feed (5000 × 0.88).
Whey (10,000 kg/h, 6 % TS) is concentrated to 50 % TS. The water to be evaporated is
B. 8800 kg/h
Product = 10,000 × 6/50 = 1200 kg/h; water = 8800 kg/h. 4400 kg/h results from subtracting percentages; 1200 kg/h is the concentrate. 9400 kg/h removes all the water in the feed (10,000 × 0.94).
The main purpose of homogenising market milk is to
A. Reduce fat globule size so that a cream layer does not form
Smaller globules rise far more slowly (Stokes' law), preventing creaming during shelf life. Homogenisation does not kill organisms or change fat content.
Milk is usually separated warm rather than cold because warming
C. Lowers skim-phase viscosity, raising the separation velocity
Stokes' law has viscosity in the denominator; warm skim milk is much less viscous, so globules move faster in the centrifugal field.
In constant-pressure cake filtration with negligible medium resistance, 1 m³ of filtrate is collected in 10 min. The time to collect 3 m³ is
C. 90 min
Time is proportional to V² when medium resistance is negligible: 10 × 3² = 90 min. Linear scaling gives 30 min. 270 min uses V³; 17.3 min inverts the relation (t ∝ √V).
Individually quick frozen (IQF) peas are usually produced in a
D. Fluidised-bed freezer
Upward cold air suspends small particles so each freezes separately and fast. Plate freezers suit flat blocks; scraped-surface freezers are for ice-cream mix.
Which feature is contrary to hygienic design of food-contact pipework?
C. A long dead-leg branch where product stagnates
Dead legs are not reached by CIP flow and harbour micro-organisms. The other features are recommended by EHEDG, 3-A and ISO 14159 principles.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.