ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papersICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Short MCQs across the whole subject: aquifer definitions, S and Sy ranges, Darcy validity, well-screen and gravel-pack rules, drilling methods, resistivity arrays, pump classification, NPSH, and simple power or specific-speed calculations.
Aquifers, well hydraulics, well design and the pumps that lift the water — asked in some form in every GATE AG paper.
Our 70 ICAR AIEEA-PG questions in this subject: 21 easy, 38 medium, 11 hard, across 16 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
In Darcy's law, the hydraulic conductivity K has the dimensions of:
A. Velocity (L T⁻¹)
q = K i, and the gradient i is dimensionless, so K has the same dimensions as the Darcy flux — a velocity such as m/day. Intrinsic permeability k, not K, has dimensions of area.
In an unconfined aquifer (K = 30 m/day), steady saturated thicknesses measured from the impermeable base are 22 m at 20 m from a pumped well and 24 m at 80 m. The discharge is:
B. 6,255 m³/day
Dupuit: Q = πK(h₂² − h₁²)/ln(r₂/r₁) = π × 30 × (576 − 484)/ln 4 = π × 30 × 92/1.3863 = 6,255 m³/day. Squaring the difference (2² = 4) gives 272; using 2π doubles the answer; log₁₀ inflates it by 2.303.
The uniformity coefficient of a sand is defined as:
C. D₆₀ / D₁₀
Cu = D₆₀/D₁₀, where D₆₀ and D₁₀ are the sizes than which 60% and 10% of the sample by weight is finer. D₁₀ is the effective size.
The drilling method most commonly used for water boreholes in hard crystalline rock such as granite is:
C. Air rotary with a down-the-hole (DTH) hammer
The DTH hammer delivers percussive blows at the bit, driven by compressed air, which also lifts cuttings; it is fast in hard rock. Jetting and augering only work in soft sediments.
Which of the following is NOT a function of drilling fluid in direct rotary drilling?
D. Raising aquifer permeability
Drilling fluid cools the bit, carries cuttings, supports the wall and suspends cuttings. Its filter cake actually reduces permeability near the hole, which is why development is needed.
A centrifugal impeller of 300 mm outer diameter runs at 1,450 rpm. The whirl component of absolute velocity at outlet is 18 m/s and flow enters radially. The Euler (theoretical) head is:
B. 41.8 m
u₂ = πDN/60 = π × 0.3 × 1450/60 = 22.78 m/s. With radial entry H = u₂V_w2/g = 22.78 × 18/9.81 = 41.8 m. Forgetting g, dividing by 2g (or using the radius, which gives the same halving), or using u₂²/g (which assumes V_w2 = u₂) are the common errors.
A pump with a very high specific speed is typically:
C. An axial-flow (propeller) pump for high flow at low head
High N_s corresponds to high flow and low head per stage — axial flow. Radial impellers have low N_s.
A solar pump must deliver 50 m³ per day against a total head of 30 m. The daily hydraulic energy is about:
A. 4.08 kWh
E = ρgVH = 1000 × 9.81 × 50 × 30 J = 14.7 MJ = 14.7/3.6 = 4.08 kWh (equivalently V·H/367). Forgetting to divide by 3600 s/h gives 14.7; omitting g gives 0.42; 40.8 is a tenfold decimal slip.
The main function of the maximum power point tracking (MPPT) controller in a solar pump is to:
D. Continuously adjust voltage and current to draw maximum available power from the array
The PV I–V curve has one maximum power point that shifts with irradiance and temperature; MPPT adjusts the load (pump speed) to stay on it. Mechanical sun-tracking is a separate option.
Most solar irrigation pumping systems store energy as:
C. Water in a tank or reservoir rather than electricity in batteries
A tank is cheaper and longer-lived than batteries, and crops need a daily volume; so systems are designed for daily volume, not constant flow.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.