LAISHA
Open Laisha

ICAR AICE-JRF/SRF Groundwater, Wells & Pumps: practice questions

ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
25written to this exam in this subject
12syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. LAN-based computer test, 2 hours, 120 MCQs: 20 Part A (general knowledge and reasoning), 50 Part B (core group), 50 Part C (specialisation); four options.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Groundwater, Wells & Pumps in ICAR AICE-JRF/SRF

PG-depth concepts: leaky and unconfined (delayed-yield) aquifer responses, image-well theory, step-drawdown analysis and well efficiency, equivalence in resistivity sounding, recharge estimation methods and their assumptions, managed aquifer recharge, and groundwater assessment frameworks.

Aquifers, well hydraulics, well design and the pumps that lift the water — asked in some form in every GATE AG paper.

Our 25 ICAR AICE-JRF/SRF questions in this subject: 3 easy, 11 medium, 11 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

The same sand column is tested with water at 10 °C and then at 30 °C. Compared with the first test, the second test gives:

  1. Lower hydraulic conductivity, same intrinsic permeability
  2. Same hydraulic conductivity, higher intrinsic permeability
  3. Higher hydraulic conductivity and higher intrinsic permeability
  4. Higher hydraulic conductivity, same intrinsic permeability
Answer and working

D. Higher hydraulic conductivity, same intrinsic permeability

K = kρg/μ. Warm water has lower viscosity, so K rises; k depends only on pore geometry and is unchanged.

Question 2 · hard

A long pumping test in an unconfined sand aquifer gives a log-log time-drawdown plot that rises, flattens for a period, then rises again. The most appropriate interpretation is:

  1. Delayed yield from gravity drainage; use a Neuman-type solution, with Sy from late data
  2. A recharge boundary reached mid-test; take T from the flat part and ignore the late rise
  3. A barrier boundary; the second rise gives double the transmissivity of the first segment
  4. Well-bore storage only; ignore all but the early data and fit a Theis curve to it
Answer and working

A. Delayed yield from gravity drainage; use a Neuman-type solution, with Sy from late data

The S-shaped curve is the signature of delayed yield: early elastic release, a flat segment while pores begin draining, then late Theis-like behaviour with storativity equal to Sy. A recharge boundary would flatten permanently, not rise again.

Question 3 · medium

In a leaky confined aquifer pumped at constant rate, the drawdown curve eventually flattens because:

  1. Aquitard leakage increasingly balances pumping
  2. Specific yield of the aquifer increases with time as the pores drain more slowly
  3. The well function W(u) becomes negative once u exceeds about 0.01
  4. Transmissivity decreases as head falls, choking flow toward the well
Answer and working

A. Aquitard leakage increasingly balances pumping

Hantush-Jacob theory: head decline induces vertical leakage through the aquitard (controlled by B = √(Tb′/K′)), which can supply all the pumping and give steady state. The flattening can be mistaken for a recharge boundary.

Question 4 · hard

A well is to be completed in a fine, very uniform sand (Cu ≈ 1.5). The most appropriate design approach is:

  1. Use a naturally developed well with a slot size passing 90% of the formation to maximise open area
  2. Leave the hole open without a screen
  3. Install an artificial pack of uniform, rounded siliceous grains, with slots retaining most of the pack
  4. Use a slotted pipe with slots larger than the median aquifer grain so fines wash out freely during development
Answer and working

C. Install an artificial pack of uniform, rounded siliceous grains, with slots retaining most of the pack

Fine uniform sands cannot form a natural graded filter because there is no coarse fraction to retain. An artificial pack, graded by pack-aquifer ratio, with slot retaining most of the pack, stabilises the formation.

Question 5 · medium

Annual rainfall is 800 mm with chloride 2 mg/L (including dry deposition). Groundwater chloride is 40 mg/L and there are no other chloride sources. By chloride mass balance the recharge is:

  1. 16,000 mm/year
  2. 20 mm/year
  3. 40 mm/year
  4. 400 mm/year
Answer and working

C. 40 mm/year

R = P × Cl_p/Cl_gw = 800 × 2/40 = 40 mm/year. Inverting the ratio gives 16,000 mm; the method fails if fertiliser, irrigation water or evaporites add chloride. 400 mm/year is a factor-of-ten slip.

Question 6 · hard

A well pump works against a system with a large static lift and little friction. If its speed is reduced by 20% with a variable-frequency drive, the flow will:

  1. Fall by exactly 20%, as the affinity laws predict for any system
  2. Fall by far more than 20%, and may stop if shutoff head drops below the static lift
  3. Fall by about 49% because Q ∝ N³
  4. Remain unchanged, because the static lift is constant and dominates the whole system curve
Answer and working

B. Fall by far more than 20%, and may stop if shutoff head drops below the static lift

Affinity laws scale the pump curve (head ∝ N², so shutoff head falls 36%), but the operating point is where the scaled curve meets the flat, high system curve, so flow drops disproportionately. Q ∝ N applies only when the system curve passes through the origin.

Question 7 · medium

A well pumps a confined aquifer 150 m from a fully penetrating stream that acts as a constant-head boundary. In image-well analysis, the boundary is replaced by:

  1. A pumping image well 300 m away, across the stream
  2. A pumping image well 150 m away, on the stream line
  3. An injection image well 150 m away, on the stream line
  4. An injection image well 300 m away, across the stream
Answer and working

D. An injection image well 300 m away, across the stream

A recharge boundary is modelled by an image well of opposite sign, recharging at the same rate, placed at the mirror point: 150 m beyond the stream, so 300 m from the real well. A pumping image well represents an impermeable barrier boundary. Placing the image on the stream line gives the wrong distance and would not hold zero drawdown along the boundary.

Question 8 · easy

In a Wenner resistivity sounding with electrode spacing a = 10 m, the measured resistance V/I is 5 Ω. The apparent resistivity is:

  1. 50 Ω·m
  2. 157 Ω·m
  3. 100 Ω·m
  4. 314 Ω·m
Answer and working

D. 314 Ω·m

For the Wenner array ρa = 2πaR = 2π × 10 × 5 = 314 Ω·m. 50 Ω·m is aR. 157 Ω·m uses πaR. 100 Ω·m is 2aR without π. The geometric factor 2πa is specific to equal electrode spacing.

Question 9 · easy

A centrifugal pump gives 20 m head at 1450 rpm. If the engine drive drops the speed to 1160 rpm, the head at the corresponding duty point becomes:

  1. 16.0 m
  2. 12.8 m
  3. 10.2 m
  4. 20.0 m
Answer and working

B. 12.8 m

Head scales with speed squared: 20 × (1160/1450)² = 20 × 0.64 = 12.8 m. 16.0 m scales head linearly, which is the rule for discharge. 10.2 m uses the cube, which is the rule for power. 20.0 m ignores the speed change.

Question 10 · medium

A pump lifts water at 30 °C (vapour pressure head 0.43 m) from a sump 4.5 m below its eye, with 0.8 m of suction friction. With atmospheric head 10.1 m, the available NPSH is:

  1. 4.37 m
  2. 5.17 m
  3. 4.80 m
  4. 14.97 m
Answer and working

A. 4.37 m

NPSHa = 10.1 − 4.5 − 0.8 − 0.43 = 4.37 m. 5.17 m leaves out the friction loss. 4.80 m leaves out the vapour pressure. 14.97 m adds the suction lift as if the water were above the pump. If the pump's required NPSH exceeds 4.37 m, it will cavitate.

A study plan for Groundwater, Wells & Pumps in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (48% of the 25 questions): Unsteady flow: Theis and Cooper-Jacob (4, 16%); Recharge estimation and artificial recharge (3, 12%); Specific speed and affinity laws (3, 12%); Aquifer types and properties: T, S and Sy (2, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Groundwater exploration: resistivity (2, 8%); NPSH and cavitation (2, 8%); Pumping tests (2, 8%); Well design: screen and gravel pack (2, 8%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Well interference (2, 8%); Darcy's law in aquifers (1, 4%); Solar pumping (1, 4%); Steady flow to wells: Thiem and Dupuit (1, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Well design: screen and gravel pack (2 hard of 2), Solar pumping (1 hard of 1), Unsteady flow: Theis and Cooper-Jacob (2 hard of 4).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Groundwater exploration: resistivity (1 easy of 2); Recharge estimation and artificial recharge (1 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Groundwater, Wells & Pumps

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.