LAISHA
Open Laisha

GATE Food & Dairy Engineering: practice questions

GATE — Agricultural Engineering (AG) · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
44written to this exam in this subject
12syllabus units

About GATE

GATE — Agricultural Engineering (AG) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 technical: 25 one-mark and 30 two-mark questions). MCQ, MSQ and NAT; negative marking on MCQ only (−1/3 for one-mark, −2/3 for two-mark); no partial credit on MSQ. On-screen virtual calculator.

Source: gate2027.iitm.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Food & Dairy Engineering in GATE

Section 7 (Dairy and Food Engineering) averages about 9 technical marks, mostly numerical. Thermal processing (D, z, F, log reductions, spoilage probability) has appeared in every paper counted from 2019 to 2026, and heat-exchanger LMTD or effectiveness in nearly every paper. Evaporator mass balance and steam economy, rheology (power-law), centrifuge and cream separator balances and Plank's freezing time recur, the last two partly under Section 6. Expect numerical-answer questions where the traps are units (per hour against per second), wet against dry basis and the sign of the lethal-rate exponent.

Unit operations of food and milk plants: balances, fluid flow, heat exchange, thermal processing, evaporation, separation, freezing and hygienic design.

Our 44 GATE questions in this subject: 2 easy, 31 medium, 11 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE and are not shown on any other exam's page.

Question 1 · medium

Whole milk (4.5 % fat) is blended with skim milk (0.05 % fat) to make 1000 kg of standardised milk at 3.0 % fat. The mass of whole milk required is closest to

  1. 663 kg
  2. 667 kg
  3. 656 kg
  4. 337 kg
Answer and working

A. 663 kg

Fat balance with total balance: m_whole = 1000 × (3.0 − 0.05)/(4.5 − 0.05) = 1000 × 2.95/4.45 = 662.9 kg. Ignoring the skim fat gives 1000 × 3/4.5 = 667 kg; 337 kg is the skim, not the whole milk. 656 kg subtracts the skim fat only in the numerator (1000 × 2.95/4.5).

Question 2 · medium

1000 kg of whole milk at 4.0 % fat is separated into cream at 40 % fat and skim milk at 0.05 % fat. The mass of cream is

  1. 98.9 kg
  2. 111.1 kg
  3. 901.1 kg
  4. 100.0 kg
Answer and working

A. 98.9 kg

Fat balance: 1000 × 0.04 = 0.40 C + 0.0005 (1000 − C), so C = 1000 × (4.0 − 0.05)/(40 − 0.05) = 98.9 kg. Assuming zero fat in skim gives 100 kg; 901.1 kg is the skim. 111.1 kg divides by 40 − 4 instead of 40 − 0.05 (1000 × 4/36).

Question 3 · medium

In a milk-to-milk regenerator the two heat-capacity rates are equal. If NTU = 4 in counter-current flow, the effectiveness is

  1. 0.50
  2. 0.98
  3. 0.20
  4. 0.80
Answer and working

D. 0.80

For counter-current flow with C_r = 1, ε = NTU/(1 + NTU) = 4/5 = 0.80. 0.98 is 1 − e^(−4), valid only when C_r = 0 (condensing or boiling on one side). 0.50 is the co-current value, (1 − e^(−8))/2; 0.20 is 1/(1 + NTU), the ineffectiveness.

Question 4 · hard

Cans contain 1000 spores each of a spoilage organism with D₁₂₁.₁ = 1.0 min. After a process of F₀ = 6 min, the expected number of spoiled cans in a batch of 50,000 is

  1. 500
  2. 5
  3. 0.05
  4. 50
Answer and working

D. 50

N = N₀ × 10^(−F/D) = 10³ × 10⁻⁶ = 10⁻³ survivors per can, i.e. one spoiled can per thousand; 50,000 × 10⁻³ = 50. 0.05 forgets the initial 1000 spores (10^−6 per can x 50,000); 500 and 5 miscount the log reductions by two either way (10^−2 and 10^−4 per can).

Question 5 · medium

A first-order death rate constant k = 0.0921 s⁻¹ corresponds to a D value of

  1. 25 s
  2. 10.9 s
  3. 2.5 s
  4. 0.0921 s
Answer and working

A. 25 s

D = 2.303/k = 2.303/0.0921 = 25.0 s. 1/k = 10.9 s is the time for a 1/e reduction, not a decimal reduction. 2.5 s uses 0.2303 instead of 2.303.

Question 6 · medium

Milk at 75 °C is heated to 140 °C by direct steam injection. If steam gives up 2200 kJ/kg and milk cp = 3.9 kJ/kg K, the steam condensed per kg of milk is about

  1. 0.248 kg
  2. 0.115 kg
  3. 1.15 kg
  4. 0.124 kg
Answer and working

B. 0.115 kg

m_s = cp ΔT/λ = 3.9 × 65/2200 = 0.115 kg/kg, about 10 % dilution, removed later by flash cooling. Using a 140 K rise (from 0 °C) instead of 65 K gives 0.248 kg. 1.15 kg is a factor-of-ten slip; 0.124 kg uses water's cp of 4.18 instead of milk's 3.9.

Question 7 · hard

A spray drier evaporates 502.6 kg/h of water. The air enters at 0.010 and leaves at 0.060 kg water per kg dry air. The dry-air flow required is about

  1. 8,380 kg/h
  2. 1,005 kg/h
  3. 50,260 kg/h
  4. 10,050 kg/h
Answer and working

D. 10,050 kg/h

Dry air = water/(H_out − H_in) = 502.6/0.050 = 10,052 kg/h. Dividing by 0.060 alone gives 8380 kg/h; dividing by 0.010 gives 50,260 kg/h. 1,005 kg/h divides by 0.5 instead of 0.050.

Question 8 · medium

By Stokes' law, reducing the mean fat globule diameter from 3 µm to 0.75 µm reduces the creaming velocity by a factor of

  1. 64
  2. 4
  3. 256
  4. 16
Answer and working

D. 16

v ∝ d²; (3/0.75)² = 4² = 16. Proportionality to d gives 4; to d³ gives 64 and to d⁴ gives 256.

Question 9 · hard

A fat globule rises at 0.64 µm/s under gravity. In a bowl giving 8000 g, the Stokes-law velocity is about

  1. 5.1 mm/s
  2. 0.64 µm/s
  3. 0.51 mm/s
  4. 51 mm/s
Answer and working

A. 5.1 mm/s

v scales with the acceleration: 0.64 × 10⁻⁶ × 8000 = 5.1 × 10⁻³ m/s = 5.1 mm/s. 0.64 µm/s ignores the centrifugal field; 0.51 mm/s and 51 mm/s are factor-of-ten slips.

Question 10 · medium

The van 't Hoff osmotic pressure of a 0.1 mol/L non-electrolyte solution at 25 °C is about

  1. 2.48 kPa
  2. 496 kPa
  3. 24.8 kPa
  4. 248 kPa
Answer and working

D. 248 kPa

π = C R T = 100 mol/m³ × 8.314 × 298.15 = 247,900 Pa = 248 kPa. Using 0.1 mol/L without converting to mol/m³ gives 248 Pa (0.248 kPa), so 2.48 and 24.8 kPa are decimal slips; 496 kPa assumes i = 2, which applies to a salt such as NaCl.

A study plan for Food & Dairy Engineering in GATE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (48% of the 44 questions): Thermal processing kinetics: D, z and F values (8, 18%); Freezing and Plank's equation (5, 11%); Evaporation: single and multiple effect (4, 9%); Fluid flow in food plants: pumps, pipes and rheology (4, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Heat exchangers: plate, tubular and scraped-surface (4, 9%); Material and energy balances (4, 9%); Centrifugation and cream separation (3, 7%); Filtration and membrane processes: MF, UF, NF and RO (3, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Spray and drum drying (3, 7%); Homogenisation (2, 5%); Pasteurisation: HTST and LTLT (2, 5%); UHT processing and sterilisation (2, 5%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: UHT processing and sterilisation (1 hard of 2), Freezing and Plank's equation (2 hard of 5), Thermal processing kinetics: D, z and F values (3 hard of 8).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Evaporation: single and multiple effect (1 easy of 4); Thermal processing kinetics: D, z and F values (1 easy of 8).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE Food & Dairy Engineering

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.