Irrigation Association Certified Agricultural Irrigation Specialist (CAIS) · USA · Irrigation Association
Original practice questions written to the published syllabus · not past papersIrrigation Association Certified Agricultural Irrigation Specialist (CAIS) is a professional certification run by Irrigation Association, for candidates in USA. 100 MCQs, 3 hours.
Source: irrigation.org.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Designing and evaluating sprinkler and drip systems, from emitter hydraulics to pump selection.
Our 37 Irrigation Association Certified Agricultural Irrigation Specialist questions in this subject: 3 easy, 24 medium, 10 hard, across 14 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Irrigation Association Certified Agricultural Irrigation Specialist and are not shown on any other exam's page.
A sprinkler lateral is laid down a uniform gentle slope from its inlet. Compared with the same lateral on level ground, what does the slope do?
C. Elevation gain offsets friction, so a longer lateral or smaller pipe can meet the same pressure limit
Going downhill, each metre of fall adds pressure that offsets friction loss; on gentle slopes the profile flattens and the allowable length grows. On steep slopes the gain can exceed friction and the end pressure rises, which again needs checking.
What distinguishes an in-line emitter from an on-line emitter?
A. In-line emitters are built into the tubing during manufacture; on-line emitters are punched into it later
The distinction is physical: in-line emitters are inserted or formed inside the tube at the factory at fixed spacing (as in dripline and tape); on-line emitters are inserted into punched holes in the field at chosen spacings. Either type can be pressure-compensating.
Ten new emitters tested at the same pressure give (L/h): 3.9, 4.1, 4.0, 3.8, 4.2, 4.0, 4.1, 3.9, 4.3, 3.7. What is the manufacturing coefficient of variation (sample standard deviation), and how does ASABE EP405 class it for point-source emitters?
B. 0.046; good
Mean = 4.00 L/h; sample s = 0.1826 L/h; Cv = s/mean = 0.046. Below 0.05 is 'good' in EP405. 0.183 is the standard deviation without dividing by the mean; 0.15 is the range over the mean.
Under ASABE EP405, a point-source emitter with a manufacturing coefficient of variation of 0.06 is classed as:
A. Average
EP405 classes for point-source emitters: below 0.05 good, 0.05–0.07 average, 0.07–0.11 marginal, 0.11–0.15 poor, above 0.15 unacceptable.
Which emitter type is most sensitive to water temperature, and why?
B. Long-path laminar emitters, because discharge depends on viscosity, which falls as temperature rises
In laminar flow, head loss depends directly on viscosity; water viscosity falls markedly as it warms, so discharge rises. Turbulent flow is nearly independent of viscosity, and water density changes very little over field temperatures.
Bralts' statistical uniformity is Us = 100 (1 − Vq). If the measured emitter flows have a coefficient of variation of 0.12, Us equals:
C. 88 %
Us = 100 × (1 − 0.12) = 88 %. 12 % confuses the variation with the uniformity; 85 % applies a 1.27 multiplier that belongs to the Keller–Karmeli formula, not Bralts'. 94 % halves the coefficient of variation.
What is the main purpose of fitting a pressure regulator at the inlet of each drip sub-main on hilly land?
C. To isolate each block from mainline pressure variation, so the block's allowable variation is used only within it
On undulating land, mainline pressure differs widely between blocks. A regulator at each sub-main inlet delivers a set pressure, so the lateral and sub-main allowance is not consumed by mainline variation. It cannot raise pressure above the supply.
A drip system draws from an open farm pond with heavy algae growth in summer. Which primary filter is most appropriate?
A. Media (sand/gravel) filter, backflushable
Media filters trap organic material in the depth of the bed and are backflushed; they are the standard primary filter for surface water with algae. A screen alone clogs quickly with algae; a hydrocyclone does not remove organic matter; chlorination complements, but does not replace, filtration.
In chemigation safety equipment, where is the main check valve placed?
B. In the irrigation line between the water source/pump and the injection point
The irrigation-line check valve prevents water containing chemicals from flowing back to the well or source; it sits between the pump and the injection point, with a vacuum-relief valve and low-pressure drain upstream of it. The injection line has its own check valve as well.
Why is clean water run through a drip system for a period after fertiliser injection stops?
C. To flush fertiliser out of laterals and emitters, preventing precipitation, clogging and uneven doses
Fertiliser left in the laterals can precipitate or support microbial growth as it dries, and emitters near the head would otherwise receive a different total than distant ones. The flush time must be at least the travel time from injector to the farthest emitter.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.