LAISHA
Open Laisha

Rajasthan PSC Sprinkler & Micro-Irrigation Systems: practice questions

Rajasthan PSC — Assistant Agriculture Engineer (Agriculture Engineering syllabus) · India · Rajasthan Public Service Commission

Original practice questions written to the published syllabus · not past papers
10worked here, free
35written to this exam in this subject
14syllabus units

About Rajasthan PSC

Rajasthan PSC — Assistant Agriculture Engineer (Agriculture Engineering syllabus) is a government recruitment exam run by Rajasthan Public Service Commission, for candidates in India. Objective paper; the paper structure was not captured.

Source: rpsc.rajasthan.gov.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Sprinkler & Micro-Irrigation Systems in Rajasthan PSC

Designing and evaluating sprinkler and drip systems, from emitter hydraulics to pump selection.

Our 35 Rajasthan PSC questions in this subject: 28 easy, 7 medium, 0 hard, across 14 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Rajasthan PSC and are not shown on any other exam's page.

Question 1 · easy

In which sprinkler is the head stepped round by a spring-loaded arm that the jet knocks aside and that then strikes the sprinkler body?

  1. Gear-driven rotor
  2. Fixed spray head
  3. Bubbler
  4. Impact sprinkler
Answer and working

D. Impact sprinkler

The impact sprinkler is driven by the jet deflecting a spring-loaded arm; the returning arm strikes the body and advances it. A gear-driven rotor uses a small water turbine and gears, a spray head has no rotating jet, and a bubbler is a micro-irrigation device for tree basins.

Question 2 · easy

Which sprinkler system layout needs the least labour during the season but has the highest pipe cost per hectare?

  1. Solid-set system
  2. Hand-move portable system
  3. Single travelling gun with one hose
  4. Semi-portable system with moved laterals
Answer and working

A. Solid-set system

Solid-set and permanent systems have a lateral at every position, so nothing is moved during the season; the cost is the large quantity of pipe. Hand-move and semi-portable systems reuse a few laterals and trade pipe cost for labour. Permanent systems behave the same way.

Question 3 · easy

Sprinklers discharging 0.5 L/s each are spaced 12 m along the lateral and 18 m between laterals. What is the average application rate?

  1. 2.31 mm/h
  2. 60.00 mm/h
  3. 12.50 mm/h
  4. 8.33 mm/h
Answer and working

D. 8.33 mm/h

I = 3600 q / (Sl × Sm) = 3600 × 0.5 / (12 × 18) = 8.33 mm/h (1 L over 1 m² is 1 mm). Using 1000 instead of 3600 (treating L/s as m³/h) gives 2.31; adding the spacings instead of multiplying gives 60; using 12 m × 12 m gives 12.5.

Question 4 · easy

A level sprinkler lateral has design average pressure head 30 m, friction loss 6 m and riser height 1 m. What pressure head is needed at the lateral inlet?

  1. 35.5 m
  2. 37.0 m
  3. 34.5 m
  4. 34.0 m
Answer and working

A. 35.5 m

Hinlet = Ha + ¾ hf + Hr = 30 + 4.5 + 1 = 35.5 m. Adding the full friction loss gives 37 m (the average pressure occurs where about three-quarters of the loss has been used, not at the end); omitting the riser gives 34.5 m. 34.0 m uses half the friction loss instead of three-quarters (30 + 3 + 1).

Question 5 · easy

What is the F factor for a pipe that delivers its entire flow through a single outlet at the far end?

  1. 0.5
  2. 0.35
  3. 0
  4. 1.0
Answer and working

D. 1.0

With one outlet at the end, the full flow travels the full length, so the loss equals the ordinary pipe loss and F = 1 (Christiansen's formula gives 0.351 + 0.5 + 0.154 ≈ 1.0 for N = 1). 0.35 is the many-outlet limit, not the single-outlet case; 0 would mean no friction loss at all.

Question 6 · easy

What is the main function of an anti-drain (non-leakage) emitter?

  1. Stops laterals draining
  2. It keeps discharge constant over a wide range of inlet pressures along the lateral
  3. It filters water at each emitter
  4. It injects fertiliser at the plant
Answer and working

A. Stops laterals draining

Anti-drain emitters close below a set pressure, keeping laterals full between short pulses and preventing low emitters from over-watering as the line drains. Constant discharge is the function of pressure compensation, a different feature.

Question 7 · easy

An emitter exponent x = 1.0 indicates which flow regime?

  1. Fully laminar flow
  2. Fully turbulent flow
  3. Pressure-compensating behaviour
  4. Vortex flow
Answer and working

A. Fully laminar flow

Laminar flow through a long, fine passage makes discharge proportional to head (x = 1). Fully turbulent orifice flow gives x = 0.5, vortex emitters about 0.4, and pressure-compensating emitters approach zero.

Question 8 · easy

What minimum flushing velocity at the end of drip laterals does ASABE EP405 recommend?

  1. About 0.03 m/s
  2. About 3 m/s
  3. About 1.5 m/s
  4. About 0.3 m/s
Answer and working

D. About 0.3 m/s

EP405 recommends flushing at not less than about 0.3 m/s (about 1 ft/s) to carry sediment out. 1.5 m/s is a common velocity limit for mains, not a flushing criterion. About 0.03 m/s and about 3 m/s are factor-of-ten slips.

Question 9 · easy

For a drip lateral with a very large number of emitters and friction computed by the Blasius form (m = 1.75), Christiansen's F approaches about:

  1. 0.36
  2. 0.50
  3. 0.33
  4. 1.00
Answer and working

A. 0.36

F → 1/(m + 1) = 1/2.75 = 0.364. 0.33 is the Darcy (m = 2) limit; 1.0 is for a single outlet at the end. 0.50 is the limit for m = 1, not 1.75.

Question 10 · easy

Why are solenoid valves on irrigation zones usually normally closed?

  1. Because normally open valves are illegal
  2. To reduce friction loss
  3. To keep laterals full and under pressure while idle, so that the next irrigation starts faster
  4. So that the valve shuts and irrigation stops if power or the control signal fails
Answer and working

D. So that the valve shuts and irrigation stops if power or the control signal fails

Normally closed valves fail safe: loss of power closes them, preventing uncontrolled irrigation and flooding.

A study plan for Sprinkler & Micro-Irrigation Systems in Rajasthan PSC

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (49% of the 35 questions): Drip system components (4, 11%); Sprinkler types and components (4, 11%); Christiansen's uniformity coefficient (3, 9%); Economics of pressurised irrigation (3, 9%); Fertigation (3, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Sprinkler lateral and main design (3, 9%); Sprinkler spacing and application rate (3, 9%); Allowable pressure variation and the friction factor F (2, 6%); Automation (2, 6%); Drip lateral and sub-main design (2, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Filtration (2, 6%); System layout and pump selection (2, 6%); Emission uniformity (1, 3%); Emitter hydraulics: exponent and coefficient of variation (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Bank the easy marks: Allowable pressure variation and the friction factor F (2 easy of 2); Automation (2 easy of 2).

    Do these early in revision so they are fast on the day.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Rajasthan PSC Sprinkler & Micro-Irrigation Systems

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.