Rajasthan PSC — Assistant Agriculture Engineer (Agriculture Engineering syllabus) · India · Rajasthan Public Service Commission
Original practice questions written to the published syllabus · not past papersRajasthan PSC — Assistant Agriculture Engineer (Agriculture Engineering syllabus) is a government recruitment exam run by Rajasthan Public Service Commission, for candidates in India. Objective paper; the paper structure was not captured.
Source: rpsc.rajasthan.gov.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Everything between the engine and the implement: clutch, gearbox, differential, PTO, brakes, steering, hydraulics, hitch and tyres.
Our 28 Rajasthan PSC questions in this subject: 14 easy, 14 medium, 0 hard, across 13 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Rajasthan PSC and are not shown on any other exam's page.
A tractor's PTO reaches 540 rev/min at 1900 engine rev/min. If the operator runs the engine at 2100 rev/min, the PTO turns at about
A. 597 rev/min
PTO ratio = 1900/540 = 3.52:1. At 2100 rev/min the PTO turns 2100/3.52 = 597 rev/min, over-speeding the implement by 10.5%. The PTO speed is fixed to engine speed by gearing, so it is not held at 540; 489 inverts the proportion. 740 adds the 200 rev/min engine increase directly to the PTO speed.
A single-acting lift cylinder has a 90 mm bore and 120 mm stroke. The pump supplies 25 L/min to it. The time for a full lift is
A. 1.83 s
Swept volume = π/4 × 0.09² × 0.12 = 0.000763 m³ = 0.763 L. Time = 0.763/25 min = 0.0305 min = 1.83 s. Using the radius in πd²/4 gives a quarter; 0.03 is the answer in minutes read as seconds. In figures, a quarter is 0.46 s; 7.33 s uses πd² without the /4.
Each rear tyre of a tractor has an internal volume of 400 L. Both are filled to the usual 75% with a ballast solution of density 1.2 kg/L. The added mass is
C. 720 kg
Mass = 2 tyres × 400 L × 0.75 × 1.2 kg/L = 720 kg. 360 kg is one tyre; 960 kg assumes a full tyre, which leaves no air cushion; 600 kg assumes plain water.
The torsional damper springs in a clutch driven plate
D. absorb torsional vibration and shock between engine and transmission
Coil springs in the hub let the plate twist slightly relative to its hub, damping engine firing pulses and shocks. Clamping force comes from the pressure-plate springs.
Gear clash when shifting a sliding-mesh gearbox on a moving tractor happens because
D. the gears to be meshed are turning at different speeds
Teeth can mesh cleanly only when their pitch-line speeds match. Sliding-mesh boxes have no synchroniser, so they need the tractor stopped or double-declutching.
Lengthening or shortening the top link of a mounted plough mainly adjusts
B. fore-and-aft pitch
The top link sets the implement's pitch (e.g. levelling a plough front to rear). Side-to-side level is set by the lift rods.
When filling a tractor tyre with liquid ballast, the valve is placed at the top and the tyre filled to about
A. 75% of its volume
With the valve at the top the liquid reaches about three-quarters full, leaving air to cushion the load and allow pressure adjustment.
Steel cage wheels are fitted to a power tiller for
C. wet paddy fields
Cage wheels sink into the mud and give traction where rubber tyres slip; they are removed for road work. They are used for puddling and other wet-field work.
A foldable two-post ROPS has been lowered to pass under a low shed door. The correct practice is to
D. raise and lock it as soon as the low clearance is passed
A folded ROPS gives no protection. Drilling or welding a ROPS can destroy its certified strength.
The most common way a tractor overturns backwards is when
C. the rear wheels are held and axle torque rotates the tractor about them, or a load is hitched high
When the wheels cannot turn, drive torque lifts the front; with a high hitch the pull adds to this moment. Rearward overturns happen in a second or two.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.