ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papersICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Single-answer MCQs on causes and effects of waterlogging, drainage coefficient, surface and subsurface system types, envelope functions, saline-sodic classification limits, amendments and water-quality indices, with short calculations.
Removing excess water and salt: surface and subsurface drain design, and reclaiming saline and sodic land.
Our 57 ICAR AIEEA-PG questions in this subject: 26 easy, 30 medium, 1 hard, across 11 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
A rainfall of 30 mm percolates to a shallow water table in a soil of drainable porosity 0.06. By how much does the water table rise?
B. 0.50 m
Rise = recharge / drainable porosity = 0.030 m / 0.06 = 0.50 m. Multiplying (30 x 0.06 = 1.8 mm) is the common error; 0.05 m and 5 m are decimal slips. Small drainable porosity means a small recharge causes a large rise.
Heavy weed growth in an open drain has which effect?
A. It raises Manning's n and so lowers the drain's capacity
Vegetation adds roughness; with a higher n, Q = (1/n) A R^(2/3) S^(1/2) falls, and water levels rise. That is why maintenance is part of design.
Why did Hooghoudt replace the depth to the impermeable layer D by an equivalent depth d?
B. To account for the extra head loss from radial convergence of flow near a pipe drain
Flow converges radially into a small pipe, which the horizontal-flow (Dupuit-Forchheimer) assumption ignores. Using a smaller d adds the right amount of resistance. It has nothing to do with pipe roughness or time.
How does water enter a corrugated plastic drain pipe?
A. Through slots cut in the valleys of the corrugations
Corrugated pipe is perforated with slots in the valleys. Water entering at the joints describes clay tiles, which were laid as short sections.
An interceptor drain is used to:
B. Cut off groundwater seeping laterally into an area from higher land or a canal
Interceptors deal with lateral inflow from outside the area. Water arriving over the area itself is handled by relief (parallel) drains; artesian pressure by relief wells.
A crop's seasonal ETc is 600 mm and the leaching requirement is 0.15. What depth of irrigation water must be applied (no rain, leaching with every irrigation)?
B. 706 mm
Diw = ETc / (1 - LR) = 600 / 0.85 = 706 mm. 690 mm adds 15 % of ETc (600 x 1.15), which is slightly too little; 510 mm subtracts; 4000 mm divides by LR.
Which description fits a sodic (alkali) soil?
C. ESP above 15, ECe below 4 dS/m, pH 8.5-10, dispersed clay and poor permeability
Sodic soils have dispersed clay and organic matter ('black alkali'), high pH and very low permeability. White crusts mark saline soils; acid sulphate soils are a different problem.
A saline-sodic soil is to be reclaimed. What is the correct sequence?
B. Apply a calcium amendment such as gypsum first, then leach
If the salts are leached first, the clay disperses and the soil becomes sodic and nearly impermeable. Calcium must replace exchangeable sodium first. Lime is insoluble at high pH and raising pH is the wrong direction.
Soil CEC is 20 meq/100 g. What is the gypsum requirement in meq/100 g to lower ESP from 30 to 10?
A. 4 meq/100 g
GR = (ESPi - ESPf) x CEC / 100 = 20 x 20 / 100 = 4 meq/100 g. 6 uses the initial ESP only; 2 uses the final ESP; 40 forgets to divide by 100.
Irrigation water has EC 1,500 uS/cm. In the USDA Salinity Laboratory scheme its salinity class is:
A. C3 (high)
C1 < 250, C2 250-750, C3 750-2,250, C4 > 2,250 uS/cm. 1,500 falls in C3.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.