LAISHA
Open Laisha

ICAR AIEEA-PG Storage Engineering, Material Handling & Packaging: practice questions

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
61written to this exam in this subject
13syllabus units

About ICAR AIEEA-PG

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Storage Engineering, Material Handling & Packaging in ICAR AIEEA-PG

Unit VI (storage) asks recall and short calculation: primary and secondary storage insects, safe moisture, CAP storage and godown design features, Janssen and Rankine relations, aeration versus drying, phosphine chemistry, CA and MA definitions, packaging polymers and their barrier properties, and conveyor types.

Storing grain and produce safely, the loads it puts on bins and silos, and the conveyors and packages that move and protect it.

Our 61 ICAR AIEEA-PG questions in this subject: 38 easy, 15 medium, 8 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.

Question 1 · easy

What is the purpose of dunnage beneath bag stacks?

  1. To add weight at the base so a tall stack does not topple when bags are removed from the top
  2. To keep bags off a floor that transmits ground moisture and allow air below the stack
  3. To act as a fumigant reservoir
  4. To absorb and trap insects migrating downward out of the grain before they reach the floor
Answer and working

B. To keep bags off a floor that transmits ground moisture and allow air below the stack

Dunnage (wooden crates, pallets or polythene sheet) separates the bottom bags from the floor, which may transmit moisture. It does not stabilise the stack by weight or release chemicals.

Question 2 · easy

For grain with φ = 30°, above what grain depth does a 4 m wide bin become a deep bin by the plane-of-rupture criterion?

  1. 2.31 m
  2. 4.00 m
  3. 3.46 m
  4. 6.93 m
Answer and working

D. 6.93 m

Critical depth = D·tan(45° + φ/2) = 4 × tan60° = 6.93 m. Using tan(45° − φ/2) gives 2.31 m; ignoring φ (tan45°) gives 4.00 m; using the radius instead of the width gives 3.46 m.

Question 3 · hard

A shallow bin holds grain of specific weight 7.5 kN/m³ to a depth of 3 m; φ = 30°. By Rankine's theory, what is the total lateral force per metre length of wall?

  1. 22.50 kN/m
  2. 33.75 kN/m
  3. 11.25 kN/m
  4. 7.50 kN/m
Answer and working

C. 11.25 kN/m

P = γH²k/2 = 7.5 × 3² × 0.333/2 = 11.25 kN/m, acting at H/3 = 1 m above the base. Forgetting the ½ (area of the triangle) gives 22.50; forgetting k treats grain as a liquid (33.75); γHk = 7.50 kPa is the pressure at the base, not the force.

Question 4 · easy

By Rankine's theory, the resultant lateral force on the wall of a shallow bin with a level grain surface acts at

  1. Half the grain depth above the base
  2. Two thirds of the depth above the base
  3. One third of the grain depth above the base
  4. The grain surface
Answer and working

C. One third of the grain depth above the base

The pressure increases linearly from zero at the surface to γHk at the base, a triangular diagram whose centroid is H/3 above the base. H/2 would apply to a uniform pressure.

Question 5 · easy

Why should an aeration cycle be completed once started?

  1. Fans cannot be restarted once stopped without first purging the plenum of moist air
  2. Fumigant will escape
  3. Grain bulk density changes when half-cooled, so the next cycle might need a larger fan motor
  4. Stopping midway leaves a boundary between warm and cool grain where condensation can occur
Answer and working

D. Stopping midway leaves a boundary between warm and cool grain where condensation can occur

A partly completed cycle leaves a temperature front inside the bulk; the temperature difference can drive local condensation and migration. Fans can be restarted, but the front should be pushed right through.

Question 6 · easy

Hermetic storage of grain controls insects mainly because

  1. The sealed container is heated by solar gain to about 60 °C, killing all insect stages
  2. Respiration of grain, insects and moulds in a sealed container depletes O2 and raises CO2
  3. A fumigant tablet is always added
  4. Light is excluded inside the sealed container, and insects cannot feed or breed in total darkness
Answer and working

B. Respiration of grain, insects and moulds in a sealed container depletes O2 and raises CO2

In a gas-tight container biological respiration consumes O2 and produces CO2 until insects die or become inactive; no chemical is required. Heating and darkness are not the mechanism.

Question 7 · medium

Arrange corrugated board flutes from tallest to shortest.

  1. E > B > C > A
  2. B > A > C > E
  3. A > C > B > E
  4. C > A > E > B
Answer and working

C. A > C > B > E

A flute is the tallest, then C, then B, then E (fine flute). Letters were assigned in the order of introduction, not size, which is why C sits between A and B.

Question 8 · easy

The double seam is the method of

  1. Sealing a PE pouch
  2. Attaching the end to a metal container body
  3. Closing a jute bag
  4. Joining glass to metal
Answer and working

B. Attaching the end to a metal container body

In a double seam the can-end curl and the body flange are interlocked and compressed in two rolling operations. Pouches are heat-sealed and bags sewn.

Question 9 · hard

A bucket elevator has buckets of 2 L capacity, 80% filled, spaced 0.3 m apart on a belt running at 2.5 m/s, handling grain of bulk density 750 kg/m³. Capacity?

  1. 45.0 t/h
  2. 10.0 t/h
  3. 36.0 t/h
  4. 3.24 t/h
Answer and working

C. 36.0 t/h

Buckets per second = v/spacing = 2.5/0.3 = 8.333. Mass per bucket = 0.002 m³ × 0.8 × 750 = 1.20 kg. Mass flow = 1.20 × 8.333 = 10.00 kg/s = 36.0 t/h. Ignoring the fill fraction gives 45.0; reporting kg/s as t/h gives 10.0; multiplying by spacing instead of dividing gives 3.24.

Question 10 · easy

Which conveyor type is best for lifting grain vertically in a compact footprint?

  1. Flat belt conveyor
  2. Horizontal chain conveyor
  3. Bucket elevator
  4. Vibratory conveyor
Answer and working

C. Bucket elevator

Bucket elevators lift vertically; belts, horizontal chain and vibratory conveyors move material horizontally or at modest inclines.

A study plan for Storage Engineering, Material Handling & Packaging in ICAR AIEEA-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (61% of the 61 questions): Janssen's and Airy's theories of bin pressure (11, 18%); Causes of storage losses (8, 13%); Design of conveyors and elevators (7, 11%); Packaging materials: paper, plastics and laminates (6, 10%); Bag and bulk storage (5, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Aeration of stored grain (4, 7%); Godowns and warehouses (4, 7%); Barrier properties of packages (3, 5%); Bins and silos (3, 5%); Packaging machines (3, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Warehouse management (3, 5%); Controlled and modified atmosphere storage (2, 3%); Fumigation (2, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Bins and silos (2 hard of 3), Janssen's and Airy's theories of bin pressure (4 hard of 11), Warehouse management (1 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Barrier properties of packages (3 easy of 3); Packaging machines (3 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG Storage Engineering, Material Handling & Packaging

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.