ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papersICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Unit V test codes and procedure: types of test (commercial, batch, confidential), names of OECD codes and what each covers, which test measures what, dynamometer types, ROPS purpose; mostly recall with short calculations.
How tractors and implements are tested against codes, and how to read a test report.
Our 38 ICAR AIEEA-PG questions in this subject: 15 easy, 23 medium, 0 hard, across 12 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
The OECD Standard Code that covers the performance testing of agricultural tractors — PTO, hydraulic and drawbar power and fuel consumption — is
A. Code 2
Code 2 is the performance code. Code 4 is the static ROPS test for standard tractors, Code 5 is noise at the driver's position, and Code 10 covers falling object protective structures.
The main reason the OECD tractor codes were set up was to
D. make a test report from one member country recognised in the others
The codes, begun in 1959, give a common test method so that a report approved under the scheme is accepted by all participating countries, easing trade. They do not set prices, do not replace national road law, and do not license operators.
During a PTO test the dynamometer records a torque of 220 N·m at a PTO speed of 540 rev/min. The PTO power is
B. 12.44 kW
P = 2πNT/60 = 2π × 540 × 220 / 60 = 12441 W = 12.44 kW. Leaving out the /60 gives 746.4 kW; using 1000 rev/min gives 23.04 kW; leaving out 2π gives 1.98 kW.
In a tractor PTO performance test, the maximum torque and the speed at which it occurs are found from
B. full-governor runs with load raised beyond rated speed, down the lug curve
With the governor control at full, raising the load past the rated point makes the engine slow down and the torque rise to its maximum; those runs trace the lug curve. Part-load runs give fuel use at partial loads, high idle carries almost no torque, and a run at standard PTO speed gives power at that speed only.
During the tractor hydraulic power test, the maximum pressure that can be reached in the external circuit is set by
C. the pressure relief valve setting
The relief valve opens at its set pressure and limits the circuit pressure; the report states that setting. Pump efficiency affects delivery, coupler size affects pressure drop at high flow, and oil temperature affects viscosity and leakage, but none of these fixes the maximum pressure.
Two independent noise sources each produce 86 dB(A) at the operator's ear. The combined level is
D. 89 dB(A)
L = 10 log₁₀(2 × 10^8.6) = 86 + 10 log₁₀ 2 = 89.0 dB(A). Decibels are not added arithmetically (172); a second equal source does add energy, so 86 is wrong; +6 dB applies to doubling sound pressure from coherent sources, not to two independent sources.
In a hydraulic (water-brake) dynamometer used for PTO testing, the load on the engine is varied by
D. changing the water level in the casing around the rotor
A water brake absorbs power by churning water; more water means more resistance. Coil current controls an eddy-current dynamometer, a rope or band is a friction brake, and gear ratio changes do not set dynamometer load.
In a combine harvester field test, grain lost over the straw walkers or out of the rotor discharge with the straw is classed as
B. separation loss
Free grain that the separating unit fails to recover and that leaves with the straw is separation loss. Header loss happens at the cutter bar and reel, cleaning loss leaves from the sieves with the chaff, and pre-harvest loss is on the ground before the machine arrives.
A brochure states 50 hp engine power; the official test report for the same model gives 42 hp maximum PTO power. A buyer should conclude that
C. the figures are taken at different points and are not directly comparable
Flywheel (engine) power is measured before the transmission and PTO power after it, so PTO power is lower by the transmission losses. That gap is normal and not evidence of a fault or an error. The tolerance between declared and measured values is set by each code or rule, and should be checked against the like-for-like quantity.
In a dynamometer, the casing is mounted on trunnion bearings and restrained by a torque arm. This arrangement allows
D. the casing's reaction torque to be measured by a load cell
Whatever torque the rotor applies to the casing (by water, magnetism or friction) tends to rotate the casing; the torque arm and load cell measure that reaction, which equals the shaft torque. The trunnions do not unload the engine, measure water flow, or affect governed speed.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.