LAISHA
Open Laisha

Agricultural and Biosystems Engineers Licensure Examination Farm Power Sources: practice questions

Agricultural and Biosystems Engineers Licensure Examination (ABELE) · Philippines · Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC

Original practice questions written to the published syllabus · not past papers
10worked here, free
44written to this exam in this subject
9syllabus units

About Agricultural and Biosystems Engineers Licensure Examination

Agricultural and Biosystems Engineers Licensure Examination (ABELE) is a licensing and registration exam run by Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC, for candidates in Philippines. Paper-based, 2 days (Day 1 6 hours; Day 2 5 hours + 4 hours). Non-programmable calculator only; the Dec 2025 programme bans the Casio fx-991ES/ES Plus by name.

Source: prc.gov.ph.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Farm Power Sources in Agricultural and Biosystems Engineers Licensure Examination

Where the energy for farm work comes from, how much is available, and how mechanisation is measured.

Our 44 Agricultural and Biosystems Engineers Licensure Examination questions in this subject: 6 easy, 22 medium, 16 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Agricultural and Biosystems Engineers Licensure Examination and are not shown on any other exam's page.

Question 1 · medium

During a draught-animal performance trial, which set of observations tells the operator that the animals are fatigued and should be rested?

  1. Rising respiration rate, body temperature and heart rate, with frothing at the mouth
  2. Steady pull with a falling respiration rate and a cool, dry muzzle throughout
  3. Increased walking speed with lower pull, and eager response to the driver's commands
  4. Normal rumination while walking
Answer and working

A. Rising respiration rate, body temperature and heart rate, with frothing at the mouth

Physiological signs of fatigue are rising respiration rate, body temperature and heart rate, frothing, reluctance to move and lying down. Steady pull and normal physiology indicate the animals are coping.

Question 2 · hard

A PTO dynamometer records a torque of 400 N·m at 540 rpm. What is the PTO power?

  1. 216.0 kW
  2. 22.6 kW
  3. 3.6 kW
  4. 1,357 kW
Answer and working

B. 22.6 kW

P = 2πNT/60 = 2π × 540 × 400 / 60 = 22,619 W = 22.6 kW. Omitting 2π/60 gives 216.0 kW; omitting 2π gives 3.6 kW; omitting /60 gives 1,357 kW.

Question 3 · hard

A three-phase induction motor draws 12 A at 415 V line voltage and 0.85 power factor. Its efficiency is 88%. What is its shaft output?

  1. 6.45 kW
  2. 3.73 kW
  3. 7.33 kW
  4. 8.33 kW
Answer and working

A. 6.45 kW

Input = √3 × 415 × 12 × 0.85 = 7,332 W; output = 0.88 × 7,332 = 6,452 W ≈ 6.45 kW. Leaving out √3 gives 3.73 kW; 7.33 kW is the input; dividing by efficiency gives 8.33 kW.

Question 4 · easy

A 4-pole induction motor runs on a 50 Hz supply with 4% slip at full load. What is its rotor speed?

  1. 1500 rpm
  2. 1440 rpm
  3. 2880 rpm
  4. 1560 rpm
Answer and working

B. 1440 rpm

Ns = 120f/p = 120 × 50/4 = 1500 rpm; N = Ns(1 − s) = 1500 × 0.96 = 1440 rpm. 1500 rpm is synchronous speed; 2880 rpm uses pole pairs instead of poles; adding slip gives 1560 rpm.

Question 5 · hard

A 300 W crystalline silicon module has a power temperature coefficient of −0.4%/°C. Estimate its output at 1000 W/m² when the cell temperature is 55 °C.

  1. 234 W
  2. 336 W
  3. 36 W
  4. 264 W
Answer and working

D. 264 W

Rise above STC = 55 − 25 = 30 °C; loss = 30 × 0.4% = 12%; P = 300 × 0.88 = 264 W. Using 55 °C instead of the rise gives 234 W; adding the loss gives 336 W; 36 W is the loss, not the output.

Question 6 · medium

A farmer wants to run an unmodified diesel pump set on biogas. What is the realistic arrangement?

  1. Biogas alone, because it self-ignites under compression
  2. Biogas mixed into the diesel tank as a liquid
  3. Dual-fuel operation, with a small pilot injection of diesel to ignite the gas
  4. Petrol added to the biogas to raise its cetane number enough for compression ignition
Answer and working

C. Dual-fuel operation, with a small pilot injection of diesel to ignite the gas

Methane has high auto-ignition resistance and will not ignite by compression alone in a diesel engine, so a pilot diesel injection is used; this saves much, but not all, of the diesel. Spark-ignition engines can run on biogas alone.

Question 7 · medium

A farm burns 5 t of crop residue (calorific value 15 MJ/kg) in a furnace with 70% efficiency to supply heat for a grain dryer. How much useful heat is delivered?

  1. 75.0 GJ
  2. 52,500 GJ
  3. 52.5 GJ
  4. 107.1 GJ
Answer and working

C. 52.5 GJ

Fuel energy = 5000 × 15 = 75,000 MJ = 75 GJ; useful = 0.70 × 75 = 52.5 GJ (= 14,583 kWh). Ignoring efficiency gives 75 GJ; 52,500 is the answer in MJ labelled GJ; dividing by efficiency gives 107.1 GJ.

Question 8 · medium

Ploughing 60 ha requires 3 tractor-hours per hectare. It must be done in 10 working days of 8 hours. What is the minimum number of tractors?

  1. 2
  2. 23
  3. 3
  4. 1
Answer and working

C. 3

Needed = 60 × 3 = 180 tractor-hours; available per tractor = 10 × 8 = 80 h; 180/80 = 2.25 → round up to 3. Rounding down to 2 leaves 20 h of work undone in the window. 1 forgets the 3 tractor-hours per hectare (60/80 = 0.75); 23 divides by one 8-hour day only (180/8 = 22.5).

Question 9 · medium

Custom hiring centres (machinery banks) mainly raise the farm power effectively available to smallholders by:

  1. Increasing the rated power of each tractor through engine upgrades at the centre
  2. Replacing all draught animals by law so that farmers must hire the centre's machines
  3. Letting many farmers use machines they could not justify owning, when they need them
  4. Lowering the calorific value of diesel
Answer and working

C. Letting many farmers use machines they could not justify owning, when they need them

Hiring spreads fixed costs over more farms and hours, improving access and timeliness without each farmer buying a machine. It does not change machine ratings.

Question 10 · medium

Two reports give very different 'levels of mechanisation' for the same state. What should you check first?

  1. Which report used the larger number of tractors
  2. Which report was published later, since later figures are always correct
  3. Whether the reports used kW or hp (metric or imperial), since that alone explains any difference
  4. The definition used (power share, operation-wise area, energy share or stock) and the area and data year
Answer and working

D. The definition used (power share, operation-wise area, energy share or stock) and the area and data year

There is no single agreed index: power-based, operation-based, energy-based and stock-based measures can differ widely. Compare like with like on definition, area basis and year before judging.

A study plan for Farm Power Sources in Agricultural and Biosystems Engineers Licensure Examination

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (50% of the 44 questions): Electrical power on the farm (9, 20%); Solar power as a farm power source (7, 16%); Animal draught power and harnessing (6, 14%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Mechanical power: engines and tractors (6, 14%); Biomass and biofuels as power sources (5, 11%); Wind power as a farm power source (5, 11%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Human power and its limits (3, 7%); Farm power availability (kW/ha) (2, 5%); Mechanisation indices (1, 2%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Human power and its limits (2 hard of 3), Wind power as a farm power source (3 hard of 5), Mechanical power: engines and tractors (3 hard of 6).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Solar power as a farm power source (2 easy of 7); Biomass and biofuels as power sources (1 easy of 5).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Agricultural and Biosystems Engineers Licensure Examination Farm Power Sources

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.