LAISHA
Open Laisha

Agricultural and Biosystems Engineers Licensure Examination Soil Science for Engineers: practice questions

Agricultural and Biosystems Engineers Licensure Examination (ABELE) · Philippines · Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC

Original practice questions written to the published syllabus · not past papers
10worked here, free
51written to this exam in this subject
9syllabus units

About Agricultural and Biosystems Engineers Licensure Examination

Agricultural and Biosystems Engineers Licensure Examination (ABELE) is a licensing and registration exam run by Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC, for candidates in Philippines. Paper-based, 2 days (Day 1 6 hours; Day 2 5 hours + 4 hours). Non-programmable calculator only; the Dec 2025 programme bans the Casio fx-991ES/ES Plus by name.

Source: prc.gov.ph.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Soil Science for Engineers in Agricultural and Biosystems Engineers Licensure Examination

The soil an engineer tills, irrigates, drains and builds on: its physical, water and chemical properties.

Our 51 Agricultural and Biosystems Engineers Licensure Examination questions in this subject: 34 easy, 13 medium, 4 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Agricultural and Biosystems Engineers Licensure Examination and are not shown on any other exam's page.

Question 1 · easy

In a soil profile, the pale horizon from which clay, iron, aluminium and humus have been washed out is designated:

  1. C horizon
  2. Bt horizon
  3. E horizon
  4. Ap horizon
Answer and working

C. E horizon

The E (eluvial) horizon loses clay, iron, aluminium and organic matter and is therefore pale. The Bt horizon is where clay accumulates (illuviation); C is little-altered parent material; Ap is a ploughed surface horizon.

Question 2 · medium

Under USDA Soil Taxonomy, which order is defined by clay-rich soils that shrink and crack when dry, swell when wet and show slickensides?

  1. Aridisols
  2. Vertisols
  3. Oxisols
  4. Andisols
Answer and working

B. Vertisols

Vertisols are the shrink-swell clays (black cotton soils of central India, the Gezira clays of Sudan and many others). Oxisols are deeply weathered oxide-rich tropical soils, Andisols form in volcanic ash, and Aridisols are soils of dry climates.

Question 3 · medium

Why do soils high in exchangeable sodium lose their structure when irrigated with very low-salinity water?

  1. Sodium clays disperse in dilute solution, so aggregates collapse and pores block
  2. Sodium cements the clay into hard aggregates that then break under raindrop impact and wind
  3. Low-salinity water dissolves the quartz grains that form the skeleton of the soil aggregates
  4. Sodium raises the particle density so the soil compacts under its own weight when it is wetted
Answer and working

A. Sodium clays disperse in dilute solution, so aggregates collapse and pores block

Monovalent Na⁺ with a thick diffuse double layer lets clay particles repel each other when the solution is dilute; the clay disperses, moves and clogs pores. Sodium does not cement aggregates, quartz is practically insoluble, and particle density is not changed by sodium.

Question 4 · medium

A loam holds 150 mm of available water per metre of soil. The crop's effective root depth is 0.8 m, management allowed depletion is 50%, and crop evapotranspiration is 6 mm/day. What is the irrigation interval?

  1. 10 days
  2. 5 days
  3. 20 days
  4. 12.5 days
Answer and working

A. 10 days

Net depth = 150 × 0.8 × 0.5 = 60 mm; interval = 60/6 = 10 days. Ignoring root depth gives 12.5 days; ignoring the depletion fraction gives 20 days (waiting until wilting point); halving again gives 5.

Question 5 · medium

A sprinkler system is being designed for a soil whose basic infiltration rate is 8 mm/h. Which design rule applies to the sprinkler application rate?

  1. It should not exceed the basic infiltration rate, to avoid ponding and runoff late in each irrigation
  2. It can be set without reference to infiltration because sprinkler water never ponds on any soil
  3. It should exceed the infiltration rate so that surface ponding helps distribute the water evenly
  4. It should equal the initial infiltration rate measured in the first minutes of the ring test
Answer and working

A. It should not exceed the basic infiltration rate, to avoid ponding and runoff late in each irrigation

Infiltration rate falls during an irrigation, so the application rate must be at or below the steady (basic) rate, with a margin on slopes and crusting soils. The initial rate is far higher and would cause runoff later; ponding under sprinklers causes runoff and non-uniformity rather than helping.

Question 6 · easy

Which of the following is a micronutrient essential for higher plants?

  1. Sulphur
  2. Calcium
  3. Magnesium
  4. Boron
Answer and working

D. Boron

Boron is one of the micronutrients (Fe, Mn, Zn, Cu, B, Mo, Cl, Ni). Sulphur, magnesium and calcium are secondary macronutrients, required in larger amounts.

Question 7 · easy

Under the US Salinity Laboratory (Handbook 60) classification, a soil with ECe 9 dS/m, ESP 8 and pH 7.9 is:

  1. Acid sulphate
  2. Saline-sodic
  3. Sodic (alkali)
  4. Saline
Answer and working

D. Saline

Saline soils have ECe above 4 dS/m, ESP below 15 and pH usually below 8.5. Sodic soils need ESP above 15 with ECe below 4; saline-sodic need both ECe above 4 and ESP above 15; acid sulphate soils are strongly acid, not pH 7.9.

Question 8 · hard

A coastal reclamation project proposes deep drainage of waterlogged estuarine sediments rich in pyrite. What is the main soil risk?

  1. Oxidation of sulphides to sulphuric acid, driving pH below about 4 and releasing aluminium and iron
  2. Loss of organic carbon that converts the sediments into coarse sand of very low water holding
  3. Rapid build-up of calcium carbonate from shells, raising the pH to about 9 within a few years
  4. Formation of sodic soils as seawater sodium is retained on the exchange complex after drainage
Answer and working

A. Oxidation of sulphides to sulphuric acid, driving pH below about 4 and releasing aluminium and iron

Drained pyritic sediments become actual acid sulphate soils: pyrite oxidises to sulphuric acid, pH falls below about 4, and aluminium, iron and heavy metals enter drainage water. Management keeps sulphidic layers wet and avoids deep drainage. Sodicity or carbonate build-up are not the main risk, and organic loss does not create sand.

Question 9 · medium

In a soil survey, a 'phase' of a soil series is:

  1. A group of related series that share the same parent material and moisture regime
  2. The lowest category of Soil Taxonomy, below the series and the family classes
  3. A seasonal change in a soil's properties between the wet and the dry season
  4. A subdivision of a series by a use-related feature such as slope or erosion
Answer and working

D. A subdivision of a series by a use-related feature such as slope or erosion

A phase splits a series by a use-related feature: slope class, erosion, stoniness, salinity and similar. It is a mapping and interpretation unit, not a taxonomic category; the series is the lowest category of Soil Taxonomy, and groupings of series are families.

Question 10 · easy

The steady infiltration rate that a soil approaches after prolonged wetting is called the:

  1. Basic infiltration rate
  2. Sorptivity
  3. Percolation ratio
  4. Initial infiltration capacity
Answer and working

A. Basic infiltration rate

The basic (final or steady-state) infiltration rate is the near-constant rate reached after long wetting; it approaches the saturated conductivity of the surface layer. Initial capacity is the high early rate, sorptivity describes early suction-driven uptake, and percolation is movement within the profile.

A study plan for Soil Science for Engineers in Agricultural and Biosystems Engineers Licensure Examination

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (45% of the 51 questions): Problem soils: saline, sodic and acid (9, 18%); Soil formation and profile (8, 16%); Bulk density, particle density and porosity (6, 12%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Soil chemistry: pH and electrical conductivity (6, 12%); Soil texture and structure (6, 12%); Infiltration (5, 10%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Soil water: field capacity, wilting point and available water (5, 10%); Hydraulic conductivity and Darcy's law (3, 6%); Sodicity: SAR and ESP (3, 6%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Problem soils: saline, sodic and acid (3 hard of 9), Soil formation and profile (1 hard of 8).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Soil chemistry: pH and electrical conductivity (6 easy of 6); Sodicity: SAR and ESP (3 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Agricultural and Biosystems Engineers Licensure Examination Soil Science for Engineers

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.