GATE — Agricultural Engineering (AG) · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papersGATE — Agricultural Engineering (AG) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 technical: 25 one-mark and 30 two-mark questions). MCQ, MSQ and NAT; negative marking on MCQ only (−1/3 for one-mark, −2/3 for two-mark); no partial credit on MSQ. On-screen virtual calculator.
Source: gate2027.iitm.ac.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Numerical answer items on soil-water-plant relations: gravimetric to volumetric water content, bulk density and porosity, available water and irrigation depth, infiltration equations (Kostiakov, Horton, Philip), Darcy's law and layered-soil conductivity, and SAR or gypsum requirement in the drainage and salinity part. Watch units and the dry-mass basis.
The soil an engineer tills, irrigates, drains and builds on: its physical, water and chemical properties.
Our 41 GATE questions in this subject: 12 easy, 14 medium, 15 hard, across 7 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE and are not shown on any other exam's page.
Under the USDA system, what are the particle-size limits of the silt fraction?
D. 0.05 to 0.002 mm
USDA silt is 0.05 to 0.002 mm. The ISSS (Atterberg) scale puts the sand-silt boundary at 0.02 mm, 2.0 to 0.05 mm is USDA sand, and 0.075 mm (the No. 200 sieve) is the boundary used in engineering classification systems.
A cylindrical core 5.0 cm in diameter and 5.0 cm long contains 135 g of oven-dry soil. What is the bulk density?
B. 1.38 g/cm³
Volume = π × 2.5² × 5 = 98.2 cm³; ρb = 135/98.2 = 1.375 g/cm³. Using the diameter as the radius gives 0.34; treating the core as a 5 cm cube gives 1.08; 2.65 is the default particle density, not bulk density.
A soil sample has a gravimetric water content of 22% and a bulk density of 1.45 g/cm³. What is its volumetric water content?
A. 31.9%
θ = w × ρb/ρw = 0.22 × 1.45 = 0.319, or 31.9%. Dividing by bulk density gives 15.2%, leaving it unconverted gives 22%, and multiplying by particle density instead of bulk density gives 58.3%.
Water in soil is at a matric suction of 1,500 kPa. What is this suction expressed as pF?
B. 4.2
1,500 kPa = 1.5 × 10⁶ Pa ÷ (1,000 × 9.81) = 152.9 m = 15,291 cm of water; pF = log₁₀(cm) = 4.18, usually rounded to 4.2. log₁₀(1500) = 3.2 uses kPa, log₁₀(15) = 1.2 uses bar, and 2.2 uses metres instead of centimetres.
A soil layer 60 cm thick has a volumetric water content of 0.25. What is the equivalent depth of water stored in it?
B. 15 cm
Equivalent depth = θ × depth = 0.25 × 60 cm = 15 cm. 25 cm treats the 0.25 as a depth; 2.4 cm divides 60 by 25; 240 cm divides the depth by θ instead of multiplying.
Water flows through a saturated soil with a Darcy flux of 0.5 m/day. The effective porosity is 0.25. What is the average pore-water (seepage) velocity?
B. 2.0 m/day
Seepage velocity = q/ne = 0.5/0.25 = 2.0 m/day; water in the pores moves faster than the flux because it uses only the pore area. Multiplying gives 0.125; equating the two gives 0.5; dividing by 0.75 (the solid fraction) gives 0.67.
Darcy's law is valid for flow in soils as long as the flow is:
D. Laminar, at low Reynolds number
Darcy's law assumes viscous, laminar flow, which holds in nearly all soils (Reynolds number below roughly 1–10). It fails in turbulent flow through very coarse gravels. Froude number and supercritical flow are open-channel concepts.
In Darcy's law, Q = K A (Δh/L). If the hydraulic gradient through a soil column is doubled while everything else stays the same, the discharge:
B. Doubles
Discharge is directly proportional to the hydraulic gradient Δh/L, so doubling the gradient doubles Q. Halving and quadrupling assume inverse or square relations, and K, not Q, is the quantity unaffected by gradient.
A soil's cumulative infiltration follows Kostiakov's equation I = 2.5 t^0.6, with I in cm and t in hours. What is the cumulative infiltration after 2 hours?
D. 3.79 cm
I = 2.5 × 2^0.6 = 2.5 × 1.516 = 3.79 cm. 3.00 multiplies instead of raising to a power; 1.14 is the infiltration rate (cm/h) at 2 h, a b t^(b−1); 7.94 uses 1/b as the exponent.
Horton's equation for a soil has f0 = 8 cm/h, fc = 1 cm/h and k = 2 h⁻¹. What is the cumulative infiltration in the first hour?
A. 4.03 cm
F = fc t + ((f0 − fc)/k)(1 − e^(−kt)) = 1 + (7/2)(1 − 0.1353) = 4.03 cm. 1.95 is the rate at 1 hour; 7.05 forgets to divide by k; 4.50 averages the initial and final rates, which overestimates because the rate falls exponentially.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.