ASRB NET — Farm Machinery & Power / Land & Water Management Engineering / Agricultural Structures & Process Engineering · India · Agricultural Scientists Recruitment Board (ICAR)
Original practice questions written to the published syllabus · not past papersASRB NET — Farm Machinery & Power / Land & Water Management Engineering / Agricultural Structures & Process Engineering is a specialist certification exam run by Agricultural Scientists Recruitment Board (ICAR), for candidates in India. NET: 150 MCQs, 150 marks, 2 hours, −1/3 per wrong answer, English/Hindi, PG level. Combined NET/ARS/SMS/STO recruitment runs prelims, mains and interview.
Official site: pw.live.
We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.
Same ground as AICE at a similar depth, with more recall of definitions, classification systems and measurement methods.
The soil an engineer tills, irrigates, drains and builds on: its physical, water and chemical properties.
Our 57 ASRB NET questions in this subject: 3 easy, 37 medium, 17 hard, across 9 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ASRB NET and are not shown on any other exam's page.
Two soils have the same mineralogy. Soil X has a higher organic matter content than soil Y. Compared with soil Y, soil X will most likely have:
D. Lower particle density and lower bulk density
Organic matter has a particle density of about 1.2–1.5 g/cm³, so it lowers the soil's average particle density; it also promotes aggregation and pore space, lowering bulk density. Neither density rises with more organic matter.
The least limiting water range (LLWR) narrows the classical available water range by taking into account:
C. Aeration at the wet end and soil penetration resistance at the dry end
LLWR (da Silva, Kay and Perfect, 1994) uses as the upper limit the wetter of field capacity or the water content at which air-filled porosity falls to a critical value (often 10%), and as the lower limit the drier of wilting point or the water content at which penetration resistance reaches a critical value (often about 2 MPa). It shrinks with compaction; the other pairs are not its definition.
Hydraulic conductivity K and intrinsic permeability k are related by K = kρg/μ. If the same soil is tested with water at 30 °C instead of 10 °C, K will:
C. Increase, because the viscosity of water decreases as it warms
Water's viscosity falls by about 40% between 10 and 30 °C (1.31 to 0.80 mPa s) while its density changes by less than 1%, so K rises; this is why K is corrected to a standard temperature. k depends only on pore geometry, but K includes the fluid properties. Warm water holds less dissolved air, not more.
As a soil dries from saturation, its unsaturated hydraulic conductivity:
A. Falls steeply, often by several orders of magnitude, as the larger pores empty
Flow capacity depends roughly on the fourth power of pore radius, so emptying the large pores first cuts K(θ) drastically; it can fall by orders of magnitude between saturation and field capacity. Steeper gradients can raise flux but not conductivity; K is not constant to wilting point, and the decline is strongly non-linear.
For designing subsurface drain spacing, which field method is standard for measuring saturated hydraulic conductivity below a shallow water table?
C. Auger-hole method
The auger-hole method measures the rate of rise of water in a hole bored below the water table and gives K of a large soil volume at the depth that matters for drains. Ring and tension infiltrometers measure surface infiltration above the water table, and small cores in a laboratory permeameter often miss the macropores that dominate field flow.
Why is the electrical conductivity of the saturated paste extract (ECe) used as the reference measure of soil salinity rather than EC of a 1:5 extract?
D. Saturation water content tracks field water content fairly evenly across textures
The saturation percentage is roughly twice field capacity in many soils, so ECe tracks the salinity roots experience and crop tolerance data are tabulated against it. Wider ratios dilute the solution and dissolve more sparingly soluble salts, so conversions to ECe are soil-specific, not a fixed factor; a 1:5 extract is easy to measure.
Why does a soil's lime requirement depend on its CEC and organic matter, and not just on its measured pH?
A. Reserve acidity on the colloids far exceeds active acidity and buffers pH change
Most soil acidity is held on the exchange complex and pH-dependent sites (reserve acidity), far exceeding the H⁺ in solution; a soil with more clay and humus has more reserve acidity and needs more lime for the same pH change. Electrode error, carbonate in acid soils and insoluble organic salts are not the reason.
Under the USSL Handbook 60 convention, a soil is classed as sodic when its ESP exceeds 15. Which alternative criterion is used in Australian practice?
A. ESP above 6
Australian classification (following Northcote and Skene) treats soils with ESP above 6 as sodic, recognising that dispersion problems begin well below ESP 15 in low-salinity conditions; some authorities use SAR 13 in place of ESP 15. ESP 25, SAR 30 and ECe 15 are not the standard alternative thresholds.
In laboratory determination of ESP, exchangeable sodium is obtained by:
B. Ammonium acetate-extractable sodium minus the soluble sodium of the saturation extract
Ammonium acetate extracts both exchangeable and soluble sodium; subtracting soluble sodium (from the saturation extract) leaves exchangeable Na, which is divided by CEC. Exchangeable sodium is not water-soluble, SAR/CEC has no meaning, and acid digestion measures total sodium including that in minerals.
Why is subsurface drainage usually needed when reclaiming a saline soil by leaching in an irrigated area with a shallow water table?
C. To carry leached salts away and keep the water table below capillary reach
Leaching only works if the salty water can leave the root zone; with a shallow water table it simply raises the table, and capillary rise then brings salts back. Drains do not supply calcium, should lower rather than raise the water table, and salts are not removed by oxidation.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.