ASRB NET — Farm Machinery & Power / Land & Water Management Engineering / Agricultural Structures & Process Engineering · India · Agricultural Scientists Recruitment Board (ICAR)
Original practice questions written to the published syllabus · not past papersASRB NET — Farm Machinery & Power / Land & Water Management Engineering / Agricultural Structures & Process Engineering is a specialist certification exam run by Agricultural Scientists Recruitment Board (ICAR), for candidates in India. NET: 150 MCQs, 150 marks, 2 hours, −1/3 per wrong answer, English/Hindi, PG level. Combined NET/ARS/SMS/STO recruitment runs prelims, mains and interview.
Official site: pw.live.
We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.
Post-harvest operations, engineering properties, process equipment design and material handling at PG level, with emphasis on Indian practice: LSU and recirculating dryers, hot-soak parboiling, rubber-roll and disc huskers, dhal milling pretreatments, expellers and solvent plants.
Moisture, drying, parboiling, milling, cleaning, size reduction and conveying of grains, pulses and oilseeds.
Our 54 ASRB NET questions in this subject: 17 easy, 29 medium, 8 hard, across 12 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ASRB NET and are not shown on any other exam's page.
Using the Henderson equation 1 − RH = exp(−c·T·Mⁿ) with hypothetical constants c = 2.0 × 10⁻⁵ and n = 2 (T in K, M in % dry basis), the EMC at 300 K and 70% RH is closest to
C. 14.2% db
Mⁿ = −ln(1 − 0.70)/(c·T) = 1.2040/(0.0060) = 200.7, so M = √200.7 = 14.17% db. Using ln(0.70) instead of ln(0.30) gives 7.7%; forgetting the square root gives 201%; 12.4% is the wet-basis value mislabelled as dry basis.
A rice mill notices head rice yield fell by several points after the dryer operator raised air temperature and ran each batch straight through to 14% moisture. The most likely cause and remedy are
B. stress fissures from steep moisture gradients; use cooler air and dry in passes with tempering
Fast, hot, uninterrupted drying creates moisture gradients that fissure rice kernels, which then break in milling. The husker and whitener were unchanged, so they are not the first suspects.
In a cross-flow column dryer, the grain at the discharge typically shows
A. a moisture gradient across the column, with grain nearest the air inlet overdried
Grain on the inlet side meets the hottest, driest air for the whole residence time. Mixed-flow designs such as the LSU dryer reduce this non-uniformity.
The purifier in a wheat mill
B. grades and cleans middlings on an oscillating sieve with an upward air current
Air lifts light bran particles off the sieve while endosperm particles are graded by size; purified middlings go to the reduction rolls.
Compared with the break system, the reduction system of a roller flour mill uses
A. smooth rolls with a smaller speed differential
Reduction rolls gently crush purified middlings to flour; a small differential (roughly 1.25–1.5:1) limits bran shattering and starch damage.
A specific-gravity (gravity) table is most useful for separating
D. same-size particles of different density, such as sound and insect-damaged seed
Air stratifies the bed and deck vibration moves heavy particles uphill while light ones flow down. Size must be similar, so the feed is sized first.
To remove chaff and dust from grain with an aspirator, the air velocity should be set
B. above the terminal velocity of light impurities but below that of the grain
Only particles whose terminal velocity is below the air velocity are lifted. Too high a velocity carries grain away; too low leaves the chaff.
By Harrington's rules of thumb, lowering seed moisture by 2 percentage points and storage temperature by 10 °C would multiply expected storage life by roughly
A. 16
Moisture: 2 × 2 = 4; temperature: each 5 °C fall doubles life, so 10 °C gives 4; combined 4 × 4 = 16. Adding the factors (4 + 4 = 8) is the common slip. 6 adds the moisture factor to a single temperature doubling (4 + 2).
The usual order of operations in seed processing is
D. receiving, pre-cleaning, drying, basic cleaning, upgrading, treating, bagging
Seed is pre-cleaned so it dries evenly, cleaned on an air-screen cleaner, upgraded, and treated last so that protectant is not wasted on rejects.
A magnetic seed separator (with iron powder) separates seeds by
B. surface texture: iron powder sticks to rough or sticky coats, which a magnet then draws off
Seeds are mixed with fine iron powder and moisture; rough-coated weed seeds hold the powder and are removed by a magnetic drum, while smooth crop seeds do not.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.