GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papersGATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.
Source: gate2026.iitg.ac.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Section 2 Food Microbiology: characteristics of spoilage organisms and pathogens, growth and death kinetics, serial dilution, spoilage of specific foods and toxins from microbes. Expect numerical-answer items on generation time, counts from dilution plates and log reductions, and multiple-select items on which organisms grow under given aw, pH or temperature.
Which microorganisms grow in which foods and why, the pathogens and toxins behind food-borne disease, and the methods — conventional, rapid and molecular — used to find them. The PG units on predictive microbiology and genomic surveillance carry it beyond the hygiene-focused milk and meat microbiology in the Veterinary track (milk-meat-hygiene-food-safety).
Our 100 GATE XE questions in this subject: 38 easy, 44 medium, 18 hard, across 14 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE XE and are not shown on any other exam's page.
A food has a water activity of 0.85. At what relative humidity of the surrounding air will it neither gain nor lose moisture?
C. 85%
Equilibrium relative humidity = aw × 100 = 0.85 × 100 = 85%. 15% is 100 − 85, a confusion with the moisture deficit; 0.85% forgets the factor of 100.
Which characteristic helps distinguish E. coli O157:H7 from most other E. coli on selective plating media?
B. It does not ferment sorbitol within 24 hours
Most O157:H7 strains are sorbitol non-fermenting and β-glucuronidase negative, the basis of sorbitol MacConkey media. All E. coli ferment glucose and are oxidase negative.
D121 for proteolytic C. botulinum spores is taken as 0.21 min. What minimum F0 does a 12D botulinum cook require?
C. 2.52 min
F0 = 12 × D121 = 12 × 0.21 = 2.52 min. 12.0 min confuses 12D with 12 minutes; 1.75 min divides 0.21 by 0.12.
A three-tube MPN test using 0.1, 0.01 and 0.001 g of sample gives the combination 3-1-0, for which the table value is 43 MPN/g. If the same combination had been obtained with 0.01, 0.001 and 0.0001 g, the result would be:
D. 430 MPN/g
Each sample amount is ten times smaller, so the estimate is ten times larger: 43 × 10 = 430 MPN/g. Keeping 43 ignores the change in dilutions.
In a sandwich ELISA for a bacterial antigen, the antigen is detected by:
B. A capture antibody on the surface and a second enzyme-labelled antibody producing colour
In a sandwich ELISA the antigen is held between a capture antibody and an enzyme-labelled detection antibody; the enzyme converts a substrate to colour.
Which reagent is used in viability PCR to reduce amplification of DNA from dead cells?
A. Propidium monoazide
Propidium monoazide enters cells with damaged membranes and, after light activation, binds DNA so it cannot be amplified. Uracil-N-glycosylase prevents carry-over contamination instead.
Cells in a biofilm are much more resistant to sanitisers than the same cells in suspension mainly because:
A. The matrix limits penetration, deep cells grow slowly and persister cells survive
The extracellular matrix binds and blocks active chemicals, slow-growing cells deep in the biofilm are less susceptible, and persisters survive.
In an ICMSF two-class sampling plan, the symbol c means:
D. The maximum number of sample units allowed to exceed m
n is the number of units tested, m the limit, c the maximum number of defective units allowed; M is used only in three-class plans.
Swollen cans are described in increasing order of severity as:
C. Flipper, springer, soft swell, hard swell
A flipper's end flips out when struck; a springer's end springs back when pressed; a soft swell can be pushed in; a hard swell cannot.
Which of the following is a primary growth model?
D. Baranyi and Roberts model
Baranyi and Roberts describes numbers against time (primary). The square-root, gamma and cardinal parameter models describe how growth parameters depend on conditions (secondary).
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.