LAISHA
Open Laisha

GATE XE Meat, Poultry & Egg Products Technology: practice questions

GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
40written to this exam in this subject
10syllabus units

About GATE XE

GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Meat, Poultry & Egg Products Technology in GATE XE

Section 1 names post-mortem changes in meat; Section 3 names canning, drying and freezing of meat and egg powder. Expect conceptual items on glycolysis and pH fall, rigor and cold shortening, myoglobin states, PSE and DFD, nitrite and cured colour, and numerical-answer mass balances: dried meat yield, salt from brine injection, egg powder yield, drip loss and the Haugh unit.

Processed meat, poultry and egg products: meat as a raw material, curing and smoking chemistry, emulsion and restructured products, canned and dried meats, poultry further processing, and egg quality and egg products. Slaughter, inspection and abattoir design are in the Veterinary track (meat-science-abattoir, milk-meat-hygiene-food-safety).

Our 40 GATE XE questions in this subject: 8 easy, 22 medium, 10 hard, across 10 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XE and are not shown on any other exam's page.

Question 1 · medium

Cold shortening is most likely when

  1. Post-rigor beef is frozen at −30 °C
  2. Pre-rigor beef is chilled below 10 °C
  3. Pork carcasses are held at 15 °C for 4 h
  4. Poultry is aged for 24 h at 2 °C
Answer and working

B. Pre-rigor beef is chilled below 10 °C

Chilling pre-rigor beef or lamb rapidly to low temperature, while ATP is still present, causes strong contraction and toughness. Freezing post-rigor meat, moderate holding and normal ageing do not cause cold shortening.

Question 2 · easy

The bright cherry-red colour of fresh meat exposed to air is due to

  1. Oxymyoglobin
  2. Metmyoglobin
  3. Deoxymyoglobin
  4. Nitrosyl haemochrome
Answer and working

A. Oxymyoglobin

Oxygen binds ferrous myoglobin to form bright red oxymyoglobin. Metmyoglobin (ferric) is brown, deoxymyoglobin is purplish, and nitrosyl haemochrome is the pink of cooked cured meat.

Question 3 · medium

Water-holding capacity of meat is lowest near pH

  1. 6.5–7.0
  2. 3.0–3.5
  3. 5.0–5.2
  4. 7.5–8.0
Answer and working

C. 5.0–5.2

The main myofibrillar proteins have their isoelectric point near pH 5.0–5.2, where net charge is minimal, filaments pack closely and water is lost. Moving pH away in either direction increases water holding.

Question 4 · medium

PSE pork results from

  1. High ultimate pH from glycogen depletion
  2. Excessive bleeding at slaughter
  3. Slow chilling of a low-glycogen carcass
  4. Rapid pH fall while the carcass is still hot
Answer and working

D. Rapid pH fall while the carcass is still hot

Fast glycolysis gives low pH at high temperature, denaturing proteins and causing pale colour, softness and drip. High ultimate pH from depleted glycogen gives DFD meat, not PSE; bleeding is not the cause.

Question 5 · medium

Beef from cattle exhausted by long transport and mixing before slaughter is likely to be

  1. Pale, soft and exudative
  2. Dark, firm and dry
  3. Bright red and tender
  4. Green and slimy
Answer and working

B. Dark, firm and dry

Pre-slaughter stress depletes glycogen, so little lactic acid forms and the ultimate pH stays high, giving dark cutting (DFD) beef. PSE needs rapid pH fall; the other descriptions are unrelated.

Question 6 · medium

50 kg of lean meat at 72% moisture (wet basis) is dried to 20% moisture (wet basis). Ignoring fat and solid losses, the dried yield is

  1. 14.0 kg
  2. 26.0 kg
  3. 11.2 kg
  4. 17.5 kg
Answer and working

D. 17.5 kg

Solids = 50 × 0.28 = 14 kg; product = 14 ÷ 0.80 = 17.5 kg. 14.0 kg is bone-dry solids; 26.0 kg subtracts percentages (50 × 0.52); 11.2 kg multiplies 14 by 0.80.

Question 7 · medium

An egg weighs 60 g and its thick albumen height is 7.0 mm. Using HU = 100 log10(H − 1.7 W^0.37 + 7.57), its Haugh unit value is about

  1. 83
  2. 58
  3. 116
  4. 70
Answer and working

A. 83

W^0.37 = 60^0.37 = 4.55; 1.7 × 4.55 = 7.73; 7.0 − 7.73 + 7.57 = 6.84; 100 × log10(6.84) = 83.5. 58 corresponds to an albumen height of 4.0 mm; 116 ignores the weight term (log10 14.57); 70 has no consistent basis.

Question 8 · easy

A liquid whole egg pasteuriser must give a 5-log reduction of Salmonella. If the D-value at the holding temperature is 0.5 min, the minimum holding time is

  1. 2.5 min
  2. 0.1 min
  3. 5.0 min
  4. 10 min
Answer and working

A. 2.5 min

Each D-value gives one tenfold (one-log) reduction, so a 5-log kill needs 5 × 0.5 = 2.5 min at constant temperature. 0.1 min divides D by the number of logs. 5.0 min doubles the requirement. 10 min multiplies 5 by 2 as though D were 2 min. Liquid egg pasteurisation is limited by the onset of protein coagulation, so time must be exact rather than generous.

Question 9 · hard

Hot boning, in which beef is removed from the carcass before chilling, is attractive to processors but needs care because

  1. It saves refrigeration but pre-rigor muscle can cold-shorten
  2. It raises the ultimate pH and always gives DFD meat
  3. It prevents rigor mortis from occurring at all
  4. It increases the chilling load by exposing bone
Answer and working

A. It saves refrigeration but pre-rigor muscle can cold-shorten

Bone and trim are removed before chilling, so less mass is cooled and chiller space and energy fall. But the excised pre-rigor muscles are unrestrained by the skeleton and chill fast, so they may cold-shorten and toughen unless electrical stimulation or controlled conditioning is used. Ultimate pH depends on glycogen, not boning method. Rigor still develops. Removing bone reduces rather than raises chilling load.

Question 10 · medium

Retail beef packed in high-oxygen modified atmosphere (about 70 to 80% O₂ with CO₂) stays bright red for longer, but its main drawback is

  1. Formation of carboxymyoglobin in the meat
  2. Faster lipid oxidation and rancid flavour
  3. Conversion of myoglobin to deoxymyoglobin
  4. Growth of strict anaerobes such as clostridia
Answer and working

B. Faster lipid oxidation and rancid flavour

High oxygen drives a deep layer of oxymyoglobin, delaying browning, but the same oxygen promotes lipid oxidation, giving rancid or warmed-over flavours and premature browning on cooking. Carboxymyoglobin needs carbon monoxide, not oxygen. Deoxymyoglobin forms in low-oxygen or vacuum packs. Strict anaerobes are suppressed, not favoured, by a high-oxygen atmosphere.

A study plan for Meat, Poultry & Egg Products Technology in GATE XE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (73% of the 40 questions): Conversion of muscle to meat: rigor mortis, pH fall and ageing (8, 20%); Meat quality: colour, water-holding capacity, PSE and DFD (8, 20%); Canning, drying and freezing of meat (7, 18%); Egg preservation and egg products: liquid, frozen and dried egg (6, 15%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Egg structure, composition and quality measurement (4, 10%); Curing chemistry: nitrite, colour and safety (3, 8%); Comminuted and emulsion products: sausages (1, 3%); Poultry further processing (1, 3%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Smoking of meat and fish (1, 3%); Structure and composition of muscle (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Structure and composition of muscle (1 hard of 1), Curing chemistry: nitrite, colour and safety (2 hard of 3), Canning, drying and freezing of meat (2 hard of 7).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Poultry further processing (1 easy of 1); Egg preservation and egg products: liquid, frozen and dried egg (2 easy of 6).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XE Meat, Poultry & Egg Products Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.