GATE XE Food Safety Management Systems: HACCP, PRPs, ISO 22000 & GFSI Schemes: practice questions
GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papers
10worked here, free
46written to this exam in this subject
14syllabus units
About GATE XE
GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Food Safety Management Systems: HACCP, PRPs, ISO 22000 & GFSI Schemes in GATE XE
Section 3 names HACCP among food standards. Expect short MCQs on the seven principles, the order of the twelve steps, definitions of CCP and critical limit, and the difference between verification and validation.
Building, running and auditing a food safety management system: prerequisite programmes and good manufacturing practice, the seven HACCP principles applied in depth, preventive controls, ISO 22000 and the GFSI-benchmarked certification schemes, food defence, food safety culture, traceability and recall, and auditing practice.
Our 46 GATE XE questions in this subject: 22 easy, 20 medium, 4 hard, across 14 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE XE and are not shown on any other exam's page.
Question 1 · easy
Which ISO document gives prerequisite programmes for food manufacturing?
ISO/TS 22002-1
ISO 14001
ISO/IEC 17025
ISO 9001
Answer and working
A. ISO/TS 22002-1
ISO/TS 22002-1 covers food manufacturing PRPs; ISO 9001 is quality management, ISO/IEC 17025 laboratory competence, ISO 14001 environmental management.
Question 2 · medium
According to the 2020 Codex text, some good hygiene practices need greater attention. This means they:
Must always be redesignated as CCPs with critical limits and continuous monitoring
They are monitored and verified more closely but remain GHPs
Apply only to primary production and not to manufacturing or catering
Can be ignored by small businesses because they are optional recommendations
Answer and working
B. They are monitored and verified more closely but remain GHPs
Examples include cleaning of a slicer for ready-to-eat meat; such GHPs get closer monitoring and verification but remain GHPs.
Question 3 · medium
Under Codex, which statement correctly distinguishes validation from verification?
Validation is done by auditors; verification is done by the competent authority
Validation: evidence the control is capable; verification: evidence it is operating as intended
Validation applies only to PRPs; verification applies only to CCPs in the plan
Validation is daily record review; verification is the initial scientific study of the control measure
Answer and working
B. Validation: evidence the control is capable; verification: evidence it is operating as intended
Validation gives evidence of capability before implementation or after change; verification uses audits, record review, calibration and testing to confirm operation.
Question 4 · easy
Which step is most often a critical control point in a cooked meat process?
Washing of the floors at shift end
Receipt of packaging materials
The cooking step with a time-temperature critical limit
Storage of cleaning chemicals
Answer and working
C. The cooking step with a time-temperature critical limit
Cooking is designed to eliminate pathogens and is the classic CCP; the others are PRPs.
Question 5 · medium
Validation of a control measure is required:
Before implementation and after relevant changes
Only when a customer complaint is received about the product
Only once, when the plant is first built, and never again
Every day, as part of routine CCP monitoring
Answer and working
A. Before implementation and after relevant changes
Validation provides evidence that a control can work; it must be repeated when anything relevant changes.
Question 6 · easy
Which is a type of preventive control named in the FDA preventive controls rule?
Supply-chain control
Marketing control
Shelf-display control
Price control
Answer and working
A. Supply-chain control
Preventive controls include process, food allergen, sanitation and supply-chain controls, plus a recall plan.
Question 7 · medium
The two plan-do-check-act cycles in ISO 22000:2018 refer to:
The management system and operational planning and control
Internal audit and external certification audit
Raw material receipt and finished product dispatch
Quality management and environmental management
Answer and working
A. The management system and operational planning and control
The outer cycle is the management system; the inner cycle is the operational hazard control cycle in clause 8.
Question 8 · easy
Food safety culture is defined as:
Shared values and norms shaping food safety behaviour
The annual training hours recorded for each employee
The microbial cultures used as starters in fermented foods
The set of documents that make up the HACCP plan
Answer and working
A. Shared values and norms shaping food safety behaviour
Culture is about mind-set and behaviour across the organisation, not documents or starter cultures.
Question 9 · medium
Which action by leaders most strongly shapes food safety culture?
Displaying the food safety policy in the reception area
Holding a single annual training day for all staff
Increasing the number of documented procedures
Choosing safety over output when the two conflict
Answer and working
D. Choosing safety over output when the two conflict
Behaviour of leaders in real decisions sets norms more than posters, documents or one-off training.
Question 10 · easy
Which allergen was added to the US list of major food allergens from 2023?
Lupin
Sesame
Celery
Mustard
Answer and working
B. Sesame
The FASTER Act added sesame as the ninth major allergen; mustard, celery and lupin are on the EU list.
A study plan for Food Safety Management Systems: HACCP, PRPs, ISO 22000 & GFSI Schemes in GATE XE
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (50% of the 46 questions): HACCP: preliminary steps and hazard analysis (6, 13%); Codex General Principles of Food Hygiene (5, 11%); HACCP: critical control points, critical limits and monitoring (5, 11%); Operational prerequisite programmes and preventive controls (4, 9%); Allergen management programmes (3, 7%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Food defence and vulnerability assessment (3, 7%); Good manufacturing and good hygiene practices (3, 7%); HACCP: corrective actions, verification, validation and records (3, 7%); ISO 22000 food safety management system (3, 7%); Prerequisite programmes (3, 7%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Traceability, withdrawal and recall (3, 7%); Food safety culture (2, 4%); Internal and third-party auditing (2, 4%); GFSI-benchmarked schemes: FSSC 22000, BRCGS and SQF (1, 2%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: HACCP: critical control points, critical limits and monitoring (2 hard of 5), Traceability, withdrawal and recall (1 hard of 3), HACCP: preliminary steps and hazard analysis (1 hard of 6).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Internal and third-party auditing (2 easy of 2); Allergen management programmes (2 easy of 3).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.