LAISHA
Open Laisha

GATE XE Dairy Science & Technology for Food Technologists: practice questions

GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
57written to this exam in this subject
11syllabus units

About GATE XE

GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Dairy Science & Technology for Food Technologists in GATE XE

Section 3 lists milk and milk products processing: pasteurisation, sterilisation, cream, butter, ghee, ice cream, cheese and milk powder. Expect conceptual items on HTST and UHT, the phosphatase test, homogenisation and Stokes' law, churning, rennet action, yoghurt cultures and spray drying, and numerical-answer items on standardisation, cream separation, regeneration efficiency, overrun, butter and powder yields.

The dairy course taught inside food technology degrees: milk as a raw material, fluid-milk processing, the main dairy products, and dairy ingredients (powders, whey and milk proteins) used across the food industry. For depth in dairy chemistry, microbiology and plant engineering see the Dairy Technology track; for Indian traditional dairy products and FSSAI dairy standards see Veterinary's milk-products-technology.

Our 57 GATE XE questions in this subject: 14 easy, 33 medium, 10 hard, across 11 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XE and are not shown on any other exam's page.

Question 1 · easy

By Stokes' law, if the diameter of a fat globule doubles, its rising velocity

  1. Increases four times
  2. Doubles
  3. Halves
  4. Stays the same
Answer and working

A. Increases four times

Velocity is proportional to the square of the diameter, so doubling it gives 2² = 4 times the velocity. Proportional, inverse and no change are the usual slips.

Question 2 · medium

In-container sterilised milk differs from UHT milk in having

  1. A darker colour and stronger cooked flavour
  2. A shorter shelf life at room temperature
  3. No heat treatment after filling
  4. A requirement for refrigerated storage
Answer and working

A. A darker colour and stronger cooked flavour

Longer heating in the bottle gives more Maillard browning and cooked, caramel flavour. Both are shelf-stable at room temperature, and in-container milk is heated after filling.

Question 3 · easy

Homogenisation of milk mainly

  1. Kills pathogenic bacteria
  2. Reduces fat globule size
  3. Removes milk fat
  4. Increases lactose content
Answer and working

B. Reduces fat globule size

It forces milk through a narrow gap at high pressure, breaking globules to below about 1–2 µm. It is not a kill step, does not remove fat and does not change lactose.

Question 4 · medium

After homogenisation, the new fat globule surfaces are covered mainly by

  1. The original globule membrane
  2. Lactose molecules
  3. Casein and whey proteins
  4. Free fatty acids
Answer and working

C. Casein and whey proteins

The original membrane cannot cover the much larger area, so milk proteins, mainly casein micelles and fragments plus whey proteins, adsorb onto the new surfaces. Lactose and free fatty acids do not form the coating.

Question 5 · medium

Homogenisation pressures for milk in the first stage are commonly in the range of

  1. 0.1–0.5 MPa
  2. 100–250 MPa
  3. 10–25 MPa
  4. 1–2 kPa
Answer and working

C. 10–25 MPa

First-stage pressures of roughly 10–25 MPa (100–250 bar) are common. 100–250 MPa is the range of high-pressure processing, and kPa values are far too low.

Question 6 · easy

Butter is formed during churning by

  1. Precipitation of casein at pH 4.6
  2. Crystallisation of lactose
  3. Phase inversion to water-in-fat
  4. Evaporation of the cream water
Answer and working

C. Phase inversion to water-in-fat

Agitation destabilises the globules, which clump until the cream emulsion inverts from fat-in-water to water-in-fat butter. Casein precipitation, lactose crystallisation and evaporation are not the mechanism.

Question 7 · medium

A litre of ice cream mix weighs 1.10 kg and a litre of the frozen ice cream weighs 0.55 kg. The overrun is

  1. 50%
  2. 100%
  3. 200%
  4. 55%
Answer and working

B. 100%

Overrun = (1.10 − 0.55) ÷ 0.55 × 100 = 100%. 50% divides by the mix mass (0.55 ÷ 1.10); 200% and 55% have no consistent basis.

Question 8 · medium

Evaporated milk differs from sweetened condensed milk in that evaporated milk

  1. Is preserved by added sugar
  2. Is not concentrated at all
  3. Is unsweetened and sterilised
  4. Contains no milk fat
Answer and working

C. Is unsweetened and sterilised

Evaporated milk is concentrated, unsweetened milk sterilised in the can or by UHT. Sweetened condensed milk relies on sugar; both are concentrated and contain fat.

Question 9 · hard

An HTST pasteuriser handles 12,000 L/h with a 15 s hold. If flow in the holding tube is laminar and the tube is sized so that the fastest particle is held 15 s, the holding tube volume must be

  1. 100 L
  2. 50 L
  3. 25 L
  4. 200 L
Answer and working

A. 100 L

Flow is 12,000/3,600 = 3.33 L/s, so a 15 s mean residence needs 50 L. In laminar flow the centre-line velocity is twice the mean, so the fastest particle would get only 7.5 s; doubling the volume to 100 L restores 15 s for it. 50 L protects only the average particle. 25 L halves instead of doubling. 200 L applies the factor of two twice.

Question 10 · easy

9 g of yoghurt needs 6.0 mL of 0.1 N NaOH to reach the phenolphthalein end point. Its titratable acidity as lactic acid (90 mg per meq) is

  1. 0.60%
  2. 0.06%
  3. 6.0%
  4. 0.90%
Answer and working

A. 0.60%

Milliequivalents of acid = 6.0 × 0.1 = 0.6 meq, equal to 0.6 × 90 = 54 mg lactic acid. As a percentage of 9 g: 0.054/9 × 100 = 0.60%, which is far above fresh milk's 0.14 to 0.16%. 0.06% and 6.0% shift the decimal. 0.90% ignores the sample mass and simply scales the 90 mg factor.

A study plan for Dairy Science & Technology for Food Technologists in GATE XE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (49% of the 57 questions): Pasteurisation, UHT and sterilised milks (9, 16%); Cheese: coagulation, cheddar and mozzarella principles (7, 12%); Clarification, separation and standardisation (6, 11%); Ice cream and frozen desserts (6, 11%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Milk powders and infant formula basics (6, 11%); Condensed and evaporated milk (5, 9%); Cream, butter and ghee (5, 9%); Homogenisation (5, 9%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Fermented milks (4, 7%); Milk reception, quality testing and platform tests (2, 4%); Whey and milk-protein ingredients (2, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Clarification, separation and standardisation (2 hard of 6), Milk powders and infant formula basics (2 hard of 6), Cheese: coagulation, cheddar and mozzarella principles (2 hard of 7).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Cream, butter and ghee (3 easy of 5); Fermented milks (2 easy of 4).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XE Dairy Science & Technology for Food Technologists

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.