LAISHA
Open Laisha

ICAR AICE-JRF/SRF Dairy Science & Technology for Food Technologists: practice questions

ICAR AICE-JRF/SRF (PhD) — Food Processing Technology, Food Safety & Quality, Processing and Food Engineering · India · ICAR through the National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
42written to this exam in this subject
13syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD) — Food Processing Technology, Food Safety & Quality, Processing and Food Engineering is a PhD, fellowship and lectureship exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Dairy Science & Technology for Food Technologists in ICAR AICE-JRF/SRF

35.a Unit 3 names dairy processing. Expect deeper questions on heat stability and age gelation, membrane fractionation of milk and whey, powder functionality and WPNI, infant formula hazards, cheese yield, and CIP validation.

The dairy course taught inside food technology degrees: milk as a raw material, fluid-milk processing, the main dairy products, and dairy ingredients (powders, whey and milk proteins) used across the food industry. For depth in dairy chemistry, microbiology and plant engineering see the Dairy Technology track; for Indian traditional dairy products and FSSAI dairy standards see Veterinary's milk-products-technology.

Our 42 ICAR AICE-JRF/SRF questions in this subject: 1 easy, 21 medium, 20 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

Homogenised milk in clear bottles under shop lighting develops off-flavour faster than unhomogenised milk mainly because

  1. It contains more lactose
  2. It oxidises more in light
  3. It is pasteurised at a higher temperature
  4. It has a lower fat content
Answer and working

B. It oxidises more in light

Homogenised milk is more susceptible to light-induced (sunlight) and oxidised flavours. Lactose, pasteurisation temperature and fat content are not changed by homogenisation.

Question 2 · medium

Ice cream kept in a shop freezer whose temperature cycles develops a coarse, icy texture because

  1. Lactose crystallises from the unfrozen phase
  2. Ice recrystallisation
  3. Air escapes and the overrun rises
  4. Fat crystals melt and leave the product
Answer and working

B. Ice recrystallisation

Heat shock melts the smallest ice crystals and refreezes the water onto larger ones, coarsening the texture. Lactose crystallisation gives sandiness, overrun falls rather than rises, and fat does not leave.

Question 3 · medium

A stabilising salt such as disodium phosphate is added to evaporated milk in an amount set by

  1. The fat content alone
  2. The sugar ratio
  3. A pilot sterilisation test
  4. The overrun of the batch
Answer and working

C. A pilot sterilisation test

The heat stability of each batch varies, so samples with different salt additions are test-sterilised and the dose is set from the result, within legal limits. Fat, sugar ratio and overrun do not determine it.

Question 4 · medium

Skim milk powder for bread making is usually specified as high-heat powder because

  1. High-heat powder dissolves faster
  2. It contains more lactose
  3. Undenatured whey proteins weaken dough
  4. It is cheaper to dry
Answer and working

C. Undenatured whey proteins weaken dough

Undenatured whey proteins, abundant in low-heat powder, reduce loaf volume; high-heat treatment denatures them. Solubility, lactose and drying cost are not the reason.

Question 5 · hard

The organism of greatest concern in powdered infant formula, because it survives in dry powder and causes severe illness in newborns, is

  1. Listeria monocytogenes
  2. Clostridium perfringens
  3. Streptococcus thermophilus
  4. Cronobacter sakazakii
Answer and working

D. Cronobacter sakazakii

Cronobacter sakazakii, with Salmonella, is the critical hazard in powdered infant formula. Listeria is a concern in moist ready-to-eat foods, C. perfringens in cooked meats, and S. thermophilus is a harmless yoghurt culture.

Question 6 · medium

Sodium caseinate is made by

  1. Ultrafiltering sweet whey
  2. Coagulating milk with rennet
  3. Neutralising acid casein with alkali
  4. Drying whey with salt
Answer and working

C. Neutralising acid casein with alkali

Acid casein, precipitated at pH 4.6, is dissolved by neutralising with sodium hydroxide and spray dried. Ultrafiltered whey gives WPC, rennet gives rennet casein, and salted whey is not caseinate.

Question 7 · medium

ATP bioluminescence swabs are used after CIP to

  1. Measure the strength of the caustic
  2. Check for organic residue
  3. Identify the bacteria on the surface
  4. Test the water hardness
Answer and working

B. Check for organic residue

The test detects ATP from residues and microorganisms, giving a rapid check of cleanliness. It does not measure detergent strength, identify species or test hardness.

Question 8 · hard

Milk leaving an HTST pasteuriser running correctly at 72 °C for 15 s tests positive for alkaline phosphatase. The most likely cause is

  1. A holding tube that is too long
  2. Over-homogenisation of the milk
  3. A fat content below 3%
  4. Raw milk leaking across the plates
Answer and working

D. Raw milk leaking across the plates

A pinhole or gasket failure in the regeneration section lets raw milk leak into pasteurised milk, which then tests positive. A longer holding tube gives more heat, and homogenisation and fat content do not restore phosphatase activity.

Question 9 · hard

Whey powder that becomes sticky and cakes in humid storage does so mainly because

  1. Whey proteins denature at room temperature
  2. Milk fat melts and binds the particles
  3. Amorphous lactose absorbs water and crystallises
  4. Minerals in the powder crystallise first
Answer and working

C. Amorphous lactose absorbs water and crystallises

Spray drying leaves lactose as an amorphous glass; water uptake lowers its glass transition so it becomes sticky and then crystallises, cementing particles. Pre-crystallising lactose before drying makes non-caking whey powder. Proteins, fat and minerals are not the main cause.

Question 10 · hard

CIP records show the caustic stage of a pasteuriser clean reached only a fraction of the specified concentration. The correct action is to

  1. Accept it if the final rinse ran
  2. Treat it as failed and reclean
  3. Increase acid strength next time
  4. Release product made afterwards
Answer and working

B. Treat it as failed and reclean

A cleaning step outside its validated limits is a deviation: the equipment is recleaned and verified before production, and any product made after a failed clean is held and assessed. Relying on the rinse, adjusting the acid or releasing product would leave the cause uncorrected.

A study plan for Dairy Science & Technology for Food Technologists in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (60% of the 42 questions): Homogenisation (6, 14%); Cheese: coagulation, cheddar and mozzarella principles (5, 12%); Milk powders and infant formula basics (5, 12%); Whey and milk-protein ingredients (5, 12%); Dairy plant cleaning and sanitation (4, 10%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Composition and physicochemical properties of milk (3, 7%); Pasteurisation, UHT and sterilised milks (3, 7%); Clarification, separation and standardisation (2, 5%); Condensed and evaporated milk (2, 5%); Cream, butter and ghee (2, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Fermented milks (2, 5%); Ice cream and frozen desserts (2, 5%); Milk reception, quality testing and platform tests (1, 2%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Clarification, separation and standardisation (2 hard of 2), Cream, butter and ghee (2 hard of 2), Pasteurisation, UHT and sterilised milks (2 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Cheese: coagulation, cheddar and mozzarella principles (1 easy of 5).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Dairy Science & Technology for Food Technologists

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.