LAISHA
Open Laisha

GATE XE Food Additives & Ingredient Technology: practice questions

GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
28written to this exam in this subject
11syllabus units

About GATE XE

GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Food Additives & Ingredient Technology in GATE XE

Section 3 names addition of preservatives and food additives. Expect MCQs on functional classes, preservative mechanisms and pH dependence, antioxidants, emulsifier HLB, gelling agents and sweeteners, and NATs on undissociated acid fraction, blend HLB and sweetener equivalence.

What each class of additive and ingredient does, how it is chosen and dosed, and how its safety is assessed and regulated: preservatives, antioxidants, emulsifiers, hydrocolloids, colours, sweeteners, flavour enhancers and processing aids.

Our 28 GATE XE questions in this subject: 15 easy, 9 medium, 4 hard, across 11 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XE and are not shown on any other exam's page.

Question 1 · easy

The acceptable daily intake of an additive is usually derived by dividing the NOAEL by:

  1. 10
  2. 1,000
  3. 100
  4. 2
Answer and working

C. 100

10 for species differences × 10 for individual variation.

Question 2 · easy

Weak-acid preservatives act mainly in their:

  1. Undissociated form
  2. Dissociated anion form
  3. Esterified form
  4. Oxidised form
Answer and working

A. Undissociated form

The neutral molecule crosses cell membranes.

Question 3 · medium

At pH equal to the pKa of a weak-acid preservative, the undissociated fraction is:

  1. 50%
  2. 91%
  3. 9%
  4. 100%
Answer and working

A. 50%

Undissociated fraction = 1/(1 + 10^0) = 0.5.

Question 4 · easy

Which is a natural antioxidant widely used in clean-label products?

  1. Rosemary extract
  2. Tert-butylhydroquinone
  3. Propyl gallate
  4. Butylated hydroxytoluene
Answer and working

A. Rosemary extract

Carnosic acid and carnosol are active.

Question 5 · easy

The reference sweetener with relative sweetness 1 is:

  1. Fructose
  2. Lactose
  3. Glucose
  4. Sucrose
Answer and working

D. Sucrose

Glucose is about 0.7.

Question 6 · easy

Monosodium glutamate gives which basic taste?

  1. Sour
  2. Sweet
  3. Umami
  4. Bitter
Answer and working

C. Umami

Identified by Ikeda in 1908.

Question 7 · easy

Which leavening agent is suitable only for thin, low-moisture products such as biscuits?

  1. Yeast
  2. Ammonium bicarbonate
  3. Baking powder
  4. Sodium bicarbonate
Answer and working

B. Ammonium bicarbonate

Ammonia escapes only from thin, dry products.

Question 8 · medium

Benzoic acid has pKa about 4.2. In a beverage at pH 3.2, the fraction present as undissociated (antimicrobially active) acid is about:

  1. 9%
  2. 1%
  3. 50%
  4. 91%
Answer and working

D. 91%

Henderson-Hasselbalch: undissociated fraction = 1 ÷ (1 + 10^(pH − pKa)) = 1 ÷ (1 + 10^−1) = 1 ÷ 1.1 ≈ 0.91. Weak-acid preservatives work best at low pH because the undissociated form crosses microbial membranes.

Question 9 · medium

An emulsifier with HLB value of 4-6 is best suited to stabilise:

  1. Gels
  2. Water-in-oil emulsions such as margarine
  3. Foams only
  4. Oil-in-water emulsions such as milk
Answer and working

B. Water-in-oil emulsions such as margarine

Low HLB emulsifiers are lipophilic and favour W/O emulsions; high HLB (8-18) favour O/W emulsions.

Question 10 · easy

Aspartame is unsuitable for baked goods because:

  1. It is too sweet
  2. It breaks down on prolonged heating and loses sweetness
  3. It caramelises
  4. It is insoluble
Answer and working

B. It breaks down on prolonged heating and loses sweetness

Aspartame, a dipeptide methyl ester, hydrolyses and cyclises at high temperature; sucralose is heat-stable and preferred for baking. Products with aspartame carry a phenylketonuria warning.

A study plan for Food Additives & Ingredient Technology in GATE XE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (50% of the 28 questions): Preservatives: benzoates, sorbates, sulphites, nitrites and natural antimicrobials (5, 18%); Emulsifiers and stabilisers (3, 11%); Hydrocolloids: starches, gums, pectins, carrageenan, alginates and gelatin (3, 11%); Safety evaluation: JECFA, ADI and good manufacturing practice (3, 11%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Sweeteners: nutritive and non-nutritive (3, 11%); Antioxidants: synthetic and natural (2, 7%); Definitions, classification and the INS/E-number system (2, 7%); Flavour enhancers and acidulants (2, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Food colours: synthetic and natural (2, 7%); Leavening agents, enzymes and processing aids (2, 7%); Fat replacers and sugar replacers (1, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Emulsifiers and stabilisers (1 hard of 3), Hydrocolloids: starches, gums, pectins, carrageenan, alginates and gelatin (1 hard of 3), Sweeteners: nutritive and non-nutritive (1 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Antioxidants: synthetic and natural (2 easy of 2); Definitions, classification and the INS/E-number system (2 easy of 2).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XE Food Additives & Ingredient Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.